Seismic Performance of High-Strength Concrete Columns
Publication: Journal of Structural Engineering
Volume 124, Issue 3
Abstract
This paper presents the experimental results of six scaled high-strength concrete columns with concrete compressive strengths of 76–86 MPa. Primary experimental parameters include axial loads ranging from 10 to 20% of column axial load-carrying capacity based on concrete gross section; longitudinal steel ratios of 2.46 to 3.53% of the gross sectional area; and volumetric ratios of transverse reinforcement ranging from 1.63 to 3.67%. Model columns with transverse reinforcement designed following the seismic provisions of current code developed sufficient ductility, with displacement ductility factors equal to or exceeding 6.0. The model columns designed with 50% of the transverse reinforcement required by current code also developed sufficient ductility when the axial load was 10% of its axial load-carrying capacity. Lateral load-carrying capacities of all the columns exceeded the flexural capacities calculated based on the equivalent concrete stress block used in current design code. Seismic shear strength of high-strength concrete columns was also examined, based on the test results and analytical approaches.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Anderson, J. C., Xiao, Y., and Yin, Z. (1994). “High strength concrete using local materials in Southern California.”Rep. No. USC-SERP94/01, Ctr. for Res. in Earthquake and Constr. Engrg., Dept. of Civ. Engrg., University of Southern California, Los Angeles, Calif.
2.
Azizinamini, A., Kuska, B. S. S., Brungardt, P., and Harfield, E.(1994). “Seismic behavior of square high-strength concrete columns.”ACI Struct. J., 91(10), 336–345.
3.
“Building code requirements for reinforced concrete and commentary.” (1995). Rep. No. ACI 318-95/ACI 418R-95, American Concrete Institute, Committee 318, Farmington Hills, Mich.
4.
Hester, T. W. (ed). (1990). High-strength concrete; SP-121. American Concrete Institute, Detroit, Mich.
5.
Joint ACI-ASCE Committee 441.(1997). “High-strength concrete columns: state of the art.”ACI Struct. J., 94(3), 323–335.
6.
King, D. J., Priestley, M. J. N., and Park, R. (1986). “Computer program for concrete column design.”Res. Rep. No. 86/12, Dept. of Civ. Engrg., Univ. of Canterbury, Christchurch, New Zealand.
7.
Li, B. (1994). “Strength and ductility of reinforced concrete and frames constructed using high-strength concrete,” PhD thesis, Univ. of Canterbury, Christchurch, New Zealand.
8.
Malhotra, V. M. (ed). (1994). High-performance concrete; SP-149. American Concrete Institute, Farmington Hills, Mich.
9.
Priestley, M. J. N., Verma, R., and Xiao, Y.(1994). “Seismic shear strength of reinforced concrete columns.”J. Struct. Engrg., ASCE, 120(7), 2310–2329.
10.
Priestley, M. J. N., Seible, F., Xiao, Y., and Verma, R.(1994). “Steel jacket retrofit of squat RC bridge columns for enhanced shear strength-part 1: theoretical considerations and test design.”ACI Struct. J., 91(4), 394–405.
11.
Priestley, M. J. N., Ranzo, G., Benzoni, G., and Kowalsky, M. J. (1996). “Yield displacement of circular bridge columns.” Proc., Fourth Caltrans Seismic Res. Workshop, California Dept. of Transp., Sacramento, Calif.
12.
Shah, S. P., and Ahmad, S. H. (eds). (1993). High performance concrete: properties and applications. McGraw-Hill Inc., New York, N.Y.
13.
Sheikh, S. A., Shah, D. V., and Khoury, S. S. (1994). “Confinement of high-strength concrete columns.”ACI Struct. J., 91(1), 100– 111.
14.
Thomsen, J. H., and Wallace, J. W.(1994). “Lateral load behavior of reinforced concrete columns constructed using high-strength materials.”ACI Struct. J., 91(16), 605–615.
15.
Xiao, Y., Tomii, M., and Sakino, K.(1986). “Experimental study on design method to prevent shear failure of reinforced concrete short circular columns by confining in steel tube.”Trans. Japan Concrete Inst., 8, 535–542.
16.
Xiao, Y., Priestley, M. J. N., and Seible, F. (1994). “Development of a full-scale testing system for dynamic evaluation of seismic base isolators.”Proc., First World Conf. on Struct. Control, University of Southern California, Los Angeles, Calif., 11–17.
Information & Authors
Information
Published In
Copyright
Copyright © 1998 American Society of Civil Engineers.
History
Published online: Mar 1, 1998
Published in print: Mar 1998
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.