Strength and Ductility of Fiber-Reinforced High-Strength Concrete Columns
Publication: Journal of Structural Engineering
Volume 127, Issue 1
Abstract
In this study 21 high-strength, fiber-reinforced columns were tested consisting of 9 155-mm square columns and 12 200-mm square columns. The concrete mix contained 2% (by weight) of end hooked steel fibers and with concrete strengths ranging from 67 to 88 MPa. The columns were tested in either concentric or eccentric compression with varying initial loading eccentricities. The study showed that the introduction of steel fibers into the mix design arrested the early spalling of the cover and increased the load capacity as well as the ductility of the columns over that of comparable nonfiber-reinforced specimens.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
ASTM. ( 1992). “Standard test for flexural toughness and first-crack strength of fibre-reinforced concrete (using beam with third-point loading).” C 1018, West Conshohocken, Pa., 514–520.
2.
Bjerkeli, I., Tomaszewicz, A., and Jensen, J. J. ( 1990). “Deformation properties and ductility of very high strength concrete.” Proc., 2nd Int. Symp., Utilization of High Strength Concrete, American Concrete Institute, Detroit, 215–238.
3.
Canadian Standards Association (CSA). ( 1994). “Design of concrete structures.” CSA-A23.3-94, Rexdale, Ont., Canada.
4.
Cusson, D., and Paultre, P. (1994). “High-strength concrete columns confined by rectangular ties.”J. Struct. Engrg., ASCE, 120(3), 783–804.
5.
Foster, S. J. ( 1998). “Design of HSC columns for strength.” Proc., Int. Conf. on High Perf. High Strength Concrete, Curtin University of Technology, Perth, Western Australia, 409–423.
6.
Foster, S. J. ( 1999a). “The falacy of early cover spalling in HSC columns.” Proc., 5th Int. Symp. on Utilization of High Strength/High Perf. Concrete, 282–291.
7.
Foster, S. J. ( 1999b). “Peak and post peak behaviour of high strength concrete columns.” Proc., Concrete '99: Our Concrete Environment, Concrete Institute of Australia, 500–511.
8.
Foster, S. J., and Attard, M. M. ( 1997). “Experimental tests on eccentrically loaded high strength concrete columns.” ACI Struct. J., 94(3), 2295–2303.
9.
Foster, S. J., Liu, J., and Sheikh, S. A. (1998). “Cover spalling in HSC columns loaded in concentric compression.”J. Struct. Engrg., ASCE, 124(12), 1431–1437.
10.
Martinez, S., Nilson, A. H., and Slate, F. O. ( 1984). “Spirally reinforced high-strength concrete columns.” ACI J., 81(5), 431–442.
11.
Paultre, P., Khayat, K. H., Langlois, A., Trudel, A., and Cusson, D. ( 1996). “Structural performance of some special concretes.” Proc., 4th Int. Symp. on the Utilization of High Perf. Concrete, 787–796.
12.
Razvi, S. R., and Saatcioglu, M. ( 1994). “Strength and deformability of confined high-strength concrete columns.” ACI Struct. J., 91(6), 678–687.
13.
Razvi, S. R., and Saatcioglu, M. ( 1996). “Tests of high strength concrete columns under concentric loading.” Rep. OCEERC 96-03, Dept. of Civ. Engrg., University of Ottawa, Ottawa.
14.
Saatcioglu, M., and Razvi, S. R. ( 1993). “Behaviour of confined high strength concrete columns.” Proc., CPCA/CSCE Struct. Concrete Conf., 37–50.
15.
Sheikh, S. A., and Uzumeri, S. M. (1980). “Strength and ductility of tied concrete columns.”J. Struct. Div., ASCE, 106(5), 1079–1102.
16.
Sheikh, S. A., and Uzumeri, S. M. (1982). “Analytical model for concrete confinement in tied columns.”J. Struct. Div., ASCE, 108(2), 2703–2722.
17.
Sugano, S., Nagashima, T., Kimura, H., Tamura, A., and Ichikawa, A. ( 1990). “Experimental studies on seismic behaviour of reinforced concrete members of high strength concrete.” Proc., 2nd Int. Symp., Utilization of High Strength Concrete, American Concrete Institute, Detroit, 61–87.
18.
Sundararaj, P., and Sheikh, S. A. ( 1992). “High strength concrete columns under eccentric loads.” Res. Rep., Dept. of Civ. Engrg., University of Toronto, Toronto.
19.
Yong, Y. K., Nour, M. G., and Nawy, E. G. (1988). “Behaviour of laterally confined high-strength concrete under axial loads.”J. Struct. Engrg., ASCE, 114(2), 332–351.
Information & Authors
Information
Published In
History
Received: Apr 19, 2000
Published online: Jan 1, 2001
Published in print: Jan 2001
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.