Wind Pressures on Buildings with Mullions
Publication: Journal of Structural Engineering
Volume 116, Issue 8
Abstract
Wind pressures on buildings may be affected by various appurtenances such as mullions or vertical ribs. The determination of the influence of these appurtenances on the wind loads on cladding and structural elements of a building is important in order to identify any modifications necessary for the provisions of wind codes of practice and design standards, and also to investigate the possibility of simplification of wind tunnel building models in the event that the simulation of appurtenances appears to be insignificant to the measured wind pressures. The paper describes an experimental study carried out in the boundary‐layer wind tunnel of the Centre for Building Studies under simulated wind‐conditions over an open country and an urban terrain. The basic model of the study represents a 60.8 m by 60.8 m square building tested at two different heights (15 m and 120 m) with one‐meter and two‐meter deep mullions attached on one wall. The experimental results indicate that, in the presence of mullions, the wind‐induced suctions increase drastically at the wall edge area for almost all geometrical and exposure configurations. Trends are similar for both mean and fluctuating wind‐induced pressures. The paper quantifies these trends and makes appropriate recommendations.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Hoerner, S. G. (1957). Fluid dynamic drag. New York, N.Y., 4.4.
2.
Leadon, B. M., and Kownacki, M. L. (1979). “Pressures on curtain wall with external mullions.” J. Engrg. Mech. Div., ASCE, 105(4), 515–523.
3.
Leutheusser, H. J. (1970). “Influence of architectural features on the static wind loading of buildings.” Proc., Technical Meeting Concerning Wind Loads on Buildings and Structures, Building Science Series No. 30, National Bureau of Standards, 73–86.
4.
“Minimum design loads for buildings and other structure.” (1982). ANSI A58.1, Amer. Nat. Standards Inst., New York, N.Y.
5.
“National building code of Canada.” (NBCC). (1985). NRCC No. 23174, Associate Committee on the National Building Code, Nat. Res. Council of Canada, Ottawa, Canada.
6.
Roshko, A. (1970). “On the aerodynamic drag of cylinders at high Reynolds numbers.” Proc., Sem. on Wind Loads on Structures, Univ. of Hawaii, Honolulu, Hawaii, 87–96.
7.
Standen, N. M., Dalgliesh, W. A., and Templin, R. J. (1971). “A wind tunnel and full‐scale study of turbulent wind pressures on a tall building.” Proc., Third Int. Conf. on Wind Effects on Buildings and Structures, Tokyo, Japan, 2.31–11.
8.
Stathopoulos, T. (1984). “Design and fabrication of a wind tunnel for building aerodynamics.” J. Wind Engrg. Indust. Aerodyn., 16(2–3), 361–376.
9.
Templin, J. T., and Cermak, J. E. (1976). “Wind pressures on buildings: Effect of mullions.” Technical Report CER7677‐JTTJEC24, Fluid Dynamics and Diffusion Lab., Colorado State Univ., Ft. Collins, Colo.
10.
Zhu, X. (1987). “Wind pressures on buildings with appurtenances,” thesis presented to Concordia University, at Montreal, Canada, in partial fulfillment of the requirements for the degree of Master of Engineering (Building).
Information & Authors
Information
Published In
Copyright
Copyright © 1990 ASCE.
History
Published online: Aug 1, 1990
Published in print: Aug 1990
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.