Hysteretic Shear Model for Reinforced Concrete Members
Publication: Journal of Structural Engineering
Volume 115, Issue 1
Abstract
A hysteretic model is proposed for shear response of reinforced concrete members subjected to shear force and bending moment reversals. The model consists of a primary shear force‐shear displacement curve and unloading and reloading branches under cyclic loading. The primary curve is the envelope curve for the hysteretic relationship, and can be considered the same as the force displacement relationship under monotonic loading up to the onset of strength decay. A primary curve established by any acceptable procedure, with well‐defined cracking and yield points, can be used in constructing the model. The rules proposed for unloading and reloading branches of the model were obtained from a large number of test data. Full‐scale column tests, under inelastic load reversals, were used for this purpose. These rules were developed to predict experimentally observed stiffness degradation and pinching of hysteresis loops. Empirically derived expressions were included to introduce the effects of axial load, deformation level, and the number of deformation cycles. The model was employed to reproduce the results of large scale tests of reinforced concrete elements. The comparisons include columns, beams, and structural walls, tested by different investigators. Individual hysteresis loops of small and large deformation cycles are compared with those produced by the model. The results show a good agreement between the model and the experimental data.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
“Building code requirements for reinforced concrete.” (1983). ACI318‐83. Am. Concr. Inst., Detroit, Mich.
2.
Clough, R. W., and Johnston, S. B. (1966). “Effect of stiffness degradation on earthquake ductility requirements.” Proc., Japan Earthquake Engrg. Symp., Tokyo, Japan, Oct., 195–198.
3.
Collins, M. P., and Mitchell, D. (1980). “Shear and torsion design of prestressed and non‐prestressed concrete beams.” J. Prestressed Concr. Inst., 25(5), 32–100.
4.
Collins, M. P., and Mitchell, D. (1984). “Shear and torsion.” Concrete Design Handbook, Can. Portland Cement Assoc., Ottawa, Ontario, Canada, 4‐1–4–51.
5.
Marumaya, M., and Jirsa, J. O. (1979). “Shear behavior of reinforced concrete members under bidirectional reversed lateral loading.” CESRL Report No. 78‐1, Univ. of Texas at Austin, Austin, Tex.
6.
Oesterle, R. G., et al. (1979). “Earthquake resistant structural walls‐tests of isolated walls—phase II.” Report to NSF, Construction Technology Laboratories, Portland Cement Assoc., Skokie, Ill.
7.
Ozcebe, G., and Saatcioglu, M. (1987). “Confinement of concrete columns for seismic loading,” ACI Struct. J., 84(4), 308–315.
8.
Ozcebe, G., and Saatcioglu, M. (1988). Hysteretic shear response of reinforced concrete columns. Dept. of Civ. Engrg., Univ. of Toronto, Toronto, Ontario, Canada, in press.
9.
Ozcebe, G. (1987). “Inelastic response of reinforced concrete columns under unidirectional and bi‐directional load reversals.,” dissertation presented to Univ. of Toronto, Toronto, Ontario, Canada, in partial fulfillment of the requirements for the degree of Doctor of Philosophy.
10.
Saatcioglu, M., and Derecho, A. T. (1979). “Dynamic inelastic response of coupled shear walls as affected by axial forces.” Proc., Nonlinear Design of Concr. Struct., CSCE‐ASCE‐ACI‐CEB Int. Symp., Univ. of Waterloo Press, Waterloo, Ontario, Canada, 639–670.
11.
Saatcioglu, M., Ozcebe, G., and Lee, B. C. K. (1988). Tests of reinforced concrete columns under uniaxial and biaxial load reversals. Dept. of Civ. Engrg., Univ. of Toronto, Toronto, Ontario, Canada (in press).
12.
Saatcioglu, M., and Ozcebe, G. (1988). “Response of reinforced concrete columns to simulated seismic loading.” ACI Struct. J., (in press).
13.
Sheikh, S. A., and Uzumeri, S. M. (1980). “Strength and ductility of tied columns.” J. Struct. Div., ASCE, 106(5), 1079–1102.
14.
Takayanaki, T., Derecho, A. T., and Corley, W. G. (1979). “Analysis of inelastic shear deformation effects in R/C structural wall systems.” Proc., Nonlinear Design of Cone. Struct., CSCE‐ASCE‐AC1‐CEB Int. Symp., Univ. of Waterloo Press, Waterloo, Ontario, Canada, 545–579.
15.
Takayanagi, T., and Schnobrich, W. C. (1976). “Computed behavior of R/C shear walls.” SRS No. 434, Univ. Illinois, Urbana, Ill.
16.
Takeda, T., Sozen, M. A., and Nielsen, N. N. (1970). “Reinforced concrete response to simulated earthquakes.” J. Struct. Div., ASCE, 96(4), 2557–2573.
17.
Tankut, A. T., Fenwick, R. C., and Thorn, C. W. (1981). “The deformation of reinforced concrete beams subjected to inelastic cyclic loading‐experimental results.” UASE Report 268, Univ. of Auckland, New Zealand.
Information & Authors
Information
Published In
Copyright
Copyright © 1989 ASCE.
History
Published online: Jan 1, 1989
Published in print: Jan 1989
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.