Localized Identification of Constructed Facilities
Publication: Journal of Structural Engineering
Volume 117, Issue 1
Abstract
A general constructed facility identification methodology that permits synthesis of localized flexibility coefficients is presented. An application of it to a region of an in‐situ concrete bridge is also described. Rigorous analytical investigation and modeling is undertaken first; dynamic testing using low stress level and easily induced impact excitation are executed next. Modal parameters except for damping ratios are identified, then the mass matrix is estimated, and then the flexibility matrix is derived. Model parameters are altered rationally; and a very good match between experimental and model flexibilities is attained. This is accomplished despite the existence of several closely spaced modes and the use of a simple identification algorithm. A static test is conducted to validate the dynamic test‐based identification. A very strong agreement is shown between static and dynamic test results. Analytical modeling, field testing, and data reduction are found to be highly interrelated tasks. Remarks on needed further research in each of these areas is presented.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Ahmadi, K. A., and Torkamani, M. A. M. (1986). “Application of system identification in mathematical modeling of buildings.” Res. Report SETEC‐CE‐86‐002, Univ. of Pittsburgh, Pittsburgh, Pa.
2.
Aktan, A. E., Bertero, V. V., Chowdhury, A. A., and Nagashima, T. (1983). “Experimental and analytical predictions of the mechanical characteristics of a 1/5‐scale model of a 7‐story RC frame‐wall building structure.” Report No. UCB/EERC‐83/13, Earthquake Engrg. Res. Ctr., Univ. of California, Berkeley, Calif.
3.
Aktan, A. E., Hogue, T. D., and Hoyos, A. (1987). “Identification of civil‐engineered structures.” Proc., 1987 SEM Spring Conf. on Experimental Mech., Society for Experimental Mechanics, 385–400.
4.
Aktan, A. E., and Nelson, G. E. (1988). “Problems in predicting seismic responses of RC buildings.” J. Struct. Engrg., ASCE, 114(9), 2036–2056.
5.
Aktan, A. E. (1988a). “Seismic vulnerability evaluation and upgrading of RC buildings.” Proc., 2nd Japan‐U.S. Workshop on Urban Earthquake Hazards Reduction, Earthquake Engineering Research Institute, Shimizu, Japan.
6.
Aktan, A. E. (1988b). “Present and future in RC building analysis.” Proc. 9th World Conf. in Earthquake Engrg., Tokyo, Japan.
7.
Beck, J. L. (1978). “Determining models of structures from earthquake records.” Report No. EERL 78‐01, California Institute of Technology, Pasadena, Calif.
8.
Beliveau, J.‐G. (1988). “Structural system identification from modal information.” Structural safety evaluation based on system identification approaches, H. G. Natke and J. T. P. Yao, eds., Vieweg, Wiesbaden, Germany, 69–81.
9.
Bertero, V. V., Aktan, A. E., Charney, F., and Sause, R. (1985). “Earthquake simulator tests and associated experimental, analytical and correlation studies of one‐fifth scale model.” Earthquake effects on reinforced concrete structures, ACl, SP‐84, American Concrete Institute, Detroit, Mich.
10.
Bertero, V. V., and Clough, R. W. (1986). “Interdependence of dynamic analysis and experiment.” Dynamic response of structures, Gary C. Hart and Richard B. Nelson, eds., ASCE, New York, N.Y., 1–27.
11.
Chen, J.‐Ch., and Garba, J. A. (1988). “Structural damage assessment using a system identification technique.” Structural safety evaluation based on system identification approaches, H. G. Natke and J. T. P. Yao, eds., Vieweg, Wiesbaden, Germany, 474–493.
12.
Clough, R. W., and Penzien, J. (1975). Dynamics of structures, McGraw‐Hill, New York, N.Y.
13.
Clough, R. W., and Bertero, V. V. (1977). “Laboratory model testing for earthquake loading.” J. Engrg. Mech., ASCE, 103(6), 1105–1124.
14.
Douglas, B. M., and Reid, W. H. (1982). “Dynamic tests and system identification of bridges.” J. Struct. Div., ASCE, 108(10), 2295–2312.
15.
Flesch, R. G., and Kernbichler, K. (1988). “Bridge inspection by dynamic tests and calculations dynamic investigations of Lavant Bridge.” Structural safety evaluation based on system identification approaches. H. G. Natke and J. T. P. Yao, eds., Vieweg, Weisbaden, Germany, 433–459.
16.
Foutch, D. A. (1977). “A study of the vibrational characteristics of two multistory buildings,” thesis presented to the California Institute of Technology, at Pasadena, Calif., in partial fulfillment of the requirements for the degree of Doctor of Philosophy.
17.
