3D Analyses of Buildings under Vertical Component of Earthquakes
Publication: Journal of Structural Engineering
Volume 126, Issue 10
Abstract
This study first investigates how to perform the 3D dynamic analysis of buildings under the vertical component of earthquakes. The analysis results indicate that (1) dividing a main girder into two elements is required to perform the vertical earthquake analysis; (2) including secondary beams for the building analysis is similar to refine modeling of the building (at this time, one building member, such as a secondary beam or a portion of the main girder, modeled by a two-node beam element can also produce an accurate result); (3) neglecting the floor stiffness in the vertical direction is suitable, if the floor thickness is not too thick; and (4) the required vertical effective mass ratio is suggested to be 80%. In the second part of this paper, 1,080 time-history analyses and 180 static analyses of reinforced concrete buildings were performed in order to investigate the relationships of extreme column axial forces and beam moments between vertical earthquake and dead loads. The analysis results indicate that these relationships are linearly proportional to the maximum acceleration obtained from the response-spectrum figure using the first vertical frequency.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Ariaratnam, S. T., and Leung, K. C. K. ( 1990). “Parametric effect of vertical ground acceleration on the earthquake response of elastic structures.” Can. J. Civ. Engrg., Ottawa, 17(2), 209–217.
2.
Bathe, K. J., Wilson, E. L., and Deterson, F. E. ( 1973). “SAPIV: A structural analysis program static and dynamic reponse of linear systems.” EERC Rep. No. 73/11, Earthquake Engrg. Res. Ctr., University of California, Berkeley, Richmond, Calif.
3.
Clough, R., and Felippa, C. ( 1968). “A refined quadrilateral element for the analysis of plate bending.” Proc., 2nd Conf. on Matrix Methods in Struct. Mech., 339–440.
4.
Gupta, R. K., and Hutchinson, G. L. ( 1994). “Horizontal and vertical seismic response of torsionally coupled buildings.” Engrg. Struct., 16(1), 11–24.
5.
Iyengar, R. N., and Shinozuka, M. ( 1972). “Effect of self-weight and vertical acceleration on the behavior of tall structures during earthquake.” Earthquake Engrg. and Struct. Dyn., 1(1), 69–78.
6.
Ju, S. H. (1997). “Investigating contact stresses on articular surfaces by 3D rigid links.”J. Engrg. Mech., ASCE, 123(12), 1253–1259.
7.
Ju, S. H., and Lin, M. C. (1999). “Comparisons of building analyses assuming rigid or flexible floors.”J. Struct. Engrg., ASCE, 125(1), 25–31.
8.
Sadeghvaziri, M. A., and Foutch, D. A. ( 1991). “Dynamic behavior of RC highway bridges under the combined effect of vertical and horizontal earthquake motions.” Earthquake Engrg. and Struct. Dyn., 20(6), 535–549.
9.
Saffarin, H. S., and Qudaimat, M. M. (1992). “In-plane floor deformations in RC structures.”J. Struct. Engrg., ASCE, 118(11), 3089–3102.
Information & Authors
Information
Published In
History
Received: Feb 4, 1999
Published online: Oct 1, 2000
Published in print: Oct 2000
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.