Active Multiple Tuned Mass Dampers: A New Control Strategy
Publication: Journal of Structural Engineering
Volume 129, Issue 7
Abstract
Active multiple tuned mass dampers (AMTMD) consisting of many active tuned mass dampers (ATMDs) with uniform distribution of natural frequencies have been, for the first time here, proposed to attenuate undesirable oscillations of structures under the ground acceleration. The MTMD in the AMTMD is manufactured by keeping the identical stiffness and damping and varying the mass. In light of the physical principle of the passive MTMD, the active control forces of AMTMD are defined, namely, the control forces are generated through keeping the identical displacement and velocity feedback gain and varying the acceleration feedback gain. Based on the modegeneralized system in the specific vibration mode being controlled (referred to as the main system), the expression for the dynamic magnification factor (DMF) of the structure with AMTMD is formulated. The criterion for the optimum searching can then be defined as the minimization of the minimum values of the maximum DMF (i.e., Min.Min.Max.DMF). With resorting to the criterion, the research is conducted on the parameters reflecting the effectiveness and robustness of AMTMD. The parameters include the frequency spacing, average damping ratio, tuning frequency ratio, total number, total mass ratio, and normalized acceleration feedback gain coefficient. For the sake of comparison, the results of the optimum MTMD (the passive counterpart of AMTMD) and ATMD are also taken into account in the present paper. It is shown that AMTMD can remarkably improve the performance of the MTMD and also has higher effectiveness than ATMD. Additionally, evaluation is performed on the stroke displacement of AMTMD through assessing the maximum DMF of every ATMD in the AMTMD with regard to that of corresponding TMD in the MTMD and ATMD. Numerical results indicate that every ATMD in the AMTMD has different maximum stroke displacement, each of which is larger than that of ATMD, and the maximum stroke displacement of every ATMD in the AMTMD is close to that of corresponding TMD in the MTMD.
Get full access to this article
View all available purchase options and get full access to this article.
References
Abe, M., and Fujino, Y.(1994). “Dynamic characterization of multiple tuned mass dampers and some design formulas.” Earthquake Eng. Struct. Dyn., 23(8), 813–835.
Abe, M., and Igusa, T.(1995). “Tuned mass dampers for structures with closely spaced natural frequencies.” Earthquake Eng. Struct. Dyn., 24(2), 247–261.
Ankireddi, S., and Yang, H. T. Y.(1996). “Simple ATMD control methodology for tall buildings subject to wind loads.” J. Struct. Eng., 122(1), 83–91.
Chang, J. C. H., and Soong, T. T.(1980). “Structural control using active tuned mass damper.” J. Eng. Mech. Div., 106(6), 1091–1098.
Chang, C. C., and Yang, H. T. Y.(1995). “Control of buildings using active tuned mass dampers.” J. Eng. Mech., 121(3), 355–366.
Jangid, R. S.(1995). “Dynamic characteristics of structures with multiple tuned mass dampers.” Struct. Eng. Mech.,3(5), 497–509.
Jangid, R. S.(1999). “Optimum multiple tuned mass dampers for base-excited undamped system.” Earthquake Eng. Struct. Dyn., 28(9), 1041–1049.
Kamiya, K., Kamagata, K., and Seto, K. (1996). “Optimum design method for multi-dynamic vibration absorber.” Proc., 3rd Int. Conf. on Motion and Vibration Control, Vol. 2, Chiba, Japan, 322–327.
Kareem, A., and Kline, S.(1995). “Performance of multiple mass dampers under random loading.” J. Struct. Eng., 121(2), 348–361.
Li, C.(2000). “Performance of multiple tuned mass dampers for attenuating undesirable oscillations of structures under the ground acceleration.” Earthquake Eng. Struct. Dyn., 29(9), 1405–1421.
Xu, K., and Igusa, T.(1992). “Dynamic characteristics of multiple substructures with closely spaced frequencies.” Earthquake Eng. Struct. Dyn., 21(12), 1059–1070.
Yamaguchi, H., and Harnpornchai, N.(1993). “Fundamental characteristics of multiple tuned mass dampers for suppressing harmonically forced oscillations.” Earthquake Eng. Struct. Dyn., 22(1), 51–62.
Yan, N., Wang, C. M., and Balendra, T.(1999). “Optimal damper characteristics of ATMD for buildings under wind loads.” J. Struct. Eng., 125(12), 1376–1383.
Information & Authors
Information
Published In
Copyright
Copyright © 2003 American Society of Civil Engineers.
History
Received: Jun 8, 2001
Accepted: Nov 6, 2002
Published online: Jun 13, 2003
Published in print: Jul 2003
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.