Strength of Slender Reinforced Concrete Columns under Biaxial Bending
Publication: Journal of Structural Engineering
Volume 127, Issue 7
Abstract
A simple approach is proposed in this paper for estimating the strength of a slender reinforced concrete column under biaxial bending and axial load. The model considers the nonlinear stress-strain relations of concrete and reinforcing steel, and can be used for slender reinforced concrete column with arbitrary cross section. The problem of finding the strength of the slender reinforced concrete column is formulated as a nonlinearly constrained optimization problem. The method is capable of predicting the slender column strength. Its use for design purposes is also outlined. The predicted results obtained from the proposed method compare well with experimental results found in the literature.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Ahmad, S. H., and Weerakoon, S. L. ( 1995). “Model for behavior of slender reinforced concrete columns under biaxial bending.” ACI Struct. J., 92(2), 188–198.
2.
Al-Noury, S. I., and Chen, W. F. (1982). “Finite segment method for biaxial loaded RC columns.”J. Struct. Div., ASCE, 108(4), 780–799.
3.
Anderson, P., and Lee, H. N. ( 1951). “A modified plastic theory of reinforced concrete.” Bull. No. 33, 54(19), University of Minnesota, Minneapolis, Minn.
4.
Bažant, Z. P., Cedolin, L., and Mazen, R. T. ( 1991). “New method of analysis of slender columns.” ACI Struct. J., 88(4), 391–402.
5.
Bresler, B. ( 1960). “Design criteria for reinforced columns under axial load and biaxial bending.” ACI J. Proc., 57, 481–490.
6.
Chuang, P.-H., and Kong, S.-K. (1998). “Strength of slender reinforced concrete columns.”J. Struct. Engrg., ASCE, 124(9), 992–998.
7.
Collins, M. P., Mitchell, D., and MacGregor, J. G. ( 1993). “Structural design considerations for high-strength concrete.” Concrete Int., May, 27–34.
8.
Hsu, C. T. ( 1988). “Analysis and design of square and rectangular columns by equation of failure surface.” ACI Struct. J., 85(2), 167–179.
9.
Kent, D. C., and Park, R. (1971). “Flexural members with confined concrete.”J. Struct. Div., ASCE, 97(7), 1969–1990.
10.
Lloyd, N. A., and Rangan, B. V. ( 1996). “Studies on high-strength concrete columns under eccentric compression.” ACI Struct. J., 93(6), 631–639.
11.
MacGregor, J. G. ( 1997). Reinforced concrete: Mechanics and design, Prentice-Hall, Upper Saddle River, N.J.
12.
Mavichak, V., and Furlong, R. W. ( 1976). “Strength and stiffness of reinforced concrete columns under biaxial bending.” Res. Rep. 7-2F, Ctr. for Hwy. Res., University of Texas at Austin, Tex.
13.
Nilson, A. H. ( 1997). Design of concrete structures, McGraw-Hill, New York.
14.
Ortega, J. M., and Rheinboldt, W. C. ( 1970). Iterative solution of nonlinear equations in several variables, Academic Press, New York.
15.
Pannell, F. N. ( 1963). “Failure surfaces for members in compression and biaxial bending.” ACI J., 60(1), 129–140.
16.
Park, R., and Paulay, T. ( 1975). Reinforced concrete structures, J. Wiley, New York.
17.
Parme, A. L., Nieves, J. M., and Gouwens, A. ( 1966). “Capacity of reinforced rectangular columns subject to biaxial bending.” ACI J., 63(9), 911–923.
18.
Poston, R. W. (1986). “Nonlinear analysis of concrete bridge piers.”J. Struct. Engrg., ASCE, 112(9), 2041–2056.
19.
Ragsdell, K. M. ( 1982). “The evaluation of optimization software for engineering design.” Proc. U.S. Bureau of Standards/Math. Programming Soc. Conf. on Testing and Validating Algorithms and Software, Lecture Notes in Economics and Math. Sys., Vol. 199, Springer, New York, 358–379.
20.
Ramamurthy, L. N. ( 1966). “Investigation of the ultimate strength of square and rectangular columns under biaxially eccentric loads.” Symp. on Reinforced Concrete Columns, ACI Spec. Publ. SP-13, American Concrete Institute, Detroit, 263–298.
21.
Rangan, B. V. ( 1990). “Strength of reinforced concrete slender columns.” ACI Struct. J., 87(1), 32–38.
22.
Reklaitis, G. V., Ravindran, A., and Ragsdell, K. M. ( 1983). Engineering optimization, method and applications, Wiley, New York.
23.
Rodriguez, J. A., and Aristozabal-Ochoa, J. D. (1999). “Biaxial interaction diagrams for short RC columns of any cross section.”J. Struct. Engrg., ASCE, 125(6), 672–683.
24.
Schittkowski, K. ( 1980). “Nonlinear programming codes: Information, tests, performance.” Lecture Notes in Economics and Math. Sys., Vol. 183, Springer, New York.
25.
Schittkowski, K. ( 1985). “NLPQL: A FORTRAN subroutine solving constrained nonlinear programming problems.” Ann. of Oper. Res., 5, 485–500.
26.
Smith, J. C. ( 1973). “Biaxial loaded concrete interaction curve.” Comp. and Struct., 3, 1461–1464.
27.
Thorenfelt, E., Tomaszewicz, A., and Jensen, J. J. ( 1987). “Mechanical properties of high-strength concrete and application in design.” Proc., Symp. Utilization of High Strength Concrete, Tapir, Trondheim, Norway, 149–159.
28.
Wang, P.-T., Naaman, A. E., and Shah, S. P. (1978). “High strength concrete in ultimate strength design.”J. Struct. Div., ASCE, 104(11), 1761–1773.
29.
Wang, G. G., and Hsu, C.-T. (1992). “Complete biaxial load-deformation behavior of RC columns.”J. Struct. Engrg., ASCE, 118(9), 2590–2609.
30.
Yen, J. Y. R. (1991). “Quasi-Newton method for reinforced-concrete column analysis and design.”J. Struct. Engrg., ASCE, 117(3), 657–666.
Information & Authors
Information
Published In
History
Received: Jul 23, 1999
Published online: Jul 1, 2001
Published in print: Jul 2001
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.