Behavior of RC Beams Subjected to High Rates of Concentrated Loading
Publication: Journal of Structural Engineering
Volume 134, Issue 12
Abstract
The work described in the present article is concerned with the numerical investigation of the dynamic response of reinforced concrete (RC) beams subjected to high rates of transverse loading. Of interest herein is the case of localized impact loading, such as that encountered in the case of contact, impact, and ballistic problems, rather than the case of loads distributed over the entire span of RC structural elements arising particularly from far field explosions. The investigation is based on the use of a commercially available general purpose finite-element (FE) package for nonlinear static and dynamic analysis of three-dimensional FE models. A key feature of our study is the hypothesis that the material properties of concrete and steel reinforcement are independent of the loading rate. Based on this assumption, the effects of the applied loading rate on the exhibited structural response are primarily attributed to the inertia forces that develop within the beam and not to the loading rate sensitivity of the mechanical characteristics of the materials involved. This hypothesis constitutes a major departure from currently accepted design and numerical modeling practices, which adopt exactly the opposite view, thus, providing an alternative explanation as to the causes that affect the complex inelastic response of RC structural elements under high loading rates, as well as the cracking patterns, observed during testing. The results obtained correlate closely with the experimental observation that structural performance, in the form of stiffness, load carrying capacity, and deformability, depart significantly from those recorded under quasi-static loading as certain thresholds of applied loading rates are surpassed, with these changes becoming more pronounced as the rate of loading increases. From the analysis of numerical and experimental predictions, the causes that lead to the above change in behavior are established and a relatively simple design model is proposed, which is able to quantify the observed increase in load-carrying capacity exhibited by RC beams with increasing rates of applied loading as well as the concentration of damage.
Get full access to this article
View all available purchase options and get full access to this article.
References
Abbas, H., Gupta, N. K., and Alam, M. (2004). “Nonlinear response of concrete beams and plates under impact loading.” Int. J. Impact Eng., 30(8–9), 1039–1053.
ANSYS. (2004). Version 9.0, Houston, PA: Swanson Analysis Systems, Inc.
Belytschko, T. (1976). “A survey of numerical methods and computer programs for dynamic structural analysis.” Nucl. Eng. Des., 37(1), 23–24.
Bischoff, P. H., and Perry, S. H. (1995). “Impact behaviour of plain concrete loaded in uniaxial compression.” J. Eng. Mech., 24, 425–450.
Cotsovos, D. M. (2004). “Numerical investigation of structural concrete under dynamic (earthquake and impact) loading.” Ph.D. thesis, Univ. of London, London.
Cotsovos, D. M., and Pavlovic, M. N. (2008a). “Numerical investigation of concrete subjected to compressive impact loading. Part 1: A fundamental explanation for the apparent strength gain at high loading rates.” Comput. Struct., 86(1–2), 145–163.
Cotsovos, D. M., and Pavlovic, M. N. (2008b). “Numerical investigation of concrete subjected to compressive impact loading. Part 2: Parametric investigation of factors affecting behaviour at high loading rates.” Comput. Struct., 86(1–2), 164–180.
Cotsovos, D. M., and Pavlovic, M. N. (2008c). “Numerical investigation of concrete subjected to high rates of uniaxial tensile loading.” Int. J. Impact Eng., 35(5), 319–335.
Du, J., Kobayashi, A. S., and Hawkins, N. M. (1989). “FEM dynamic fracture analysis of concrete beams.” J. Eng. Mech., 115(10), 2136–2149.
Georgin, J. F., and Reynouard, J. M. (2003). “Modeling of structures subjected to impact: Concrete behavior under high strain rate.” Cem. Concr. Compos., 25, 131–143.
Hatzigeorgiou, G., Beskos, D., Theodorakopoulos, D., and Sfakianakis, M. (2001). “A simple concrete damage model for dynamic FEM applications.” Int. J. Comput. Eng. Sci., 2(2), 267–286.
Hughes, G., and Speirs, D. M. (1982). “An investigation on the beam impact problem.” Technical Rep. No. 546, Cement and Concrete Association.
Kishi, N., Mikami, H., and Ando, T. (2001). “An applicability of the FE impact analysis on shear-failure-type RC beams with shear rebars.” Proc., 4th Asia-Pacific Conf. on Shock and Impact Loads on Structures, 309–315, Singapore.
Kishi, N., Mikami, H., Matsuoka, K. G., and Ando, T. (2002). “Impact behaviour of shear—Failure-type RC beams without shear rebar.” Int. J. Impact Eng., 27(9), 955–968.
Kotsovos, M. D., and Pavlović, M. N. (1995). Structural concrete: Finite element analysis and design, Thomas Telford, London.
LS-DYNA. (2007). “Evaluation, of LS-DYNA concrete material model 159.” Publication No. FHWA-HRT-05-063.
Mander, J. B., Priestley, M. J. N., and Park, R. (1983). “Theoretical stress-strain model for confined concrete.” J. Struct. Eng., 114(8), 1804–1826.
Miyamoto, A., King, M. W., and Fujii, M. (1989). “Non-linear dynamic analysis and design concepts for RC beams under impulsive loads.” New Zealand Nat. Soc. Earthquake Eng. Bull, 22(2), 98–111.
Thabet, A., and Haldane, D. (2001). “Three-dimensional numerical simulation of the behaviour of standard concrete test specimens when subjected to impact loading.” Comput. Struct., 79, 21–31.
TM5-855-1. (1998). “Design and analysis of hardened structures to conventional weapons effects.” The Departments of Army, Air Force and Navy and the Defence Special Weapons Agency, Washington, D.C.
Willam, K. J., and Warnke, E. P. (1974). “Constitutive model for the triaxial behaviour of concrete.” Proc., IABSE Seminar on Concrete Structures Subjected to Triaxial Stresses, Vol. 19, 1–30.
Information & Authors
Information
Published In
Journal of Structural Engineering
Volume 134 • Issue 12 • December 2008
Pages: 1839 - 1851
Copyright
© 2008 ASCE.
History
Received: Jun 14, 2006
Accepted: May 7, 2008
Published online: Dec 1, 2008
Published in print: Dec 2008
Notes
Note. Associate Editor: Khalid M. Mosalam
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.