Model for Predicting Floods due to Earthen Dam Breaching. I: Formulation and Evaluation
This article is a reply.
VIEW THE ORIGINAL ARTICLEThis article has a reply.
VIEW THE REPLYPublication: Journal of Hydraulic Engineering
Volume 134, Issue 12
Abstract
This paper proposes a dam-breach model which predicts, in a simple but physically based manner, not only the peak discharge but the whole outflow hydrograph and breach development. The following aspects are taken into account: the geometry of the embankment, the shape of the reservoir, the hydraulic characteristics of the flow through the breach and its erosive capacity, and the shape of the breach. The model needs only one calibration parameter and can be easily applied to real cases. The application of the model with a single value of the calibration parameter produced excellent results in the simulation of 12 historic earthfill dam failures, with a discharge range covering three orders of magnitude.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This paper is dedicated to Professor Giuseppe Frega, in the year of his 70th birthday. The writer is grateful to the anonymous reviewers for their valuable observations which led to a greater in-depth analysis of a number of aspects dealt with herein. Thanks also go to Gianluca De Lorenzo and Antonella Rino for their notable contribution to the numerical calculation and layout of the figures.
References
Balloffet, A., and Scheffler, M. L. (1982). “Numerical analysis of the Teton Dam failure flood.” J. Hydraul. Res., 20(4), 317–328.
Benoist, G., and Nicollet, G. (1983). “Rupture progressive des barrages en terre.” Proc. 20th IAHR Congress, Vol. 2, International Association of Hydraulic Research, Moscow, 464–470.
Chadwick, W. L., et al. (1976). “Failure of Teton Dam.” Rep. to U.S. Department of the Interior and State of Idaho, Independent Panel to Review Cause of Teton Dam Failure, Idaho Falls, Id.
Chanson, H. (2004). “Discussion of Overtopping breaching of noncohesive homogeneous embankments by S. E. Coleman, D. P. Andrews, and M. G. Webby.” J. Hydraul. Eng., 130(4), 371–376.
Coleman, S. E., Andrews, D. P., and Webby, M. G. (2002). “Overtopping breaching of noncohesive homogeneous embankment.” J. Hydraul. Eng., 128(9), 829–838.
Costabile, P., Macchione, F., and Rinaldi, L. (2004). “Schema monodimensionale per il calcolo dell’erosione di rilevati in materiale sciolto.” Proc., 29th Convegno di Idraulica e Costruzioni Idrauliche, Vol. 1, Editoriale BIOS, Cosenza, Italy, 821–827.
Cunge, J. A., Holly, F. M., Jr., and Verwey, A. (1980). Practical aspects of computational river hydraulics, Pitman Advanced Publishing Program, Boston.
Franca, M. J., and Almeida, A. B. (2004). “A computational model of rockfill dam breaching caused by overtopping (RoDaB).” J. Hydraul. Res., 42(2), 197–206.
Fread, D. L. (1988a). “BREACH: An erosion model for earthen dam failures.” U.S. National Weather Service Report, Silver Spring, Md.
Fread, D. L. (1988b). “The NWS DAMBRK model: Theoretical background/user documentation.” HRL-258, Hydrologic Research Laboratory Report, National Weather Service, Silver Spring, Md.
Fread, D. L. (1989). “National Weather Service models to forecast dam-breach floods.” Hydrology of disasters, Ö. Starosolszky and O. M. Melder, eds., James and James, London, 192–211.
Fread, D. L., and Harbaugh, T. E. (1973). “Transient hydraulic simulation of breached earth dams.” J. Hydr. Div., 99(1), 139–154.
Froehlich, D. C. (1995a). “Embankment dam breach parameters revisited.” Proc., Water Resources Engineering, ASCE, Reston, Va., 887–891.
Froehlich, D. C. (1995b). “Peak outflow from breached embankment dam.” J. Water Resour. Plann. Manage., 121(1), 90–97.
Giuseppetti, G., and Molinaro, P. (1989). “A mathematical model of the erosion of an embankment dam by overtopping.” Proc., Int. Symp. on Analytical Evaluation of Dam Related Safety Problems, ICOLD, Copenhagen, Denmark.
International Commission On Large Dams (ICOLD). (1974). Lessons from dam incidents, CIGB-ICOLD, Paris.
International Commission On Large Dams (ICOLD). (1990). The design flood guidelines, Paris.
Investigation of Extreme Flood Process and Uncertainty (IMPACT). (2005). “WP2 publications—Technical reports.” ⟨http://www.samui.co.uk/impact%2Dproject/wp2_technical.htm⟩ (June 2005).
Jessup, W. E. (1964). “Baldwin Hills Dam failure.” Civ. Eng. (N.Y.), 34(2), 62–64.
