Toward A Unified Nomenclature for Reinforced-Concrete Theory
Publication: Journal of Structural Engineering
Volume 122, Issue 3
Abstract
Research in the fundamental behavior of reinforced concrete has progressed greatly since the 1960s, particularly in the areas of shear and torsion. This large body of knowledge spawned many theories and created many terms that do not adhere to a centralized nomenclature—a very confusing situation for the engineering profession. This paper proposes a unified nomenclature that covers all four basic actions (bending, axial load, shear, and torsion) and is based on the angle of inclination of the concrete struts, the scope of applications, and the three fundamental principles of the mechanics of materials (stress equilibrium, strain compatibility, and the constitutive laws of materials). Six models are presented: strut-and-tie model, Bernoulli compatibility truss model, equilibrium (plasticity) truss model, Mohr compatibility truss model, softened truss model, and fixed-angle softened-truss model. This paper shows that all rational reinforced-concrete theories developed to date can be covered by these six models.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Belarbi, A., and Hsu, T. T. C.(1994). “Constitutive laws of concrete in tension and reinforcing bars stiffened by concrete.”Struct. J. Am. Concrete Inst., 91(4), 465–474.
2.
Belarbi, A., and Hsu, T. T. C.(1995). “Constitutive laws of softened concrete in biaxial tension-compression.”Struct. J. Am. Concrete Inst., 92(5), 562–573.
3.
Collins, M. P. (1973). “Torque-twist characteristics of reinforced concrete beams.”Inelasticity and non-linearity in structural concrete. Study No. 8, University of Waterloo Press, 211–231.
4.
Collins, M. P., and Mitchell, D.(1980). “Shear and torsion design of prestressed and non-prestressed concrete beams.”J. Prestressed Concrete Inst., 25(5), 32–100.
5.
Collins, M. P., and Mitchell, D. (1991). Prestressed concrete structures, Prentice-Hall Inc., Englewood Cliffs, N.J., Sect. 7.10 and 7.11, 343–359.
6.
Dei Poli, S., Gambarova, P. G., and Karakoç, C.(1987). “Aggregate interlock role in R.C. thin-webbed beams in shear.”Journal of Structural Engineering, ASCE, 113(1), 1–19.
7.
Elfgren, L. (1972). “Reinforced concrete beams loaded in combined torsion, bending and shear.”Publication 71:3, Division of Concrete Structures, Chalmers University of Technology, Göteborg, Sweden.
8.
Hsu, T. T. C. (1984). Torsion of reinforced concrete, Van Nostrand Reinhold Co. Inc., New York, N.Y.
9.
Hsu, T. T. C.(1988). “Softening truss model theory for shear and torsion.”Struct. J. Am. Concrete Inst., 85(6), 624–635.
10.
Hsu, T. T. C.(1991a). “Nonlinear analysis of concrete membrane elements.”Struct. J. Am. Concrete Inst., 88(5), 552–561.
11.
Hsu, T. T. C.(1991b). “Nonlinear analysis of concrete torsional members.”Struct. J. Am. Concrete Inst., 88(6), 674–682.
12.
Hsu, T. T. C. (1993). Unified theory of reinforced concrete . CRC Press, Inc., Boca Raton, Fla.
13.
Hsu, T. T. C., and Mo, Y. L.(1985). “Softening of concrete in torsional members—theory and tests.”J. Am. Concrete Inst., 82(3), 290–303.
14.
Hsu, T. T. C., and Mo., Y. L.(1986). “Discussion of `Prestressed concrete tests compared with torsion theories,' by A. E. McMullen and W. M. El-Degwy.”J. Prestressed Concrete, 31(5), 160–164.
15.
Hsu, T. T. C., and Zhang, L. X. (1996). “Tension stiffening in reinforced concrete membrane elements.”Struct. J. Am. Concrete Inst., 93(1).
16.
