Seepage Effects on Sand‐Bed Channels
Publication: Journal of Irrigation and Drainage Engineering
Volume 120, Issue 1
Abstract
Experiments were conducted to find the effects of seepage on flow over a sand bed in a straight rectangular flume under two conditions: (1) When the channel bed is plane, horizontal, and nontransporting; and (2) when the bed is transporting at a constant sediment concentration. Effects of both injection and suction, caused by seepage flow into and out of the channel bed, are studied for condition 1; and only suction effects are studied for condition 2. Three sands, of sizes 0.34 mm, 0.53 mm, and 0.80 mm, are used in the study. It is found that seepage can cause an increase or decrease in the bed shear stress relative to no seepage for the two conditions. The change in bed shear stress depends on the relative magnitudes of the bed shear stress and the critical shear stress of particles under the no‐seepage condition, sediment concentration, and the seepage rate. Quantitative relationships giving the ratio of bed shear stresses with and without seepage are presented for both conditions of the bed. A procedure to estimate the changes in bed shear stress, friction factor, Manning's , and stream power due to seepage for known initial conditions of the channel and the amount of applied seepage is presented.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Burgi, P. H., and Karaki, S. (1971). “Seepage effects on channel bank stability.” J. Irrig. and Drain Engrg. Div., ASCE, 97(1), 59–72.
2.
Chow, V. T. (1959). Open‐channel hydraulics. McGraw‐Hill Book Co., Inc., New York, N.Y.
3.
Clarke, J. H., Menkes, H. R., and Libby, P. A. (1955). “A provisional analysis of turbulent boundary layers with injection.” J. Aeronautical Sci., 22(4), 255–260.
4.
Coleman, N. L. (1967). “A theoretical and experimental study of drag and lift forces acting on a sphere resting on hypothetical stream bed.” Proc., 12th Congr. of Int. Assoc. for Hydr. Res. (IAHR), Vol. 3, 185–192.
5.
Dutton, R. A. (1960). “The effect of distributed suction on the development of turbulent boundary layers.” No. 3155, Aeronautical Res. Council, London, England.
6.
Eckert, E. R. G., Diaguila, A. J., and Danoughe, P. L. (1955). “Experiments on turbulent flow through channels having porous rough surfaces with or without air injection.” TN 3339, National Advisory Committee for Aeronautics (NACA), Washington, D.C.
7.
Harrison, S. S. (1968). “The effects of ground water seepage on stream regimen—a laboratory study,” PhD thesis, University of North Dakota, Grand Forks, N.D.
8.
Oldenziel, D. M., and Brink, W. E. (1974). “Influence of suction and blowing on entrainment of sand particles.” J. Hydr. Div., ASCE, 100(7), 935–949.
9.
Ramakrishna Rao, A. (1979). “Seepage effects on the resistance characteristics of sand bed channels,” PhD thesis, Indian Institute of Science, Bangalore, India.
10.
Ramakrishna Rao, A., and Vedula, S. (1981). “Liquid bubble manometer for low differential heads.” Proc., Indian Academy of Sciences (Engrg. Sciences), Indian Academy of Sciences, Bangalore, India, Vol. 4, Part 1, 87–94.
11.
Ramakrishna Rao, A. (1989). “A new incipient motion criterion independent of particle size.” Proc., 3rd Int. Workshop on Alluvial River Problems, Oxford and IBH Publishing Co., 155–160.
12.
Ramakrishna Rao, A., and Namboodiripad, D. (1992). “A micromanometer with a capacitative transducer.” VIII APD‐IAHR Congr., F21–F27.
13.
Richardson, J. R., Abt, S. R., and Richardson, E. V. (1985). “Inflow seepage influence on straight alluvial channels.” J. Hydr. Engrg., ASCE, 111(8), 1133–1147.
14.
Schlichting, H. (1968). Boundary‐layer theory. McGraw‐Hill Book Co., Inc., New York, N.Y.
15.
Shen, H. W. (1971). River mechanics vol. I. Colorado State Univ., Fort Collins, Colo.
16.
Simons, D. B., and Richardson, E. V. (1966). “Resistance to flow in alluvial channels.” Geological Survey Prof. Paper, 422‐J, U.S. Geological Survey, Washington, D.C.
17.
Sparrow, E. M., and Eckert, E. R. G. (1962). “Sensitivity of skin friction and drag to the distribution of suction and blowing.” J. Aerosp. Sci., 29(1), 104–105.
18.
Thayumanavan, S. (1986). “Variations in boundary shear stress in sand bed channels subjected to seepage,” PhD thesis, Indian Institute of Science, Bangalore, India.
19.
Turcotte, D. L. (1960). “A sub‐layer theory for fluid injection into incompressible turbulent boundary layer.” J. Aerosp. Sci., 27(9), 675–678.
20.
Vanoni, V. A., and Brooks, N. H. (1957). “Laboratory studies of the roughness and suspended load of alluvial streams.” Rep. No. E‐68, California Inst. of Technol., Pasadena, Calif.
21.
Vanoni, V. A. (1964). “Measurement of critical shear stress for entraining fine sediments in a boundary layer.” Report no. KH‐R‐7, California Inst. of Technol., Pasadena, Calif.
22.
Watters, G. Z., and Rao Manam, V. P. (1971). “Hydrodynamic effects of seepage on bed particles.” J. Hydr. Div., ASCE, 101(3), 421–439.
23.
Willets, B. B., and Drossos, M. E. (1975). “Local erosion caused by rapid infiltration.” J. Hydr. Div., ASCE, 101(12), 1477–1488.
24.
Zagni, A. F. E., and Smith, K. V. H. (1976). “Channel flow over permeable beds of graded spheres.” J. Hydr. Div., ASCE, 102(2), 207–222.
Information & Authors
Information
Published In
Copyright
Copyright © 1994 American Society of Civil Engineers.
History
Received: Sep 27, 1991
Published online: Jan 1, 1994
Published in print: Jan 1994
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.