Johnson, F. A., and Illes, P. (1976). “A classification of dam failures.” Int. Water Power Dam Constr., 28(12), 43–45.
Macchione, F. (1986). “Sull’idrogramma di piena conseguente alla rottura di dighe in terra.” Memorie e studi (External Memorandum), Dip. di Difesa del Suolo, Univ. della Calabria, Cosenza, Italy, No. 139.
Macchione, F. (1989). “Discussion on ‘Dimensionless analytical solutions for dam breach erosion by V. P. Singh, and C. A. Quiroga’.” J. Hydraul. Res., 27(3), 447–452.
Macchione, F. (1993). “Alluvioni artificiali conseguenti a rotture di dighe.” Fenomeni alluvionali artificiali a valle delle dighe, G. Frega, ed., Quaderni di Idrotecnica—Sezione Calabra dell’Associazione Idrotecnica Italiana, Editoriale BIOS, Cosenza, Italy, 37–82.
Macchione, F. (2000). “Le piene derivanti dall’erosione degli sbarramenti in materiali sciolti.” Sistemazione dei corsi d’acqua, U. Maione, A. Brath, and P. Mignosa, eds., Editoriale BIOS, Cosenza, Italy, 61–89.
Macchione, F., and Rino, A. (2008). “Model for predicting floods due to earthen dam breaching. II: Comparison with other methods and predictive use.” J. Hydraul. Eng. 134(12), 1697–1707.
Macchione, F., and Sirangelo, B. (1989). “Study of earth dam erosion due to overtopping.” Hydrology of disasters, Ö. Starosolszky, and O. M. Melder, eds., James and James, London, 212–219.
MacDonald, T. C., and Langridge-Monopolis, J. (1984). “Breaching characteristics of dam failures.” J. Hydraul. Eng., 110(5), 567–586.
Marone, V. (1971). “Calcolo di massima di un serbatoio di laminazione.” Energ. Elettr., 48(9), 561–567.
Mohamed, M. A. A., Samuels, P. G., Morris, M. W., and Ghataora, G. S. (2002). “Improving the accuracy of prediction of breach formation through embankment dams and flood embankments.” River Flow 2002, Proc., Int. Conf. on Fluvial Hydraulics, Vol. 1, D. Bousmar and Y. Zech, eds., Balkema, Lisse, The Netherlands.
Ponce, V. M., and Tsivoglou, A. J. (1981). “Modeling gradual dam breaches.” J. Hydr. Div., 107(7), 829–838.
Rostvedt, J. O. et al. (1968). “Summary of floods in the United States during 1963.” USGS Water-Supply Paper 1830-B, U.S. Geological Survey, Washington, D.C., B84–B87.
Rozov, A. L. (2003). “Modeling of washout of dams.” J. Hydraul. Res., 41(6), 565–577.
Singh, K. P., and Snorrason, A. (1984). “Sensitivity of outflow peaks and flood stages to the selection of dam breach parameters and simulation models.” J. Hydrol., 68, 295–310.
Singh, V. P. (1996). Dam breach modeling technology, Kluwer Academic, Norwell, Mass.
Singh, V. P., and Quiroga, C. A. (1988). “Dimensionless analytical solution for dam breach erosion.” J. Hydraul. Res., 26(2), 179–197.
Singh, V. P., and Scarlatos, P. D. (1988). “Analysis of gradual earth dam failure.” J. Hydraul. Eng., 114(1), 21–42.
Singh, V. P., and Scarlatos, P. D. (1989). “Breach erosion of earthfill dams and flood routing: BEED model.” Miscellaneous Paper EL-79-6, Military Hydrology Rep., U.S. Army Engineer Waterways Experiment Station, Environmental Laboratory, Vicksburg, Miss.
Tinney, E. R., and Hsu, Y. H. (1961). “Mechanics of washout of an erodible fuse plug.” J. Hydr. Div., 87(HY3), 1–29.
Wahl, T. L. (1998). “Prediction of embankment dam breach parameters—A literature review and needs assessment.” Dam Safety Rep. No. DSO-98-004, U.S. Dept. of the Interior. Bureau of Reclamation, Denver, ⟨http://www.usbr.gov/pmts/hydraulics_lab/twahl/⟩ (Feb. 2005).
Wahl, T. L. (2004). “Uncertainty of predictions of embankment dam breach parameters.” J. Hydraul. Eng., 130(5), 389–397.
Walder, J. S., and O’Connor, J. E. (1997). “Methods for predicting peak discharge of floods caused by failure of natural and constructed earthen dams.” Water Resour. Res., 33(10), 2337–2348.
Information & Authors
Information
Published In
Copyright
© 2008 ASCE.
History
Received: Jun 17, 2004
Accepted: May 19, 2008
Published online: Dec 1, 2008
Published in print: Dec 2008
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.