Seismic Response of Light Subsystems on Inelastic Structures
Publication: Journal of Structural Engineering
Volume 111, Issue 2
Abstract
Preliminary analyses are performed to obtain insight into the seismic response of light, acceleration sensitive nonstructural subsystems supported on structures that yield during severe earthquake ground motions. The effects of the severity of the inelastic deformations, of different hysteretic characteristics of the structure and of the amount of viscous damping of the subsystem are thoroughly investigated. Current design recommendations for subsystems accounting for yielding of the supporting structure are assessed and found to be unconservative. An amplification factor is defined to quantify the effects of inelastic deformations of the supporting structure on subsystem response. Design guidelines are formulated for predicting the amplification factor based on statistical evaluation of the results generated for ten earthquake ground motions. Using these values, design floor response spectrums can be obtained from conventional linear elastic floor response spectrums accounting for yielding of the supporting structure without having to perform inelastic analysis.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Ayers, J. M., Sun, T. Y., and Brown, F. R., “Non‐Structural Damages to Buildings,” The Great Alaska Earthquake of 1964: Engineering, National Academy of Science, Washington, D.C., 1973.
2.
Ayres, J. M., and Sun, T. Y., “Non‐Structural Damages,” San Fernando, California Earthquake of February 9, 1971, National Oceanic and Atmospheric Administration, U.S. Department of Commerce, Washington, D.C., 1973.
3.
Biggs, J. M., and Roesset, J. M., “Seismic Analysis of Equipment Mounted on a Massive Structure,” Seismic Design For Nuclear Power Plants, R. J. Hansen, ed., MIT Press, Cambridge, Mass., 1970, pp. 319–343.
4.
Coats, D. W., “Recommended Revisions to Nuclear Regulatory Commission Seismic Design Criteria,” NUREG/CR‐1151, U.S. Nuclear Regulatory Commission, Washington, D.C., May, 1980.
5.
Crandall, S. H., and Mark, W. D., Random Vibration in Mechanical Systems, Academy Press Inc., New York, N.Y., 1963, pp. 85–101.
6.
Der Kiureghian, A., Sackman, J. L., and Nour‐Omid, B., “Dynamic Response of Equipment in Structures,” Report No. UCB/EERC‐81/05, Earthquake Engineering Research Center, University of California, Berkeley, Calif., Apr., 1981.
7.
“Design Response Spectra for Nuclear Power Plants,” Nuclear Regulatory Guide No. 1.60, Rev. 1, U.S. Nuclear Regulatory Commission, Washington, D.C., 1973.
8.
Goldberg, A., and Rukos, E. A., “Nonstructural Elements,” Design of Earthquake Resistant Structures, E. Rosenbleuth, ed., John Wiley and Sons, Inc., New York, N.Y., 1981, p. 267.
9.
Iwan, W. D., and Gates, N. C., “The Effective Period and Damping of a Class of Hysteretic Structures,” Journal of the International Association of Earthquake Engineering, Vol. 7, No. 3, May–June, 1979, pp. 199–211.
10.
Kawakatsu, T., Kitada, K., Takemori, T., Kuwabara, Y., and Ogiwara, Y., “Floor Response Spectra Considering Elasto‐Plastic Behavior of Nuclear Power Facilities,” Transactions of the 5th International Conference on Structural Mechanics in Reactor Technology, Paper K9/4, Berlin, Aug., 1979.
11.
Kelly, J. M., and Sackman, J. L., “Conservatism In Summation Rules for Closely Spaced Modes,” Report No. UCB/EERC‐79/11, Earthquake Engineering Research Center, University of California, Berkeley, Calif., May, 1979.
12.
Kelly, T. E., “Floor Response of Yielding Structures,” Bulletin of the New Zealand National Society for Earthquake Engineering, Vol. 11, No. 4, Dec., 1978.
13.
Mahin, S. A., and Lin, J., “Construction of Inelastic Response Spectra for Single‐Degree‐of‐Freedom Systems: Computer Program and Application,” Report No. UCB/EERC‐83/17, Earthquake Engineering Research Center, University of California, Berkeley, Calif., June, 1983.
14.
Newmark, N. M., and Hall, W. J., “Procedures and Criteria for Earthquake Resistant Design,” Building Practice for Disaster Mitigation, Building Science Series 45, National Bureau of Standards, Washington, D.C., Feb., 1973, pp. 209–236.
15.
Nigam, N. C., and Jenning, P. C., “SPECEQ/UQ‐Digital Calculation of Response Spectra from Strong‐Motion Earthquake Records,” Earthquake Engineering Research Laboratory, California Institute of Technology, June, 1968.
16.
Sackman, J. L., and Kelly, J. M., “Rational Design Methods for Light Equipment in Structures Subjected to Ground Motion,” Report No. UCB/EERC‐78/19, Earthquake Engineering Research Center, University of California, Berkeley, Calif., Sept., 1978.
17.
Shibata, A., and Sozen, M., “Substitute‐Structure Method for Seismic Design for R/C,” Journal of the Structural Division, ASCE, Vol. 102, No. ST1, Jan., 1976, pp. 1–18.
18.
Trifunac, M. D., “Response Envelope Spectrum and Interpretation of Strong Earthquake Ground Motion,” Bulletin of the Seismological Society of America, Vol. 61, Apr., 1971, pp. 343–356.
19.
“Development of Floor Response Spectra for Seismic Design of Floor‐Supported Equipment or Components,” Nuclear Regulatory Guide No. 1.122, Rev. 1, U.S. Nuclear Regulatory Commission, Washington, D.C., 1973.
20.
Viti, G., Olvieri, M., and Travi, S., “Development of Non‐Linear Floor Response Spectra,” Nuclear Engineering and Design, Amsterdam, The Netherlands, Vol. 64, No. 1, Mar., 1981, pp. 33–38.
Information & Authors
Information
Published In
Copyright
Copyright © 1985 ASCE.
History
Published online: Feb 1, 1985
Published in print: Feb 1985
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.