3D Numerical Simulation for Water Flows and Sediment Deposition in Dam Areas of the Three Gorges Project
Publication: Journal of Hydraulic Engineering
Volume 135, Issue 9
Abstract
This paper presents a three-dimensional (3D) mathematical model for suspended load transport in turbulent flows. Based on the stochastic theory of turbulent flow proposed by Dou, numerical schemes of Reynolds stresses for anisotropic turbulent flows are obtained. Instead of a logarithmic law, a specific wall function is used to describe the velocity profile close to wall boundaries. The equations for two-dimensional suspended load motion and sorting of bed material have been improved for a 3D case. Numerical results are in good agreement with the measured data of the Gezhouba Project. The present method has been employed to simulate sediment erosion and deposition in the vicinity of the Three Gorges Dam. The size distribution of the deposits and bed material, and flow and sediment concentration at different times and elevations, are predicted. The results agree well with the observations in physical experiments. Thus, a new method is established for 3D simulation of sediment motion in the vicinity of dams.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The project is financially supported by the National Basic Research 973 Program of China (Grant No. UNSPECIFIED2003CB415206) and the National Natural Science Foundation of China (Grant No. NNSFC50879047), and the “Ninth 5-year Plan” TGP engineering sediment problem fundamental research grant (Grant No. UNSPECIFIED95-3-3). The writers benefited greatly from stimulating discussions with Dr. Longxi Han, Yan Lu, Xianghua Yang, Liqin Zuo, and Rongyao Ji.
References
Bijvelds, M. D. J. P., Kranenburg, C., and Stelling, G. S. (1999). “3D numerical simulation of turbulent shallow-water in square harbor.” J. Hydraul. Eng., 125(1), 26–31.
Celik, I., and Rodi, W. (1988). “Modeling suspended sediment transport in non-equilibrium situations.” J. Hydraul. Eng., 114(10), 1157–1191.
Chen, R. F. (1986). “Modeling of estuary hydrodynamics—A mixture of art and science.” Proc., 3rd Int. Symp. on River Sedimentation, Univ. of Mississippi, Mississippi.
Chien, N., and Wan, Z. H. (1999). Mechanics of sediment transport, ASCE, Reston, Va.
Demuren, A. O. (1989). “Calculation of sediment transport in meandering channels.” Proc., Tech. Session A, 23rd IAHR Congr., Int. Association for Hydraulic Research, Delft, The Netherlands.
Demuren, A. O. (1991). “Development of a mathematical model for sediment transport in meandering rivers.” Rep. No. 693, Inst. for Hydromechanics, Univ. of Karlsruhe, Karlsruhe, Germany.
Demuren A. O. and Rodi W. (1986). “Calculation of flow and pollutant diffusion in meandering channels.” J. Fluid Mech., 172, 63–92.
Dou, G. R. (1980). “The stochastic theory and the general law of all flow regions for turbulent open channel flows. ” Proc., 1st Int. Symp. on River Sedimentation, Guanghua Press, Beijing, 151–161.
Dou, G. R. (1981). Turbulence flow dynamics, Vol. A, People’s Education, Beijing (in Chinese).
Dou, X. B. (1997). “Numerical simulation of three-dimensional flow field and local scour at bridge rossings.” Ph.D. dissertation, The Univ. of Mississippi, Mississippi.
Fang, H. W., and Rodi, W. (2003). “Three-dimensional calculations of flow and suspended sediment transport in the neighborhood of the dam for the Three Gorges Project (TGP) reservoir in the Yangtze River.” J. Hydraul. Res., 41(4), 379–394.
Fang, H. W., and Wang, G. Q. (2000). “Three-dimensional mathematical model of suspended-sediment transport.” J. Hydraul. Eng., 126(8), 578–592.
Fernette, R. D. G., and Tanguy, J. M. (1992). “A three-dimensional finite element sediment transport model.” Proc., 5th Int. Symp. on River Sedimentation, Univ. of Karlsruhe, Karlsruhe, 365–374.
Ge, L., and Sotiropoulos, F. (2005). “3D unsteady rans modeling of complex hydraulic engineering flows. Part I: Numerical model.” J. Hydraul. Eng., 131(9), 800–808.
Han, Q. W., and He, M. M. (1990). “A mathematical model for reservoir sedimentation and fluvial process.” Int. J. Sediment Res., 5(2), 43–84.
Holly, F. M., Jr., and Rahuel, J. L. (1990). “Numerical physical framework for mobil-bed modelling.” J. Hydraul. Res., 28(4), 401–416.
Launder, B. E., and Spalding, D. B. (1974). “The numerical computation of turbulent flows.” Comput. Methods Appl. Mech. Eng., 3(2), 269–289.
Lin, B. L. and Falconer, R. A. (1996). “Numerical modeling of three-dimensional suspended load for estuarine and coastal waters.” J. Hydraul. Res., 34(4), 435–456.
Lu, Y. J., Han, L. X., and Yang, X. H. (2002). “3D turbulent flow sediment mathematical model and its application in sediment erosion and deposition in the dam area of Three Gorges Project.” Rep. No. H0256, Nanjing Hydraulic Research Institute, Nanjing, China (in Chinese).
McAnally, W. H., Leter, J. W., and Tomas, W. A. (1986). “Two- and three-D modeling systems for sedimentation.” Proc., 3rd Int. Symp. on River Sedimentation, Univ. of Mississippi, Mississippi.
