Damage Detection in Structures by Modal Vibration Characterization
Publication: Journal of Structural Engineering
Volume 125, Issue 12
Abstract
A nondestructive methodology is presented for detecting structural damage in structural systems. The procedure is based on using experimentally measured modes and frequencies in conjunction with vibratory residual forces and a weighted sensitivity analysis to estimate the extent of mass and/or stiffness variations in a structural system. Determination of the residual forces and weighted sensitivity analysis involves the use of an analytical model that is correlated to the experimental baseline data from a reference state. This reference state defines the undamaged structural configuration. The method is demonstrated by using a ten-bay space truss as an experimental test bed for various damage scenarios. The experimental results show that the method can accurately predict the location and severity of stiffness change as well as any change in mass for different damage scenarios. The use of an analytical model that is correlated to the baseline test data is shown to improve the prediction; however, reasonable results are also obtained using an uncorrelated analytical model.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Adams, R. D., Crawley, P., Pye, C. J., and Stone, B. J. (1978). “A vibration technique for non-destructively assessing the integrity of structures.” J. Mech. Engrg. Sci., 20, 93–100.
2.
Beck, J., Vanik, M., Polidori, D., and May, B. (1997). “Ambient vibration surveys of a steel frame building in a healthy and damaged state.” Rep. EERL97-03, Earthquake Engrg. Res. Lab., California Institute of Technology, Pasadena, Calif.
3.
Beck, J., Vanik, M., Polidori, D., and May, B. (1998). “Structural health monitoring using ambient variations.” Proc., Struct. Engrs. World Congress, Elsevier, Oxford, U.K., Paper T118-3.
4.
Chen, J. C., and Garba, J. A. (1988). “On-orbit damage assessment for large space structures.” AIAA J., 26(12), 1119–1126.
5.
Chen, T. Y., and Wang, B. P. (1988). “Finite element model refinement using modal analysis data.” Proc., AIAA/ASME/ASCE/AHS 29th Struct., Struct. Dyn., and Mat. Conf., American Institute of Aeronautics and Astronautics, Reston, Va., 1219–1229.
6.
Collins, J. D., Hart, G. C., Hasselman, T. K., and Kennedy, B. (1974). “Statistical identification of structures.” AIAA J., 12(2), 185–190.
7.
Coppolino, R. N., and Rubin, S. (1980). “Detectability of structural failures in offshore platforms by ambient vibration monitoring.” Proc., Offshore Technol. Conf., Society of Petroleum Engineers, Richardson, Tex., 101–110.
8.
Crawley, P., and Adams, R. D. (1979a). “A vibration technique for non-destructive testing of fibre composite structures.” J. Compos. Mat., 13(3), 1161–175.
9.
Crawley, P., and Adams, R. D. (1979b). “The location of defects in structures from measurements of natural frequencies.” J. Strain Analysis, 14(April), 49–57.
10.
Ewins, D. J. (1984). Modal testing: theory and practice. Wiley, New York.
11.
Fox, R. L., and Kapoor, M. P. (1968). “Rates of change of eigenvalues and eigenvectors.” AIAA J., 6(12), 2426–2429.
12.
Hemez, F. M., and Farhat, C. (1995). “Structural damage detection via a finite element model updating methodology.” Modal Analysis, 10(3), 152–166.
13.
Hjelmstad, K. D. (1998). “Damage detection in civil engineering structures.” Proc., Struct. Engrs. World Congress, Elsevier, Oxford, U.K., Paper T118-4.
14.
Kabe, A. K. (1985). “Stiffness matrix adjustment using mode data.” AIAA J., 23(9), 1431–1436.
15.
Kim, H., and Bartkowicz, T. (1993). “Damage detection and health monitoring of large space structures.” Sound and Vibration, 27(6), 12–17.
16.
Kosmatka, J. B., and Ricles, J. M. (1993). “Nondestructive damage determination using vibratory residual forces and weighted sensitivity—analytical and experimental verification studies.” Struct. Sys. Res. Rep. No. 93/09, Dept. of AMES, University of California, San Diego.
17.
Mills-Curan, W. C. (1988). “Calculation of eigenvector derivatives for structures with repeated roots.” AIAA J., 26(1), 867–871.
18.
MSC PAL/2 advanced stress and vibration analysis users manual, version 3.0. (1987). MacNeal-Schwendler Corporation, Los Angeles.
19.
Naeim, F., DiJulio, R., Benuska, K., Reinhorn, A., and Li, C. (1995). “Evaluation of seismic performance of an 11-story moment frame building during the 1994 Northridge earthquake.” Rep. No. 95-04, SAC Joint Venture, California Universities for Research in Earthquake Engineering, Richmond, Calif.
20.
Nelson, R. B. (1976). “Simplified calculation of eigenvector derivatives.” AIAA J., 14(9), 1201–1205.
21.
Park, Y. S., Park, H. S., and Lee, S. S. (1988). “Weighted-error-matrix application to detect stiffness damage by dynamic characteristic measurement.” J. Modal Anal., 6(2), 101–107.
22.
Ricles, J. M., and Kosmatka, J. B. (1992). “Damage detection in elastic structures using vibratory residual forces and weighted sensitivity.” AIAA J., 30(9), 2310–2316.
23.
Smith, S. W., and Hendricks, S. L. (1987). “Evaluation of two identification methods for damage detection in large space trusses.” Proc., 6th VPI&SU/AIAA Symp. on Dyn. and Controls for Large Space Struct., Virginia Polytechnic Institute and State University, Blacksburg, Va., 127–142.
24.
STAR modal analysis users manual, version 3.0. (1991). Structural Measurement Systems, Santa Clara, Calif.
25.
Stubbs, N., Broome, T. H., and Osegueda, R. (1990). “Nondestructive construction error detection in large space structures.” AIAA J., (28)1, 146–152.
26.
Stubbs, N., and Osegueda, R. (1990). “Global non-destructive damage evaluation in solids.” Int. J. Anal. and Experimental Modal Anal., 5(2), 67–79.
27.
Vandiver, J. K. (1975). “Detection of structural failure on fixed platforms by measurement of dynamic response.” Proc., Offshore Technol. Conf., Society of Petroleum Engineers, Richardson, Tex., 243–252.
28.
White, C. W., and Maytum, B. D. (1976). “Eigensolution sensitivity to parametric model perturbations.” Shock and Vibration Bull., 46(5), 123–133.
Information & Authors
Information
Published In
History
Received: Jul 24, 1998
Published online: Dec 1, 1999
Published in print: Dec 1999
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.