Experimental Study of Friction‐Pendulum Isolation System
Publication: Journal of Structural Engineering
Volume 117, Issue 4
Abstract
A shake‐table study of the friction‐pendulum isolation system, installed in a six‐story, quarter‐scale, 52‐kip model structure, is presented. Two bearing materials are studied, one with a peak friction coefficient of 0.075 and another of 0.095. In both cases, the isolation system has a rigid‐body mode period of 1 sec. The isolated structure is found to be capable of withstanding strong earthquake forces of different frequency content. In tests with the El Centra motion, the isolated structure sustains, without any damage, a peak ground acceleration six times greater than what it could under fixed‐based conditions. It is found that the bearing displacements are low and that the permanent bearing displacements at the end of free vibration are very small, in general, not exceeding 6% of the bearing design displacement. The system is shown to have quantifiable properties, and analytical techniques are presented that provide accurate prediction of the response.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Buckle, I. (1986). “Development and application of base isolation and passive energy dissipation: A world overview.” Proc. of ATC‐17 Seminar on Base Isolation and Passive Energy Dissipation, Applied Technology Council, Palo Alto, Calif., 153—174.
2.
Clough, R. W., and Penzien, J. (1975). Dynamics of structures. McGraw‐Hill, Inc., New York, N.Y.
3.
Constantinou, M. C., Mokha, A., and Reinhorn, A. M. (1990). “Teflon bearings in base isolation II: Modeling.” J. Struct. Engrg., ASCE, 116(2), 455–474.
4.
Den Hartog, J. P. (1931). “Forced vibration with combined Coulomb and viscous friction.” Trans. of ASME, 53 APM‐53‐9, 107–115.
5.
Gear, C. W. (1971). “The automatic integration of ordinary differential equations.” Numer. Math., Commun. of ACM, 14(3), 176–190.
6.
Griffith, M. C., Aiken, T. D., and Kelly, J. M. (1988). “Experimental evaluation of seismic isolation of a 9‐story braced steel frame subject to uplift.” Report No. UCB/EERC‐88/05, Earthquake Engineering Reserach Center, Univ. of California, Berkeley, Calif.
7.
Kelly, J. M. (1988). “Base isolation in Japan, 1988.” Report No. UCB/EERC‐88/20, Earthquake Engineering Research Center, Univ. of California, Berkeley, Calif.
8.
Makris, N. (1989). “Analysis of motion of harmonically excited sliding isolation systems,” thesis presented to the State University of New York, at Buffalo, N.Y., in partial fulfillment of the requirements for the degree of Master of Science.
9.
Mokha, A., Constantinou, M. C., and Reinhorn, A. M. (1988). “Teflon bearings in aseismic base isolation. Experimental studies and mathematical modeling.” Report No. NCEER‐88‐0038, National Center for Earthquake Engineering Research, State Univ. of New York, Buffalo, N.Y.
10.
Mokha, A., Constantinou, M. C., and Reinhorn, A. M. (1990a). “Teflon bearings in base isolation I: Testing.” J. Struct. Engrg., ASCE, 116(2), 438–454.
11.
Mokha, A., Constantinou, M. C., and Reinhorn, A. M. (1990b). “Experimental study and analytical prediction of earthquake response of a sliding isolation system with a spherical surface.” Report No. NCEER‐90/0020, National Center for Earthquake Engineering Research, State Univ. of New York, Buffalo, N.Y.
12.
Mostaghel, N., and Khodaverdian, M. (1987). “Dynamics of resilient friction base isolator (R‐FBI).” Earthquake Engrg. Struct. Dyn., 15(3), 379–390.
13.
Reinhorn, A. M., Soong, T. T., Lin, R. C., Wang, Y. P., Fukao, Y., Abe, H., and Nakai, M. (1989). “1:4 scale model studies of active tendons systems and active mass dampers for aseismic protection.” Report No. NCEER‐890026, National Center for Earthquake Engineering Research, State Univ. of New York, Buffalo, N.Y.
14.
Su, L., Ahmadi, G., and Tadjbakhsh, I. (1989). “A comparative study of performance of various base isolation systems, part I: Shear beam structures.” Earthquake Engrg. and Struct. Dyn., 18(1), 11–32.
15.
Zayas, V., Low, S. S., and Mahin, S. A. (1987). “The FPS earthquake resisting system, experimental report.” Report No. UCB/EERC‐87/01, Earthquake Engineering Research Center, Univ. of California, Berkeley, Calif., June.
Information & Authors
Information
Published In
Copyright
Copyright © 1991 ASCE.
History
Published online: Apr 1, 1991
Published in print: Apr 1991
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.