Nagata, N., Hosoda, T., Nakato, T., and Muramoto, Y. (2005). “Three-dimensional numerical model for flow and bed deformation around river hydraulic structures.” J. Hydraul. Eng., 131(12), 1074–1087.
Nanjing Hydraulic Research Institute. (2002). “Experimental researches on sediment deposition and navigation flow conditions in the dam area of Three Gorges Project.” Researches on sediment problems of Three Gorges Project on Yangtze River (1996–2000), Intellectual Property, Beijing, 1521–1613 (in Chinese).
Olsen, N. R. B., and Kjelesvig, H. M. (1998). “Three-dimensional numerical flow modeling for maximum local scour depth.” J. Hydraul. Res., 36(4), 579–597.
Olsen, N. R. B., and Skoglund, M. (1994). “Three-dimensional suspended load for estuarine and coastal water.” J. Hydraul. Res., 32(6), 833–844.
Patankar, S. V. (1980). Numerical heat transfer and fluid flow, Hemisphere, Washington, D.C.
Prinos, P. (1993). “Compound open flow with suspended loads.” Proc., Advances in Hydro-Science and Engineering, First Int. Conf. on Hydro-Science and Engineering, Univ. of Mississippi, Washington, D.C., 1206–1214.
Rodi, W. (1984). Turbulence models and their application in hydraulics-a state of the art view, Int. Assoc. for Hydraulics Research, Delft, The Netherlands.
Rüther, N., and Olsen, N. R. B. (2005). “Three-dimensional modeling of sediment transport in a narrow 90° channel bend.” J. Hydraul. Eng., 131(10), 917–920.
Shimizu, Y., Yamaguchi, H., and Itakura, T. (1990). “Three-dimensional computation of flow and bed deformation.” J. Hydraul. Eng., 116(9), 1090–1108.
Spalding, B. D., and Svensson, U. (1990). “The development and erosion of the thermocline.” Heat transfer and turbulent buoyant convection, studies and applications, for natural environment, buildings, engineering systems, D. B. Spalding and N. Afgon, eds., Hemisphere, Washington, D.C.
Thompson, J. F., Warsi, Z. U. A., and Mastin, C. W. (1985). Numerical grid generation-foundations and applications, Elsevier Science, Amsterdam, The Netherlands.
Tsinghua University. (2002). “Experimental researches on sediment models for the dam area of Three Gorges Project.” Researches on sediment problems of Three Gorges Project on Yangtze River (1996–2000), Intellectual Property, Beijing, 1614–1665 (in Chinese).
Van Rijn, L. C. (1981). “Entrainment of fine sediment particles; development of concentration profiles in a steady, uniform flow without initial sediment load.” Rep. No. M1531, Delft Hydraulic Laboratory, Delft, The Netherlands.
Van Rijn, L. C. (1984). “Sediment transport. Part III: Bed forms and alluvial roughness.” J. Hydraul. Eng., 110(12), 1733–1754.
Van Rijn, L. C. (1986). “Mathematical modeling of suspended sediment in non-uniform flows.” J. Hydraul. Eng., 112(6), 433–455.
Van Rijn, L. C. (1987). “Mathematical modeling of morphological processes in the case of suspended load transport.” Delft Hydra. Communication Rep. No. 382, WL|Delft Hydraulics, Delft, The Netherlands.
Wang, S. Y., and Adeff, S. E. (1986). “Three-dimensional modeling of river sedimentation processes.” Proc., 3rd Int. Symp. on River Sedimentation, Univ. of Mississippi, Mississippi, 1594–1601.
Wang, S. Y., and Jia, Y. (1995). “Computational modeling and hydroscience research.” Proc., Advances in Hydro-Science and Engineering, 2nd Int. Conf. on Hydro-Science and Engineering, Tsinghua University Press, Beijing, 2147–2157.
Wang, Z. B., and Ribberink J. S. (1986). “The validity of a depth-integrated model for suspended sediment transport.” J. Hydraul. Res., 24(1), 53–66.
Willemse, J. B. T. M. (1986). “Solving shallow water equations with an orthogonal coordinate transformation.” Delft Hydraulics Communication Rep. No. 356, WL|Delft Hydraulics, Delft, The Netherlands.
Wu, W. M., Rodi, W., and Wenka, T. (2000). “3D numerical model of flow and sediment transport in open channels.” J. Hydraul. Eng., 126(1), 4–15.
Yangtze River Scientific Research Institute. (2002). “Experimental researches on sediment models for the approach channel in the upstream of Three Gorges Project.” Researches on sediment problems of Three Gorges Project on Yangtze River (1996–2000), Intellectual Property, Beijing, 1455–1520 (in Chinese).
Ye, J., and Dou, G. R. (1989). “A new turbulence model: The K-\Gj-S model.” Proc., Int. Symp. on Sediment Transport Modeling, ASCE, New Orleans, 184–189.
Ye, J., and Dou, G. R. (1990). “A new turbulent flow model-K-e-S model.” J. of Hydro-Science and Engineering, 3(1), 1–10 (in Chinese).
Ye, J., and McCorquodale, J. A. (1998). “Simulation of curved open channel flows by 3d hydrodynamic model.” J. Hydraul. Eng., 124(7), 687–698.
Information & Authors
Information
Published In
Copyright
© 2009 ASCE.
History
Received: Aug 24, 2006
Accepted: Apr 24, 2009
Published online: Aug 14, 2009
Published in print: Sep 2009
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.