Vibration Controller Design for Confined Masonry Walls by Distributed Genetic Algorithms
Publication: Journal of Structural Engineering
Volume 134, Issue 2
Abstract
Active control of confined masonry walls with nonlinear hysteretic response has been studied through numerical simulation in this paper. The objective has been to reduce the response to below the failure level when the walls have been subjected to earthquakes. An active tendon control mechanism, comprised of prestressed tendons and an actuator, has been used. A nonlinear control algorithm has also been developed based on Wilson’s- instantaneous linear optimal control method and applied. To achieve the best results, weights in the performance index corresponding to displacement, velocity, acceleration, and control force have been optimized by distributed genetic algorithms. An illustrative example has been included where, for designing and testing the controller, a series of white noise ground accelerations of different amplitudes as well as a number of strong earthquakes, such as Chi Chi in 1999 and Northridge in 1994, have been used. Some practical aspects such as actuator-wall interaction, actuator saturation, sensor saturation, and time delay have not been considered in this phase of the study. The designed controllers have been clearly successful in all the tests, even for earthquakes of very high intensity.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The writers would like to thank the Office of the Deputy of Higher Education of Sharif University of Technology, Tehran, Iran for partially supporting this research.
References
Ahlawat, A. S., and Ramaswamy, A. (2002a). “Multi objective optimal design of FLC driven hybrid mass damper for seismically excited structures.” Earthquake Eng. Struct. Dyn., 31, 1459–1479.
Ahlawat, A. S., and Ramaswamy, A. (2002b). “Multi objective optimal design of FLC driven hybrid mass damper for torsionally coupled seismically structures.” Earthquake Eng. Struct. Dyn., 31, 2121–2139.
Ahlawat, A. S., and Ramaswamy, A. (2004a). “Multi objective optimal fuzzy logic controller driven active and hybrid control systems for seismically excited nonlinear buildings.” J. Eng. Mech., 130(4), 416–423.
Ahlawat, A. S., and Ramaswamy, A. (2004b). “Multi objective optimal fuzzy logic control systems for response control of wind-excited tall buildings.” J. Eng. Mech., 130(4), 524–530.
Arfiadi, Y., and Hadi, M. N. S. (2001). “Optimal direct (static) output feedback controller using real coded genetic algorithms.” Comput. Struct., 79, 1625–1634.
Bahar, O., Banan, M. R., Mahzoon, M., and Kitagawa, Y. (2003). “Instantaneous optimal Wilson- control method.” J. Eng. Mech., 129(11), 1268–1276.
Baker, J. E. (1985). “Adaptive selection methods for genetic algorithms.” Proc., ICGA, Vol. 1, 101–111.
Baker, J. E. (1987). “Reducing bias and inefficiency in the selection algorithm.” Proc., ICGA, Vol. 2, 14–21.
Balling, R. J., Briggs, R. R., and Gillman, K. (2006). “Multiple optimum size/shape/topology designs for skeletal structures using a genetic algorithm.” J. Struct. Eng., 132(7), 1158–1165.
Bani-Hani, K. A. (2005). “Vibration control of wind-induced response of tall buildings with an active tuned mass damper using neural networks.” J. Struct. Control Health Monit., 14(1), 83–108.
Bathe, K. J. (1996). Finite element procedures, Prentice-Hall, Upper Saddle River, N.J.
Bhardwaj, M. K., and Datta, T. K. (2006). “Semiactive fuzzy control of the seismic response of building frames.” J. Struct. Eng., 132(5), 791–799.
Chang, C. C., and Yang, H. T. Y. (1994). “Instantaneous optimal control of building frames.” J. Struct. Eng., 120(4), 1307–1326.
Dawe, J. L., Schriver, A. B., and Sofocleous, C. (1989). “Masonry infilled steel frames subjected to dynamic load.” Can. J. Civ. Eng., 16, 877–885.
De Jong, K. A., and Sarma, J. (1993). “Generation gaps revisited.” Foundations of genetic algorithms 2, L. D. Whitley, ed., Morgan Kaufmann, 19–28.
Ghaboussi, J., and Joghataie, A. (1995). “Active control of structures using neural networks.” J. Eng. Mech., 121(4), 555–567.
Goldberg, D. E. (1989). Genetic algorithms in search, optimization and machine Learning, Addison-Wesley, Reading, Mass.
Hadi, N. S., and Arfiadi, Y. (1998). “Optimum design of absorber for MDOF structures.” J. Struct. Eng., 124(11), 1272–1280.
Holland, J. H. (1975). Adaptation in natural and artificial systems, The University of Michigan Press, Ann Arbor, Mich.
