Seismic Behavior of Post-Tensioned Gravity Dams: Shake Table Experiments and Numerical Simulations
Publication: Journal of Structural Engineering
Volume 128, Issue 2
Abstract
Displacement controlled shear tests on small concrete lift joint specimens with different surface roughnesses reinforced with an unbonded post-tension cable are conducted to study a related joint constitutive model, and to determine the failure mechanisms associated to it. To investigate the applicability of the joint model, shake table tests are conducted on a 3.4-m high plain concrete post-tensioned gravity dam that has a cold lift joint about midheight. Numerical simulations using the joint constitutive model are compared with the experimental results. From the displacement controlled shear tests, it is shown that the post-tension cable provides additional strength to the joint by applying an additional normal load on the joint, and by the shear resistance that can be mobilized (cable dowel action). The tests performed on rough surface joints have demonstrated that the dilatancy phenomenon due to asperities increases the post-tension force. Shake table tests on the 3.4-m high dam model have shown that post-tensioning largely reduces residual sliding displacements of the joint. This reduction is a function of the frequency content of the base excitation. However, a single post-tension cable placed near the upstream face increases the upstream rocking response of the upper block, which is also a function of the frequency content of the excitation. Strong seismic excitations can induce cable failure at a lower value than its uniaxial tensile strength when significant shear displacements take place. To describe this brittle failure mechanism, a cable failure criterion that considers the mobilized shear and tensile strengths was proposed and was found to be adequate. Moreover, the post-tensioned joint model proposed showed good agreement with the static and dynamic tests performed to evaluate the joint shear force.
Get full access to this article
View all available purchase options and get full access to this article.
References
ANCOLD, (Australian National Committee on Large Dams). (1992). “Guidelines on strengthening and raising concrete gravity dams.” Sydney, N.S.W., Australia, 66–68.
Arcangeli, E., and Ciabarri, P.(1994). “Menjil dam rehabilitation by resin grouting and high capacity anchors.” Int. Water Power Dam Constr., 46(2), 19–25.
Barton, N. R., and Choubey, V.(1977). “The shear strength of rock joints in theory and practice.” Rock Mech., 10(1–2), 1–54.
Chong, W. H., and Soong, T. T. (2000). “Sliding fragility of unrestrained equipment in critical facilities.” Multidisciplinary Center for Earthquake Engineering Research. Technical Rep. No. MCEER-00-0005, University of Buffalo, Buffalo, N.Y.
Chopra, A. K., and Zhang, L.(1991). “Earthquake-induced base sliding of concrete gravity dams.” J. Struct. Eng. (India), 17(12), 3698–3719.
Cole, R. G., and Horswill, P.(1988). “Alkali-silica reaction: Val de la Mare Dam, Jersey, case history.” Proc. Inst. Civ. Eng., Struct. Build., 84, 1237–1259.
Corns, C. F. (1988). “Dilatation-stressed tendons in post-tensioned anchors.” in Advanced dam engineering for design, construction and rehabilitation, R. B. Jansen, ed., Van Nostrand Reinhold, New York, 595–596.
Dimentberg, M. F., Lin, Y. K., and Zhang, R.(1993). “Toppling of computer-type equipment under base excitation.” J. Eng. Mech., 119(1), 145–160.
Donlon, W. P., and Hall, J. F.(1991). “Shake table study of concrete gravity dam monoliths.” Earthquake Eng. Struct. Dyn., 20, 769–786.
Fronteddu, L., Léger, P., and Tinawi, R.(1998). “Static and dynamic behavior of concrete lift joint interfaces.” J. Struct. Eng. (India), 124(12), 1418–1430.
Goris, J. M., Martin, L. A., and Curtin, R. P.(1996). “Shear behavior of cable bolt supports in horizontal bedded deposit.” CIM Bull., 89(1001), 124–128.
Haas, C. J.(1976). “Shear resistance of rock bolts.” Trans. Soc. Min. Eng. AIME, 260(1), 32–41.
Hall, J. F., Dowling, M. J., and El-Aidi, B.(1992). “Defensive earthquake design of concrete gravity dams.” Dam Eng., 3(4), 249–263.
Léger, P., and Mahyari, A. T.(1994). “Finite element analysis of post-tensioned gravity dams for floods and earthquakes.” Dam Eng., 5(3), 5–27.
Lin, Y. K., Dimentberg, M. F., and Zhang, R.(1994). “Sliding motion ofanchored rigid block under random base excitation.” Probab. Eng. Mech., 9, 33–38.
Lin, G., Zhou, J., and Fan, C.(1993). “Dynamic model rupture test and safety evaluation of concrete gravity dams.” Dam Eng., 4(3), 769–786.
Lorig, L. J.(1985). “A simple numerical representation of fully bonded passive rock reinforcement for hard rocks.” Comput. Geotech., 1, 79–97.
Malla, S., Wieland M., and Peter, M. (1996). “Post-cracking behaviour of piers of a weir of a run-of-river power plant subjected to earthquake loading.” Proc. 11th World Conf. on Earthquake Engineering, June 1996, Acapulco, Mexico.
Mir, R. A., and Taylor, C. A.(1995). “An experimental investigation into earthquake-induced failure of medium to low height concrete gravity dams.” Earthquake Eng. Struct. Dyn., 24, 373–393.
Mir, R. A., and Taylor, C. A.(1996). “An investigation into the base sliding response of rigid concrete gravity dams to dynamic loading.” Earthquake Eng. Struct. Dyn., 25, 79–98.
Pant, B. (1990). “Structural behaviour of concrete and masonry gravity dams.” Central Board of Irrigation and Power, New Delhi, India, Pub. No. 215, 95–106.
Stillborg, B. (1984). “Experimental investigation of steel cables for rock reinforcement in hard rock.” Doctoral thesis, Division of Rock Mechanics, University of Lulea, Sweden.
Tinawi, R., Léger, P., Leclerc, M., and Cippola, G.(2000). “Seismic safety of gravity dams: From shake table experiments to numerical analysis.” J. Struct. Eng. (India), 126(4), 518–529.
UDEC (Universal Distinct Element Code). (1996). User’s Manual, Ver. 3.0. Itasca Consulting Group Inc., Minneapolis.
Xu, H., and Benmokrane, B.(1996). “Strengthening of existing concrete dams using post-tensioned anchors: A state-of-the-art review.” Can. J. Civ. Eng., 23, 1151–1171.
Information & Authors
Information
Published In
Copyright
Copyright © 2002 American Society of Civil Engineers.
History
Received: Jul 10, 2000
Accepted: Jul 27, 2001
Published online: Feb 1, 2002
Published in print: Feb 2002
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.