Kupfer, H., and Bulicek, H. (1992). “A consistent model for the design of shear reinforcement in slender beams with I- or box-shaped cross section.”Concrete shear in earthquake, Proc. Int. Workshop on Concrete Shear in Earthquake, Elsevier Science Publishers, Inc., New York, N.Y., 256–265.
17.
Lampert, P., and Thurlimann, B. (1968). “Torsion tests of reinforced concrete beams (Torsionsversuche an Stahlbetonbalken),”Bericht No. 6506-2, Institute fur Baustatik, ETH, Zurich, Switzerland (in German).
18.
Leonhardt, F. (1977). “Schub bei Stahlbeton und Spannbeton-Grundlagen der neueren Schubbemessung.”Beton- und Stahlbetonbau, Berlin, Germany, 11 and 12, 270–277, 295–302 (in German).
19.
McMullen, A. E., and El-Degwy, W. M.(1985). “Prestressed concrete tests compared with torsion theories.”J. Prestressed Concrete Inst., 30(5), 96–127.
20.
Morsch, E. (1902). “Der eisenbetonbau, seine anwendung und theorie,” 1st ed., Wayss and Freytag, A. G., Im Selbstverlag der Firma, Neustadt a.d. Haardt, Germany (in German).
21.
Nielsen, M. P. (1967). “Om forskydningsarmering i jernbetonbjaelker (On Shear Reinforcement in Reinforced Concrete Beams).”Bygningsstatiske Meddelelser, Copenhagan, Denmark, 38(2), 33–58 (in Danish).
22.
Pang, X. B., and Hsu, T. T. C. (1992). “Constitutive laws of reinforced concrete in shear.”Res. Rep. UHCEE 92-1, Dept. of Civ. and Envir. Engrg., Univ. of Houston, Tex.
23.
Pang, X. B., and Hsu, T. T. C.(1995). “Behavior of reinforced concrete membrane elements in shear.”Struct. J. Am. Concrete Inst., 92(6), 665–679.
24.
Pang, X. B., and Hsu, T. T. C. (1996). “Fixed-angle softened-truss model for reinforced concrete.”Struct. J. Am. Concrete Inst., 93(2).
25.
Ritter, W. (1899). “Die bauweise hennebique.”Schweizerishe Bauzeitung, Zurich, Switzerland (in German).
26.
Robinson, J. R., and Demorieux, J. M. (1968). “Essais de traction-compression sur modèles d'âme de poutre en béton armé.”IRABA Rep., Institut de Recherches Appliquées du Béton de l'Ame, Paris, France.
27.
Robinson, J. R., and Demorieux, J. M. (1972). “Resistance ultimate du béton de l'âme de poutres en double te en Béton Armé,”IRABA Report, Institut de Recherches Appliquées du Béton de l'Ame, Paris, France.
28.
Vecchio, F., and Collins, M. P. (1981). “Stress-strain characteristics of reinforced concrete in pure shear.”Final Rep., IABSE Colloquium on Advanced Mechanics of Reinforced Concrete, Delft, Netherland, 211–225.
29.
Vecchio, F. J., and Collins, M. P.(1986). “The modified compression field theory for reinforced concrete elements subjected to shear.”J. Am. Concrete Inst., 83(2), 219–231.
30.
Wagner, H. (1931). “Flat sheet metal girder with very thin metal web.”Tech. Memos 604, 605, 606, NACA, Washington, D.C.
31.
Zhang, L. X. (1995). “Constitutive laws of reinforced membrane elements with high strength concrete,” PhD dissertation, Dept. of Civ. and Envir. Engr., Univ. of Houston, Tex.
Information & Authors
Information
Published In
Journal of Structural Engineering
Volume 122 • Issue 3 • March 1996
Pages: 275 - 283
Copyright
Copyright © 1996 American Society of Civil Engineers.
History
Published online: Mar 1, 1996
Published in print: Mar 1996
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.