Floor Spectra for Nonclassically Damped Structures
Publication: Journal of Structural Engineering
Volume 111, Issue 11
Abstract
An approach is presented for the generation of seismic floor response spectra for structures which cannot be modeled as classically damped. Although the nonclassically damped structures do not possess classical modes, the proposed approach can still employ prescribed ground response spectra directly as input for the generation of floor spectra. The approach requires the solution of a complex eigenvalue problem which provides the information about the equivalent modal frequencies and damping ratios of the structure. The floor response spectrum value is expressed in terms of these equivalent modal parameters. The seismic input is required to be defined in terms of psuedo acceleration and relative velocity ground spectra for the equivalent modal frequencies and damping ratios of the structure and also at the oscillator frequency and its damping ratio. To verify the applicability of the proposed approach in view of simplifying assumptions made in this development, a numerical simulation study has been conducted. The results obtained by the proposed direct approach and the time history approach for an ensemble of acceleration time histories as inputs compare very well with each other, thus validating the applicability of the proposed approach.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Biggs, J. M., “Seismic Response Spectra for Equipment Design in Nuclear Power Plants,” Proceedings, SMIRT‐1 Conference, Paper K4/7, Berlin, Germany, Sept., 1971.
2.
Caughey, T. K., “Classical Normal Modes in Damped Linear Dynamic Systems,” Journal of Applied Mechanics, Vol. 27, June, 1960, pp. 269–271.
3.
Der Kiureghian, A., Sackman, J. L., and Nour‐Omid, B., “Dynamic Response of Light Equipment in Structures,” Report No. UCB/EERC‐81/05, University of California, Berkeley, Calif., Apr., 1981.
4.
“Design Response Spectra for Nuclear Power Plants,” Nuclear Regidatory Guide No. 1.60, U.S. Nuclear Regulatory Commission, Washington, D.C., 1975.
5.
Foss, K. A., “Co‐ordinates which Uncouple the Equations of Motion of Damped Linear Dynamic Systems,” Journal of Applied Mechanics, Vol. 25, Sept., 1958, pp. 361–364.
6.
Gasparini, D., and Vanmarcke, E. H., “Simulated Earthquake Motions Compatible with Prescribed Response Spectra,” Pub. No. R76‐4, Department of Civil Engineering, Massachusetts Institute of Technology, Jan., 1975.
7.
Jennings, P. C., Housner, G. W., and Tsai, N. C., “Simulated Earthquake Motions,” Earthquake Engineering Research Lab Report, California Institute of Technology, Pasadena, Calif., Apr., 1968.
8.
Kapur, K. K., and Shao, L. C., “Generation of Seismic Floor Response Spectra for Equipment Design,” Proceedings, Specialty Conference on Structural Design of Nuclear Power Plant Facilities, Chicago, Ill., Dec., 1973.
9.
Lin, Y. K., Probabilistic Theory of Structural Dynamics, McGraw Hill, Inc., New York, N.Y., 1967.
10.
Meirovitch, L., Analytical Methods in Vibrations, McMillan Co., New York, N.Y., 1967.
11.
Newmark, N. M., Blume, J. A., and Kapur, K. K., “Seismic Design Spectra for Nuclear Power Plants,” Journal of the Power Division, ASCE, Vol. 99, 1973.
12.
Scanlan, R. H., and Sachs, K., “Floor Response Spectra for Multi‐Degree‐of‐Freedom Systems by Fourier Transforms,” Proceedings, SMIRT‐3 Conference, Paper K5/5, London, England, Sept., 1975.
13.
Sharma, A. M., “Direct Generation of Seismic Floor Response Spectra for Classically and Nonclassically Damped Structures,” dissertation presented to Virginia Polytechnic Institute and State University, at Blacksburg, Va., in 1983, in partial fulfillment of the requirements of the degree of Doctor of Philosophy.
14.
Singh, M. P., “Generation of Seismic Floor Spectra,” Journal of the Engineering Mechanics Division, ASCE, Vol. 101, No. EM5, Paper 11651, Oct., 1975, pp. 593–607.
15.
Singh, M. P., “Seismic Design Input for Secondary Systems,” Journal of the Structural Division, ASCE, Vol. 106, No. ST2, Paper 15207, Feb., 1980, pp. 505–517.
16.
Singh, M. P., “Seismic Response by SRSS for Nonproportional amping,” Journal of the Engineering Mechanics Division, ASCE, Vol. 106, No. EM6, Paper 15948, Dec., 1980, pp. 1405–1419.
17.
Vanmarcke, E. H., “Seismic Structural Response,” Seismic Risk and Engineering Decision, Chap. 8, C. Lomnitz and E. Rosenblueth, Eds., Elsevier Scientific Publishing Co., New York, N.Y., 1976.
18.
Vanmarcke, E. H., “A Simple Procedure for Predicting Amplified Response Spectra and Equipment Response,” Proceedings, 6th World Conference on Earthquake Engineering, New Delhi, India, Jan., 1977.
Information & Authors
Information
Published In
Copyright
Copyright © 1985 ASCE.
History
Published online: Nov 1, 1985
Published in print: Nov 1985
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.