Inelastic Behavior of Concrete Masonry Shear Walls
Publication: Journal of Structural Engineering
Volume 115, Issue 9
Abstract
The seismic resistance of story‐height reinforced masonry shear walls has been evaluated experimentally to examine the influence of the applied axial stress and the amount of vertical and horizontal reinforcement on the lateral resistance, failure mechanism, ductility, and energy‐dissipation capability of a wall panel. The results obtained from 16 concrete masonry specimens are summarized in this paper. It has been shown that the flexural strength increases with the applied axial stress and the amount of the vertical reinforcement present. The shear strength dominated by diagonal cracking increases with the amount of vertical and horizontal steel, as well as with the tensile strength of masonry and the applied axial stress. However, the axial stress has a more significant influence on the flexural strength than on the shear strength. Furthermore, increasing the amount of vertical and horizontal reinforcement can substantially improve the postcracked ductility and energy‐dissipation capability of a shear‐dominated specimen.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Atkinson, R. H., and Kingsley, G. R. (1985). “A comparison of the behavior of clay and concrete masonry in compression.” Report No. 1.1‐1, U.S.‐Japan Coordinated Program for Masonry Building Research, Atkinson‐Noland & Assoc.
2.
Chen, S. W., et al. (1978). “Cyclic loading tests of masonry single piers, Vol. 2—Height to width ratio of 1.” Report no UCB/EERC‐78/28, Earthquake Engrg. Res. Ctr., Univ. of California, Berkeley, Calif.
3.
Hidalgo, P. A., et al. (1978). “Cyclic loading tests of masonry single piers, Vol. 1—Height to width ratio of 2.” Report No. UCB/EERC‐78/27, Earthquake Engrg. Res. Ctr., Univ. of California, Berkeley, Calif.
4.
Hidalgo, P. A., et al. (1979). “Cyclic loading tests of masonry single piers, Vol. 3—Height to width ratio of 0.5.” Report No. UCB/EERC‐79/12, Earthquake Engrg. Res. Ctr., Univ. of California, Berkeley, Calif.
5.
Kaba, S. A., and Mahin, S. A. (1983). “Interactive computer analysis methods for predicting the inelastic cyclic behavior of structural sections.” Report No. UCB/EERC‐83/18, Earthquake Engrg. Res. Ctr., Univ. of California, Berkeley, Calif.
6.
Kingsley, R. L., Tulin, L. G., and Noland, J. L. (1985). “Parameters influencing the quality of grout in hollow clay masonry.” Proc., Seventh Int. Brick Masonry Conf., Melbourne, Australia.
7.
Mayes, R. L., Omote, Y., and Clough, R. W. (1976a). “Cyclic shear tests of masonry piers, Vol. 1— Test results.” Report No. UCB/EERC‐76/8, Earthquake Engrg. Res. Ctr., Univ. of California, Berkeley, Calif.
8.
Mayes, R. L., Omote, Y., and Clough, R. W. (1976b). “Cyclic shear tests of masonry piers, Vol. 2—Analysis of test results.” Report No. UCB/EERC‐76/16, Earthquake Engrg. Res. Ctr., Univ. of California, Berkeley, Calif.
9.
Noland, J. L. (1987). “A review of the U.S. coordinated program for masonry building research.” Proc., Fourth North American Masonry Conf., The Masonry Society, Univ. of California, Los Angeles, Calif.
10.
Priestley, M. J. N. (1977). “Seismic resistance of reinforced concrete masonry shear walls with high steel percentages.” Bull. New Zealand Nat. Soc. Earthquake Engrg., 10(1).
11.
Priestley, M. J. N. (1986). “Flexural strength of rectangular unconfined masonry shear walls with distributed reinforcement.” Masonry Soc. J., 5(2).
12.
Priestley, M. J. N., and Bridgeman, D. O. (1974). “Seismic resistance of brick masonry walls.” Bull. New Zealand Nat. Soc. Earthquake Engrg., 7(4).
13.
Priestley, M. J. N., and Elder, D. (1982). “Cyclic loading tests of slender concrete masonry shear walls.” Bull. New Zealand Nat. Soc. for Earthquake Engrg., 15(1).
14.
Sheikh, S. A., and Uzumeri, S. M. (1982). “Analytical model for concrete confinement in tied columns.” J. Struct. Engrg., ASCE, 108(12), 2703–2722.
15.
Shing, P. B., et al. (1987). “Inelastic behavior of masonry wall panels under inplane cyclic loads.” Proc., Fourth North American Masonry Conf., Los Angeles, Calif.
16.
Sveinsson, B. I., McNiven, H. D., and Sucuoglu, H. (1985). “Cyclic loading tests of masonry single piers, Vol. 4—Additional tests with height to width ratio of 1.” Report No. UCB/EERC‐85/15, Earthquake Engrg. Res. Ctr., Univ. of California, Berkeley, Calif.
17.
Tomazevic, M., et al. (1986). “Seismic resistance of reinforced masonry walls.” Report No. ZRMK/IKPI‐86/04, Institute for Structures and Earthquake Engineering, Ljubljana, Yugoslavia.
18.
Wakabayashi, M., and Nakamura, T. (1984). “Reinforcing principle and seismic reistance of brick masonry walls.” Proc., Eighth World Conf. on Earthquake Engineering, V, San Francisco, Calif.
Information & Authors
Information
Published In
Copyright
Copyright © 1989 ASCE.
History
Published online: Sep 1, 1989
Published in print: Sep 1989
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.