Constitutive Model for Shear Transfer in Cracked Concrete
Publication: Journal of Structural Engineering
Volume 113, Issue 5
Abstract
The capability of rough cracks in concrete to transmit significant amounts of shear has been well recognized for the past few decades. In spite of extensive analysis and experimentation of interface shear, general constitutive models relating shear and normal stresses to corresponding displacements are scarce. A constitutive model for shear transfer (crack stiffness matrix) is desirable for the finite element modeling as well as for modeling mixed mode fracture problems. It is difficult to formulate the relation between stresses and displacements when all four parameters change during the test. To simplify the problem, normal and shear stresses were decoupled during testing in the study reported here. From the test data, expressions were formulated for shear stress versus slip and slip versus dilation at constant normal stresses. Coupling was incorporated by relating normal stresses to peak shear stresses by means of a “failure surface.” Using the proposed crack stiffness matrix formulation, the predicted values were satisfactorily compared with the data of other tests where normal and shear stresses were coupled. The proposed model assumes total deformation theory. Unloading is not considered.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Bažant, Z. P., and Gambarova, P., “Crack Shear in Concrete: Crack Band Microplane Model,” Journal of Structural Engineering, ASCE, Vol. 110, No. 9, Sep., 1984, pp. 2015–2035.
2.
Bažant, Z. P., and Gambarova, P., “Rough Cracks in Reinforced Concrete,” Journal of the Structural Division, ASCE, Vol. 106, No. 4, Apr., 1980, pp. 819–842.
3.
Bažant, Z. P., and Tsubaki, T., “Slip‐Dilatancy, Model for Cracked Reinforced Concrete,” Journal of the Structural Division, ASCE, Vol. 106, No. 9, Sep., 1980, pp. 1947–1966.
4.
Bresler, B., and Pister, K. S., “Strength of Concrete under Combined Stresses,” Journal of the American Concrete Institute, Vol. 30, No. 3, Sep., 1958, pp. 321–345.
5.
Buyukozturk, O., Connor, J. J., and Leombruni, P., “Research on Modeling Shear Transfer in Reinforced Concrete Nuclear Structures,” Nuclear Engineering and Design, Vol. 59, No. 1, Aug., 1979, pp. 67–84.
6.
Daschner, F., “Schubkraftubertragung in Rissen von Normal‐ und Leichtbeton,” Report, Lehstruhl fur Massivbau, Technische Universitat Munchen, West Germany, 1980.
7.
Fafitis, A., and Shah, S. P., “A Rheological Model for Cyclic Loading of Concrete,” Journal of Structural Engineering, ASCE, Vol. 110, No. 9, Sep., 1984, pp. 2085–2102.
8.
Fardis, M. N., and Buyukozturk, O., “Shear Stiffness of Concrete by Finite Elements,” Journal of the Structural Division, ASCE, Vol. 106, No. 6, Jun., 1980, pp. 1311–1327.
9.
Fardis, M. N., and Buyukozturk, O., “Shear Transfer Model for Reinforced Concrete,” Journal of the Engineering Mechanics Division, ASCE, Vol. 105, No. 2, Apr., 1979, pp. 255–275.
10.
Fenwick, R. C., “The Shear Strength of Reinforced Concrete Beams,” thesis presented to the University of Canterbury, Christchurch, New Zealand, in 1966, in partial fulfillment of the requirements for the degree of Doctor of Philosophy.
11.
Fenwick, R. C., and Paulay, T., “Mechanism of Shear Resistance of Beams,” Journal of the Structural Division, ASCE, Vol. 94, No. 10, Oct., 1968, pp. 2325–2350.
12.
Gopalaratnam, V. S., and Shah, S. P., “Softening Response of Concrete in Direct Tension,” Journal of the American Concrete Institute, Vol. 82, No. 3, May–Jun., 1985, pp. 290–303.
13.
Hofbeck, J. A., Ibrahim, I. O., and Mattock, A. H., “Shear Transfer in Reinforced Concrete,” Journal of the American Concrete Institute, Vol. 66, No. 2, Feb., 1969, pp. 119–128.
