Design of Prestressed Concrete Beams with Openings
Publication: Journal of Structural Engineering
Volume 121, Issue 5
Abstract
Web openings in beams occur quite often in practice to provide convenient passage of environmental services. As a result, story heights in buildings can be reduced resulting in major cost savings. In this paper the nonlinear analysis and design of simply supported posttensioned prestressed concrete beams with rectangular openings are presented. Several design parameters are varied such as: opening width and depth, horizontal and vertical locations of the opening, and type of cross section. The results from a nonlinear finite-element analysis are substantiated by test results from 13 unbonded posttensioned prestressed concrete beams, six of which are rectangular in section, five are T-section, and the remaining two are I-section. Good agreement is shown between the theoretical and the experimental results. The effect of the openings on the behavior of such beams at different stages of loading is presented. A simple design method for estimating the ultimate failure load for each type of failure mode is proposed. An illustrative design example is presented.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Abdalla, H. A. (1993). “Static and dynamic responses of prestressed concrete beams with openings,” PhD thesis, Univ. of Windsor, Ontario, Canada.
2.
Barney, G. B., Corley, W. G., Hanson, J. M., and Parmelee, R. A. (1977). “Behaviour and design of prestressed concrete beams with large web openings.”J. Prestressed Concrete Inst. 22(6), 32–61.
3.
“Building code requirements of reinforced concrete.” (1989). ACI 318-89 American Concrete Institute, Detroit.
4.
Dinakaran, V., and Sastry, M. K.(1984). “Behaviour of post-tensioned prestressed concrete T-beams with large web openings.”Indian Concrete J., Bombay, India, 58(2), 34–38.
5.
Hanson, J. M. (1969). “Square openings in webs of continuous joists.”RD001.01D, Portland Cement Association, Skokie, Ill.
6.
Hibbitt, H. D., Karlsson, B. I., and Sorensen, E. P. (1989). ABAQUS version 4-8, finite element program, Hibbitt, Karlsson & Sorensen, Inc., Providence, R. I.
7.
Kennedy, J. B., and Abdalla, H. A.(1992). “Static response of prestressed girders with openings.”J. Struct. Engrg., ASCE, 118(2), 488–504.
8.
Mansur, M. A.(1988). “Ultimate strength design of beams with large openings.”Int. J. Struct., 8(2), 107–125.
9.
Mansur, M. A., Tan, K. H., Lee, Y. F., and Lee, S. L.(1991). “Piecewise linear behaviour of RC beams with openings.”J. Struct. Engrg., ASCE, 117(6), 1607–1621.
10.
Regan, H. S., and Warwaruk, J. (1967). “Tee-members with large web openings.”J. Prestressed Concrete Inst. 12(4), 52–65.
11.
Sauve, J. S. (1970). “Prestressed concrete tee-beams with large web openings,” Master's thesis, Univ. of Alberta, Edmonton, Canada.
12.
Whitney, C. S.(1940). “Plastic theory of reinforced concrete design.”Proc., ASCE, ASCE, 66(10), 1749–1780.
Information & Authors
Information
Published In
Copyright
Copyright © 1995 American Society of Civil Engineers.
History
Published online: May 1, 1995
Published in print: May 1995
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.