Homaifar, A., Qi, C. X., and Lai, S. H. (1994). “Constrained optimization via genetic algorithms.” Simulation, 62(4), 252–254.
Huang, R., and Fogarty, T. C. (1991). “Adaptive classification and control-rule optimization via a learning algorithm for controlling a dynamic system.” Proc., 30th Conf. Decision and Control, Brighton, U.K., 867–868.
Jenkins, W. M. (2002). “A decimal-coded evolutionary algorithm for constrained optimization.” Comput. Struct., 80, 471–480.
Joghataie, A., and Ghaboussi, J. (1994). “Neural networks and fuzzy logic in structural control.” Proc., 1st World Conf. on Struct. Control, Los Angeles, Paper No. PPWPI-21–30.
Joghataie, A., and Vahidi, A. (2000). “Designing a general neuro controller for water towers.” J. Eng. Mech., 126(6), 582–587.
Kirsch, U. (1981). Optimum structural design, McGraw-Hill, New York.
Madan, A., Reinhorn, A. M., Mander, J. B., and Valles, R. E. (1997). “Modeling of masonry infill panels for structural analysis.” J. Struct. Eng., 123(10), 1295–1302.
Michalewicz, Z. (1996). Genetic algorithms data structures=evolution programs, Springer, New York.
Moghaddam, H. A., and Dowling, P. J. (1987). “The state of the art in infill frames.” ESEE Res. Rep. No. 87-2, Civil Engineering Dept, Imperial College, London.
Moroni, M. O., Astroza, M., Gomez, J., and Guzman, R. (1996). “Establishing and factors for confined masonry buildings.” J. Struct. Eng., 122(10), 1208–1215.
Moroni, M. O., Astroza, M., and Tavonatti, S. (1994). “Non-linear models for shear failure in confined masonry walls.” TMS J., 12(2), 72–78.
Mühlenbein, H., and Schlierkamp-Voosen, D. (1993). “Predictive models for the breeder genetic algorithm: I. Continuous parameter optimization.” Evol. Comput., 1(1), 25–49.
Mühlenbein, H., Schomisch, M., and Born, J. (1991). “The parallel genetic algorithms as a function optimizer.” Parallel Comput., 17, 619–632.
Park, H. S., Kwon, Y. H., Seo, J. H., and Woo, B. H. (2006). “Distributed hybrid genetic algorithms for structural optimization on a PC cluster.” J. Struct. Eng., 132(12), 1890–1897.
Rajeev, S., and Krishnamoorthy, C. S. (1997). “Genetic algorithms-based methodologies for design optimization of trusses.” J. Struct. Eng., 123(3), 350–358.
Reinhorn, A. M., Manolis, G. D., and Wen, C. Y. (1987). “Active control of inelastic structures.” J. Eng. Mech., 113(3), 315–333.
Soong, T. T. (1990). Active structural control: Theory and practice, Longman Scientific & Technical, New York.
Starkweather, T., Whitley, D., and Mathias, K. (1990). “Optimization using distributed genetic algorithms.” Springer-Verlag lecture notes in computer science, No. 496, Springer, New York, 176–185.
Tomazevic, M., and Klemenc, I. (1997a). “Seismic behavior of confined masonry wall.” Earthquake Eng. Struct. Dyn., 26, 1059–1071.
Tomazevic, M., and Klemenc, I. (1997b). “Verification of seismic resistance of confined masonry buildings.” Earthquake Eng. Struct. Dyn., 26, 1073–1088.
Wong, K. K. F. (2005). “Predictive optimal linear control of inelastic structures during earthquakes. Part II.” J. Eng. Mech., 131(2), 142–152.
Yang, J. N., Akbarpour, A., and Ghaemmaghami, P. (1987). “New optimal control algorithms for structural control.” J. Eng. Mech., 113(9), 1369–1386.
Yang, J. N., Li, Z., Danielians, A., and Liu, S. C. (1992a). “A seismic hybrid control of nonlinear and hysteretic structures I.” J. Eng. Mech., 118(7), 1423–1440.
Yang, J. N., Li, Z., and Liu, S. C. (1992b). “Stable controllers for instantaneous optimal control.” J. Eng. Mech., 118(8), 1612–1630.
Yang, J. N., Long, F. X., and Wong, D. (1988). “Optimal control of nonlinear structures.” J. Appl. Mech., 55, 931–938.
Information & Authors
Information
Published In
Copyright
© 2008 ASCE.
History
Received: Jul 11, 2006
Accepted: Jun 26, 2007
Published online: Feb 1, 2008
Published in print: Feb 2008
Notes
Note. Associate Editor: Anil Kumar Agrawal
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.