Rapid Flow Startup in Filled Horizontal Pipelines
Publication: Journal of Hydraulic Engineering
Volume 134, Issue 7
Abstract
Maintenance or repair of water mains may require the interruption of flow. Reinitiation of flow may present opportunities for the interaction of air and the accelerating water, resulting in undesirable pressure transients. This study focuses on air intrusion during flow startup in an initially filled horizontal pipeline supplied by a constant-head reservoir. Flow was initiated by opening the downstream end, allowing a free discharge at that point. During the initial phases of flow startup, an air cavity intruded in the upper portion of the pipe cross section while water exited the pipeline through the lower portion. The initial reservoir head controlled the rate of water velocity increase and, thus, the air intrusion advance. Air intrusion occurred until the water velocity was sufficient to arrest the intrusion. Higher reservoir heads resulted in the subsequent expulsion of the intrusion from the pipeline. However, for lower reservoir heads, the intrusion was not expelled, but readvanced to a final position that was controlled by shear forces. Criteria are developed for the flow conditions necessary to arrest the air intrusion in a horizontal pipeline as well as the intrusion lengths to be expected.
Get full access to this article
View all available purchase options and get full access to this article.
References
Albertson, M. L., and Andrews, J. S. (1971). “Transients caused by air release.” Control of flow in closed conduits, J. P. Tullis, ed., Colorado State Univ., Fort Collins, Colo.
Benjamin, T. B. (1968). “Gravity currents and related phenomena.” J. Fluid Mech., 31(2), 209–248.
Cardle, J. A., and Song, C. S. S. (1988). “Mathematical modeling of unsteady flow in storm sewers.” Int. J. Eng. Fluid Mech., 1(4), 495–518.
Cunge, J. A., and Wegner, M. (1964). “Integration numerique des equations d’ecoulement de Barre de St. Venant par un schema implicite de differences finies. Application au cas d’une galerie tantot en charge tantot a surface libre.” Houille Blanche, 1, 33–39 (in French).
Fuertes, V. S., Arregui, F., Cabrera, E., and Iglesias, P. L. (2000). “Experimental setup of entrapped air pockets model validation.” Proc., 8th Int. Conf. on Pressure Surges—Safe Design and Operation of Industrial Pipe Systems, 133–145.
Guizani, M., Vasconcelos, J. G., Wright, S. J., and Maalel, K. (2006). “Investigation of rapid filling of empty pipes.” Intelligent modeling of urban water systems, W. James et al., eds., Monograph 14, Chap. 20:463–482, CHI.
Henderson, F. M. (1966). Open channel flow, Prentice-Hall, Upper Saddle River, N.J.
Izquierdo, J., Fuertes, V. S., Cabrera, E., Iglesias, P. L., and Garcia-Serra, J. (1999). “Pipeline start-up with entrapped air.” J. Hydraul. Res., 37(5), 579–590.
Keulegan, G. H. (1966). “Chapter 11: The mechanism of an arrested saline wedge.” Estuary and coastline hydrodynamics, A. Ippen, ed., McGraw-Hill, New York.
Liou, C. P., and Hunt, W. A. (1996). “Filling of pipelines with undulating elevation profiles.” J. Hydraul. Eng., 122(10), 534–539.
Martin, C. S. (1976). “Entrapped air in pipelines.” Proc., 2nd Int. Conf. on Pressure Surges—BHRA, F2-15–F2-25.
Townson, J. M. (1991). Free-surface hydraulics, Cambridge University Press.
Vasconcelos, J. G., Wright, S. J., and Roe, P. L. (2006). “Improved simulation of flow regime transition in sewers: The two-component pressure approach.” J. Hydraul. Eng., 132(6), 553–562.
Whitham, G. B. (1955). “The effects of hydraulic resistance in the dam-break problem.” Proc. R. Soc. London, Ser. A, 227(1170), 399–407.
Wylie, E. B., and Streeter, V. L. (1993). Fluid transients in systems, Prentice-Hall, Upper Saddle River, N.J., 95–99.
Information & Authors
Information
Published In
Copyright
© 2008 ASCE.
History
Received: Dec 29, 2006
Accepted: Nov 2, 2007
Published online: Jul 1, 2008
Published in print: Jul 2008
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.