Hart, G. C., and Yao, J. T. P. (1977). “System identification in structural dynamics.” J. Engrg. Mech. Div., ASCE, 103(6), 1089–1104.
18.
Heylen, W. (1982). “Optimization of model matrices by means of experimentally obtained dynamic data.” Proc. 1st Int. Modal Analysis Conf., Union College, Schenectady, New York, 32–38.
19.
Hogue, T. D. (1987). “Concept and application of frequency domain analysis in structural dynamics,” thesis presented to Louisiana State University, at Baton Rouge, La., in partial fulfillment of the requirements for the degree of Master of Science.
20.
Hogue, T. D. (1988). “Regional identification of a concrete bridge using impact‐induced free vibration response,” thesis presented to Louisiana State University, at Baton Rouge, La., in partial fulfillment of the requirements for the degree of Doctor of Philosophy.
21.
Hoyos, A. (1987). “Identification of civil‐engineered substructures by local impact testing,” thesis presented to the Louisiana State University, at Baton Rouge, La., in partial fulfillment of the requirements for the degree of Master of Science.
22.
Hudson, D. E. (1977). “Dynamic tests of full‐scale structures.” J. Engrg. Mech. Div., ASCE, 103(6), 1141–1157.
23.
Ibanez, P. (1972). “Identification of dynamic structural models from experimental data.” Univ. of Calif. at Los Angeles Engrg. Report, UCLA‐ENG‐7725, Univ. of California at Los Angeles, Los Angeles, Calif.
24.
Ibanez, P., and Blakely, K. D. (1983). “Structural identification—pros and cons.” Recent advances in engineering mechanics and their impact on civil engineering practice, ASCE, New York, N.Y., 303–306.
25.
Jayakumar, P., and Beck, J. L. (1988). “System identification using nonlinear structural models.” Structural safety evaluation based on system identification approaches, H. G. Natke and J. T. P. Yao, eds., Vieweg, Wiesbaden, Germany, 82–102.
26.
Juang, J.‐N., and Pappa, R. S. (1987). “A comparative overview of modal testing and system identification for control of structures.” Proc., 1987 SEM Spring Conf. on Experimental Mech., Soc. for Experimental Mech., 250–259.
27.
Kostem, C. N., Fisher, J. W., Reese, R. T., and Kealey, T. R. (1981). “Vibration of a steel truss highway bridge.” Dynamic response of structures‐experimentation, observation, prediction, and control, Gary Hart, ed., ASCE, New York, N.Y., 61–71.
28.
Liu, S.‐C., and Yao, J. T. P. (1978). “Structural identification concept.” J. Struct. Div., ASCE, 104(12), 1845–1858.
29.
Miller, R. K., and Heidari, M. A. (1986). “Approximate analysis of earthquake response of impacting structures.” 1986 ASCE Structures Congress, New Orleans, La.
30.
Natke, H. G., and Yao, J. T. P. (1988a). “System identification approaches in structural safety evaluation.” Structural safety evaluation based on system identification approaches, H. G. Natke and J. T. P. Yao, eds., Vieweg, Wiesbaden, Germany, 460–473.
31.
Natke, H. G., and Yao, J. T. P. (1988b). “Concluding remarks and recommendations.” Structural safety evaluation based on system identification approaches. H. G. Natke and J. T. P. Yao, eds., Vieweg, Wiesbaden, Germany, 498–502.
32.
Neuss, C. F., Maison, B. F., and Bouwkamp, J. G. (1983). “A study of computer modeling formulation and special analytical procedures for earthquake response of multistory buildings.” A Report to the National Science Foundation, J. G. Bouwkamp, Inc., Berkeley, Calif.
33.
Rubin, S., and Coppolino, R. (1983). Flexibility monitoring evaluation study. Minerals Management Service, U.S. Dept. of the Interior, Washington, D.C.
34.
Sage, A. P. (1972). “System identification—history, methodology, future prospects.” System identification of vibrating structures‐mathematical models from test data, W. D. Pilkey and R. Cohen, eds., Amer. Soc. of Mech. Engrs. (ASME), New York, N.Y., 1–22.
35.
Stephen, R., Wilson, E., and Stander, N. (1985). “Dynamic properties of a thirty‐story condominium tower building.” UCB/EERC Report‐85/03, Univ. of California, Berkeley, Calif.
36.
Structural safety evaluation based on system identification approaches. (1988). H. G. Natke and J. T. P. Yao, eds., Vieweg, Wiesbaden, Germany.
37.
Wilson, E., and Habibullah, A. (1986). SAP‐80 structural analysis programs: Users guide. Computers and Structures, Inc., Berkeley, Calif.
Information & Authors
Information
Published In
Copyright
Copyright © 1991 ASCE.
History
Published online: Jan 1, 1991
Published in print: Jan 1991
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.