Furrow Irrigation Using Canal Side Weirs
Publication: Journal of Irrigation and Drainage Engineering
Volume 113, Issue 2
Abstract
The potential of canal side weirs for uniform water delivery to irrigation furrows and system flexibility is assessed. Weir discharge uniformity is affected by: (1) Canal velocity and weir entrance conditions; (2) variations in weir crest construction elevations; and (3) variations in water surface elevations along the distribution canal. For sharp‐entranced weirs, model studies show that the decrease in canal flow velocity down a typical distribution reach can result in an increase in weir discharge up to 15%. This velocity effect is significantly dampened by using a streamlined entrance to the weir. Field data on weir crest elevations have a standard deviation of about 3 mm, which translates into 6–8% weir discharge variation at normal discharge settings. A computer model of distribution canal flows indicates weir discharge uniformity is improved by shortening the length of the reach, reducing the required weir discharge setting, and increasing canal size. A design guideline is developed for the system.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Amruthur, S., Ramamurthy, M., Udoyara, S. T., and Carbollada, L. B. (1986). “Lateral weirs in trapezoidal channels.” J. Irrig. Drain. Engrg., ASCE, 112(2), 130–137.
2.
Bondurant, J. A., and Humphreys, A. S. (1962). “Surface irrigation through automatic control.” Agric. Engrg., 43(1), 20–21, 35.
3.
Bos, M. G., Replogle, J. A., and Clemens, A. J. (1984). Flow measuring flumes for open channel systems. John Wiley & Sons, New York, N.Y.
4.
Clemens, A. J. (1983). “Fluctuations in irrigation water delivery.” Proc., ASCE Spec. Conf., held at Jackson, Wyo.
5.
Dedrick, A. R., and Erie, L. J. (1978). “Automation of on farm irrigation turnouts utilizing jack‐gates.” Trans., ASAE, 21(1), 92–96.
6.
Edling, R. J., Duke, H. R., and Payne, M. L. (1978). “Utilization of a portable solid state furrow irrigation valve controller.” ASAE paper no. 78‐2546, ASAE, St. Joseph, Mich.
7.
Edwards, F. W. (1941). “Uniformly tapped pipes.” Engrg. News‐Rec., 126, 78.
8.
Eftekharzadeh, S. (1985). “Canal side weirs for water delivery to irrigation furrows,” thesis presented to the University of Arizona, at Tucson, Ariz., in partial fulfillment of the requirements for the degree of Masters of Science.
9.
Erie, L. J., and Dedrick, A. R. (1978). “Automation of an open ditch irrigation conveyance system utilizing jack‐gates.” Trans., ASAE, 21(1), 119–123.
10.
Evans, G. R. (1976). “An improved cut‐back surface irrigation system.” ASAE paper no. 76‐2048, ASAE, St. Joseph, Mich.
11.
Fischer, H. D., Humphreys, A. S., and Young, D. A. (1983). “Automated telemetric irrigation controller.” Proc., ASCE spec., conf., held at Jackson, Wyo.
12.
Garton, J. E., Beasley, R. P., and Barefoot, A. D. (1964). “Automation of cutback furrow irrigation.” Agric. Engrg., 45(6), 328–329.
13.
Gladding, R. D. (1940). “Loss of head determination in uniformly tapped pipes.” Engrg. News‐Rec., 115, 699.
14.
Haise, H. R., and Whitney, P. L. (1967). “Hydraulically controlled gates for automatic surface irrigation.” trans. ASAE, 10(3), 639–642.
15.
Hansen, V. E. (1954). “Determination of water flow from gated pipes.” Agric. Engrg., 35(7), 496–97.
16.
Henderson, F. M. (1966). Open channel flow. Macmillan Pub. Co., New York, N.Y.
17.
Humphreys, A. S. (1967). “Control structures for automatic surface irrigation systems.” Trans. ASAE, 10(1), 21–21, 27.
18.
Humphreys, A. S. (1971). “Automation furrow irrigation systems.” trans. ASAE, 14(3), 466–470.
19.
Keller, J. D., Jr. (1949). “The manifold problem.” J. Appl. Mech., 16, 77–85.
20.
Manges, H. L., Matteson, D. K., and Butler, K. G. (1980). “Radio controls for gated‐pipe irrigation.” ASAE paper no. 80‐2557, ASAE, St. Joseph, Mich.
21.
Marr, J. C. (1967). “Furrow irrigation.” Agric. Sci. Pub. No. 4027, Univ. of Calif., Richmond, Calif.
22.
Payne, M. G., Duke, H. R., and Haise, H. R. (1974). “Further development in automation of level basins.” ASAE paper no. 74‐2530, ASAE, St. Joseph,. Mich.
23.
Ramirez‐Guzman, H., and Manges, H. (1971). “Uniform flow from orifices in irrigation pipe.” Trans. ASAE, 14(1), 127–129.
24.
Sweeten, J. M., Garton, J. E., and Mink, A. L. (1969). “Hydraulics roughness of an irrigation channel with decreasing spatially varied flow.” Trans. ASAE, 12(4), 466–470.
25.
Sweeten, J. M., and Garton, J. E. (1970). “Hydraulics of an automated furrow irrigation system with rectangular side weir outlets.” Trans. ASAE, 25(1), 120–123.
26.
Taylor, A. R., Ryde, D. H., and Aldridge, D. G. (1982). “Automation of New Zealand border strip irrigation.” Trans. ASAE, 25(1), 120–123.
27.
Tovey, R., and Myers, V. I. (1959). “Evaluation of some water control devices.” Idaho agric. exp. sta. bull., 319, 6–9.
Information & Authors
Information
Published In
Journal of Irrigation and Drainage Engineering
Volume 113 • Issue 2 • May 1987
Pages: 251 - 265
Copyright
Copyright © 1987 ASCE.
History
Published online: May 1, 1987
Published in print: May 1987
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.