Seismic Design Forces for Rigid Floor Diaphragms in Precast Concrete Building Structures
Publication: Journal of Structural Engineering
Volume 133, Issue 11
Abstract
Floor accelerations are needed to evaluate in-plane diaphragm forces in earthquake resistant design of buildings, and for the design of their connections. Recorded floor accelerations in buildings during some past earthquakes have shown acceleration magnifications that are not properly considered by current building codes. Earthquake damage in some precast buildings seems to point out significant deficiencies in the design of precast diaphragms. Two deficiencies stand out: the magnitude of the design forces and the lack of suitable design methods. This paper describes an experimental validation of a previously proposed analytical-based procedure for the evaluation of earthquake-induced floor horizontal accelerations in regular buildings built with rigid diaphragms. Horizontal floor accelerations recorded from shake table tests of four small-scale structures representing frame and frame-wall multistory reinforced concrete buildings were collected. These buildings were tested on the University of Illinois Urbana-Champaign shaking table during the 1979–1989 period. The horizontal floor accelerations obtained from the tests are compared in this paper with results from four predictive approaches.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The financial support of CONACYT, Contract Nos. UNSPECIFIED1085 PA and NSFNSF-2004-C01-4/A-1, are gratefully acknowledged. Thanks are due to Professor M. Aschheim, from Santa Clara University, formerly at the University of Illinois at Urbana-Champaign, for his assistance in collecting the information and reports from this University needed for this research. Thanks are also due to Mr. R. Sanchez, Ph. D. candidate from the National University of Mexico who helped with several analyses. Three reviewers made useful suggestions that helped to improve the manuscript. Their reviews and time are greatly appreciated.
References
Abrams, D., and Sozen, M. (1979). “Experimental study of frame-wall interaction in reinforced concrete structures subjected to strong earthquake motions.” Structural Research Series No. 460: A Rep. to the National Science Foundation, Univ. of Illinois at Urbana-Champaign, Urbana, Ill.
ASCE/SEI. (2005). Minimum design loads for buildings and other structures, ASCE 7-05, Reston, Va.
Bachman, R. E., and Drake, R. M. (1994). “1994 NEHRP provisions for architectural, mechanical and electrical components.” Proc., 5th US National Conf. on Earthquake Engineering, Vol. IV, Chicago, 765–774.
Blandón, J. J., and Rodriguez, M. E. (2005). “Behavior and design recommendations of connections and floor diagrams in earthquake resisting precast concrete building.” Precast/Prestressed Concrete Instit. J., 50(2), 56–75.
Blandón, J. J., and Rodriguez, M. E. (2007). “Seismic design of rigid floor systems in precast concrete structures.” Rep. of the Instituto de Ingeniería, UNAM, Mexico City, Mexico, to be published.
Carr, A. J. (1998). “RUAUMOKO, Computer Program Library.” Dept. of Civil Engineering, Univ. of Canterbury, Christchurch, New Zealand.
Chaudhuri, R., and Hutchinson, T. (2004). “Distribution of peak horizontal floor accelerations for estimating nonstructural element vulnerability.” Proc., 13th WCEE, Vancouver, Canada, Paper No. 1721.
Chopra, A. (1995). Dynamics of structures: Theory and applications to earthquake engineering, 2nd Ed., Prentice-Hall, Upper Saddle River, N.J.
Drake, R., and Bragagnolo, L. (2000). “Model code design force provisions for elements of structures and nonstructural components.” Earthquake Spectra, 16(1), 115–125.
Eberhard, M., and Sozen, M. (1989). “Experiments and analyses to study the seismic response of reinforced concrete frame-wall structures with yielding columns.” Structural Research Series No. 548, A Rep. to the National Science Foundation, Univ. of Illinois at Urbana-Champaign, Urbana, Ill.
Fleischman, R., and Farrow, K. T. (2002). “Seismic performance of perimeter lateral system structures with highly flexible diaphragms.” Earthquake Spectra, 8(2), 251–286.
Fleischman, R., and Farrow, K. T. (2003). “Seismic design recommendations for precast concrete diaphragms in long floor span construction.” Precast/Prestressed Concrete Instit. J., 48(6), 46–52.
Fleischman, R., Naito, C. J., Restrepo, J. I., Sause, R., and Ghosh, S. K. (2005). “Seismic design methodology for precast concrete diaphragms. Part 1: Design framework.” Precast/Prestressed Concrete Instit. J., 50(5), 68–83.
Fleischman, R., Sause, R., Pessiki, S., and Rhodes, A. (1998). “Seismic behavior of precast parking structure diaphragms.” Precast/Prestressed Concrete Instit. J., 38–53.
Hall, J. (1995). “Northridge Earthquake of January 17, 1994 Reconnaissance Report.” Earthquake Spectra, 1.
International Conference of Building Officials (ICBO). (1997). Uniform building code, Whittier, Calif.
Miranda, E., and Taghavi, S. (2005). “Approximate floor acceleration demands in multistory buildings. I: Formulation.” J. Struct. Eng., 131(2), 203–211.
Restrepo, J. I., and Cowan, H. (2000). “El Eje Cafetero Earthquake, Colombia of January 25 1999.” New Zealand Nat. Soc. Earthquake Eng. Bull, 33(1), 1–29.
Rodriguez, M. E., Restrepo, J. I., and Blandón, J. J. (2006). “Shaking table tests of a four-story miniature steel building-model validation.” Earthquake Spectra, 22(3), 755–780.
Rodriguez, M. E., Restrepo, J. I., and Carr, A. J. (2002). “Earthquake induced horizontal floor accelerations in buildings.” Earthquake Eng. Struct. Dyn., 31, 693–718.
Schroeder, M. E., and Bachman, R. E. (1994). “Analytical studies in support of the NEHRP provisions for nonstructural components.” Proc., 5th US National Conf. on Earthquake Engineering, Chicago, Vol. IV, 755–764.
Schultz, A. (1985). “An experimental and analytical study of the earthquake response of R/C frames with yielding columns.” Ph.D. dissertation, Graduate College Univ. of Illinois at Urbana-Champaign, Urbana, Ill, submitted.
Soong, T. T., Bachman, R. E., and Drake, R. M. (1998). “Implications of the 1994 Northridge Earthquake on design guidelines for nonstructural components.” Proc., NEHRP Conf. and Workshop on the Northridge Earthquake January 17, 1994, California Univ. for Research in Earthquake Engineering, Calif., Vol. III, 441–448.
Villaverde, R. (2000). “Design-oriented approach for seismic nonlinear analysis of nonstructural components.” Proc., 12th WCEE, Auckland, New Zealand, Paper No. 1979.
Information & Authors
Information
Published In
Copyright
© 2007 ASCE.
History
Received: Feb 15, 2006
Accepted: Jan 17, 2007
Published online: Nov 1, 2007
Published in print: Nov 2007
Notes
Note. Associate Editor: Yahya C. Kurama
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.