14.
Houde, J., and Mirza, M. S., “A Finite Element Analysis of Shear Strength of Reinforced Concrete Beams,” Shear in Reinforced Concrete, ACI Special Publication No. 42, American Concrete Institute, Detroit, Mich., 1974, pp. 105–128.
15.
Ingraffea, A. R., and Gerstle, W., “Non‐Linear Fracture Models for Discrete Crack Progation,” Application of Fracture Mechanics to Cementitious Composites, NATO‐ARW, S. P. Shah, Ed., Sep. 4–7, 1985, Northwestern University, Evanston, Ill., pp. 171–209.
16.
Laible, J. P., White, R. N., and Gergely, P., “An Experimental Investigation of Seismic Shear Transfer across Cracks in Concrete Nuclear Containment Vessels,” ACI Special Publication No. 53, American Concrete Institute, Detroit, Mich., 1977.
17.
Leichnitz, W., “Mechanical Properties of Rock Joints,” International Journal of Rock Mechanics, Mining Sciences and Geomechanics Abstracts, Vol. 22, No. 5, 1985, pp. 313–321.
18.
Loeber, P. J., “Shear Transfer by Aggregate Interlock,” thesis presented to the University of Canterbury, at Christchurch, New Zealand, in 1970, in partial fulfillment of the requirements for the degree of Master of Science.
19.
Marquardt, D. W., “An Algorithm for Least Squares Estimation of Non‐Linear Parameters,” Journal of SIAM, Vol. 11, No. 2, Mar., 1963, pp. 164–168.
20.
Mattock, A. H., “Cyclic Shear Transfer and Type of Interface,” Journal of the Structural Division, ASCE, Vol. 107, No. 10, Oct., 1981, pp. 1945–1964.
21.
Mattock, A. H., Chen, K. C., and Soongswong, K., “The Behavior of Reinforced Concrete Corbels,” PCI Journal, Vol. 21, No. 2, Mar.–Apr., 1976, pp. 52–77.
22.
Mattock, A. H., Johal, L., and Chow, H. C., “Shear Transfer in Reinforced with Moment or Tension Acting across the Shear Plane,” PCI Journal, Vol. 20, No. 4, Jul.–Aug., 1975, pp. 76–92.
23.
Mattock, A. H., Li, W. K., and Wang, T. C., “Shear Transfer in Lightweight Reinforced Concrete,” PCI Journal, Vol. 21, No. 1, Jan.–Feb., 1976, pp. 20–39.
24.
Millard, S. G., and Johnson, R. P., “Shear Transfer across Cracks in Reinforced Concrete due to Aggregate Interlock and Dowel Action,” Magazine of Concrete Research, Vol. 36, No. 126, Mar., 1984, pp. 9–21.
25.
Task Committee on Finite Element Analysis of Reinforced Concrete Structures of the Structural Division, Finite Element Analysis of Reinforced Concrete, ASCE, New York, N.Y., 1982.
26.
Walraven, J. C., and Reinhardt, H. W., “Experiments on Shear Transfer in Cracks in Concrete: Part I; Description of Results,” Stevin Laboratory Report No. 5‐79‐3, Delft University of Technology, Delft, The Netherlands, 1979.
27.
Walraven, J. C., “Aggregate Interlock A Theoretical and Experimental Analysis,” thesis presented to Delft University of Technology, at Delft, Netherlands, in 1980, in partial fulfillment of the requirements for the degree of Doctor of Engineering.
28.
White, R. N., Jiminez, R., and Gergely, P., “Sliding Shear and Dowel Forces in Cracked Reinforced Concrete Subjected to Seismic Loading,” Bulletin D'Information No. 132, ‘Structural Concrete Under Seismic Actions,’ CEB, Paris, France, Apr., 1979.
Information & Authors
Information
Published In
Copyright
Copyright © 1987 ASCE.
History
Published online: May 1, 1987
Published in print: May 1987
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.