Effect of Reinforcement Type on the Ductility of Suspended Reinforced Concrete Slabs
Publication: Journal of Structural Engineering
Volume 133, Issue 6
Abstract
Reinforced concrete slabs typically have relatively small tensile reinforcement ratios and are generally regarded as very ductile structural elements. This is not the case for slabs reinforced with low-ductility welded wire fabric. Such slabs fail with little warning by fracture of the reinforcement in a brittle and catastrophic manner and, as a consequence, many of the assumptions implicit in structural design are not applicable. Slabs containing low-ductility reinforcement lack robustness and cannot absorb the energy required to resist significant impact or blast loading. This paper outlines the importance of ductility in concrete structures and describes the observed failure mode and ductility of reinforced concrete slabs containing both normal and low-ductility reinforcement. For slabs reinforced with low-ductility welded wire fabric, failure is characterized by relatively little plastic deformation prior to collapse, with small rotational capacities of the critical regions and, consequently, little moment redistribution.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This study was undertaken as part of an ARC Discovery Project (DP0558370). The support of the Australian Research Council is gratefully acknowledged. The writer is also thankful to the laboratory staff at the Heavy Structures Laboratory at The University of New South Wales for their assistance with the laboratory experiments.
References
American Concrete Institute (ACI). (2005). “Building code requirements for structural concrete.” ACI 318–05, ACI Committee 318, Detroit.
Alvarez, M., Koppel, S., and Marti, P. (2000). “Rotation capacity of reinforced concrete slabs.” ACI Struct. J., 97(2), 235–242.
European Committee for Standardization (CEN). (1992). “Design of concrete structures. Part 1-1: General rules for buildings.” DD ENV 1992-1-1, Eurocode 2, Brussels.
Gilbert, R. I. (2001). “The impact of steel reinforcement of the ductility of concrete structures—Revision of AS3600.” Proc., 20th CIA Conf.: Adding Value through Innovation, Concrete Institute of Australia, Perth, 597–603.
Gilbert, R. I., and Smith, S. T. (2006). “Strain localization and its impact on the ductility of reinforced concrete slabs containing reinforcement.” Adv. Struct. Eng., 9(1), 117–127.
Gravina, R. J. (2002). “Nonlinear overload behaviour and ductility of reinforced concrete flexural members containing grade steel reinforcement.” Ph.D. thesis, Dept. of Civil and Environmental Engineering, Univ. of Adelaide, Adelaide, South Australia.
Shakir, A., and Rogowsky, D. M. (2000). “Evaluation of ductility and allowable moment redistribution in reinforced concrete structures.” Can. J. Civ. Eng., 27, 1286–1299.
Smith, S. T., and Gilbert, R. I. (2003). “Tests on RC slabs reinforced with welded wire fabric.” Proc., Concrete in the 3rd Millennium: 21st CIA Conf., Concrete Institute of Australia, Brisbane, 561–570.
Standards Australia. (2001). “Concrete Structures.” BD-002, AS 3600-2001, Standards Australia, Sydney.
Information & Authors
Information
Published In
Copyright
© 2007 ASCE.
History
Received: Jun 28, 2006
Accepted: Nov 30, 2006
Published online: Jun 1, 2007
Published in print: Jun 2007
Notes
Note. Associate Editor: Dat Duthinh
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.