Turbulent Flow over a Channel with Fluid-Saturated Porous Bed
Publication: Journal of Hydraulic Engineering
Volume 133, Issue 6
Abstract
The characteristics of fully developed turbulent flow in a hybrid domain channel, which consists of a clear fluid region and a porous bed, are examined numerically using a model based on the macroscopic Reynolds-averaged Navier–Stokes equations. By adopting the classical continuity interface conditions, the present model treats the hybrid domain problem with a single domain approach, and the simulated results are noted to coincide with the existing experimental data and microscopic data. The effects of porosity and Darcy number on the flow properties over and inside the porous bed are further investigated in the selected ranges of , and . It has been demonstrated that the presence of the porous bed causes the significant reduction of the flow velocities inside the clear fluid region relative to that of a smooth impermeable bed, and also reduces the magnitude of the integral constant of the velocity logarithmic distributions from its traditional value 5.25. Moreover, turbulent shear stress within the upper part of the porous bed increases significantly with the porosity and Darcy number . The thickness of turbulence penetration remains proportional to the values of porosity and Darcy number .
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The National Science Council, Taiwan, financially supported this study under Grant No. NSC 92-2211-E-006-031. The writers gratefully acknowledge Dr. A. Sau (Cheng-Kung University) for his writing comment. The writers would also like to thank all of the referees for providing their helpful and constructive comments.
References
Alazmi, B., and Vafai, K. (2001). “Analysis of fluid flow and heat transfer interfacial conditions between a porous medium and fluid layer.” Int. J. Heat Mass Transfer, 44(9), 1735–1749.
Antohe, B. V., and Lage, J. L. (1997). “A general two-equation macroscopic turbulence model for incompressible flow in porous media.” Int. J. Heat Mass Transfer, 40(13), 3013–3024.
Chen, X., and Chiew, Y. M. (2004). “Velocity distribution of turbulent open-channel flow with bed suction.” J. Hydraul. Eng., 130(2), 140–148.
Cheng, N.-S., and Chiew, Y. M. (1998). “Modified logarithmic law for velocity distribution subjected to upward seepage.” J. Hydraul. Eng., 124(12), 1235–1241.
Choi, C. Y., and Waller, P. M. (1997). “Momentum transport mechanism for water flow over porous media.” J. Environ. Eng., 123(8), 792–799.
de Lemos, M. J. S., and Pedras, M. H. J. (2000). “Simulation of turbulent flow through hybrid porous medium-clear fluid domains.” Proc., ASME Heat Transfer Division, ASME, Orlando, Fla., Vol. 5, 113–122.
Getachew, D., Minkowycz, W. J., and Lage, J. L. (2000). “A modified form of the model for turbulent flow of an incompressible fluid in porous media.” Int. J. Heat Mass Transfer, 43(16), 2909–2915.
Hsu, C. T., and Cheng, P. (1990). “Thermal dispersion in a porous medium.” Int. J. Heat Mass Transfer, 33(8), 1587–1597.
Huettel, M., Røy, H., Precht, E., and Ehrenhauss, S. (2003). “Hydrodynamical impact on biogeochemical processes in aquatic sediments.” Hydrobiologia, 494(1–3), 231–236.
Kuwahara, F., Kameyama, Y., Yamashita, S., and Nakayama, A. (1998). “Numerical modeling of turbulent flow in porous media using a spatially periodic array.” J. Porous Media, 1(1), 47–55.
Kuznetsov, A. V. (1997). “Influence of the stress jump condition at the porous-medium clear-fluid interface on a flow at a porous wall.” Int. Commun. Heat Mass Transfer, 24(3), 401–417.
Launder, B. E., and Sharma, B. I. (1974). “Application of the energy dissipation model of turbulence to the calculation of flow near a spinning disk.” Lett. Heat Mass Transfer, 1(2), 131–138.
Lee, K., and Howell, J. R. (1987). “Forced convective and radiative transfer within a highly porous layer exposed to a turbulent external flow field.” Proc., ASME-JSME Thermal Engineering Joint Conf., Honolulu, Vol. 2, 377–386.
Masuoka, T., and Takatsu, Y. (1996). “Turbulence model for flow through porous media.” Int. J. Heat Mass Transfer, 39(13), 2803–2809.
McNair, J. N., Newbold, J. D., and Hart, D. D. (1997). “Turbulent transport of suspended particles and dispersing benthic organisms: How long to hit bottom?” J. Theor. Biol., 188(1), 29–52.
Mendoza, C., and Zhou, D. (1992). “Effect of porous bed on turbulent stream flow above bed.” J. Hydraul. Eng., 118(9), 1222–1240.
Nakayama, A., and Kuwahara, F. (1999). “A macroscopic turbulence model for flow in a porous medium.” J. Fluids Eng., 121(2), 427–433.
Nezu, I., and Nakagawa, H. (1993). Turbulence in open channel flow, IAHR Monograph, Balkema, Rotterdam, The Netherlands.
Ochoa-Tapia, J. A., and Whitaker, S. (1995a). “Momentum transfer at the boundary between a porous medium and a homogeneous fluid. I: Theoretical development.” Int. J. Heat Mass Transfer, 38(14), 2635–2646.
Ochoa-Tapia, J. A., and Whitaker, S. (1995b). “Momentum transfer at the boundary between a porous medium and a homogeneous fluid. II: Comparison with experiment.” Int. J. Heat Mass Transfer, 38(14), 2647–2655.
Packman, A. I., Salehin, M., and Zaramella, M. (2004). “Hyporheicexchange with gravel beds: Basic hydrodynamic interactions and bedform-induced advective flows.” J. Hydraul. Eng., 130(7), 647–656.
Patankar, S. V. (1980). Numerical heat transfer and fluid flow, Hemisphere, New York.
Pedras, M. H. J., and de Lemos, M. J. S. (2000). “On the definition of turbulent kinetic energy for flow in porous media.” Int. Commun. Heat Mass Transfer, 27(2), 211–220.
Pedras, M. H. J., and de Lemos, M. J. S. (2001a). “Macroscopic turbulence modeling for incompressible flow through undeformable porous media.” Int. J. Heat Mass Transfer, 44(6), 1081–1093.
Pedras, M. H. J., and de Lemos, M. J. S. (2001b). “On the mathematical description and simulation of turbulent flow in a porous medium formed by an array of elliptic rods.” J. Fluids Eng., 123(4), 941–947.
Pedras, M. H. J., and de Lemos, M. J. S. (2001c). “Simulation of turbulent flow in porous media using a spatially periodic array and a low Re two-equation closure.” Numer. Heat Transfer, Part A, 39(1), 35–59.
Pedras, M. H. J., and de Lemos, M. J. S. (2003). “Computation of turbulent flow in porous media using a low Reynolds k- model and an infinite array of transversally-displaced elliptic rods.” Numer. Heat Transfer, Part A, 43(6), 585–602.
Prinos, P., Sofialidis, D., and Keramaris, E. (2003). “Turbulent flow over and within a porous bed.” J. Hydraul. Eng., 129(9), 720–733.
Shimizu, Y., Tsujimoto, T., and Nakagawa, H. (1990). “Experimental and macroscopic modeling of flow in highly porous medium under free-surface flow.” J. Hydrosci. Hydr. Eng., 8(1), 69–78.
Silva, R. A., and de Lemos, M. J. S. (2003). “Numerical analysis of the stress jump interface condition for laminar flow over a porous layer.” Numer. Heat Transfer, Part A, 43(6), 603–617.
Steinberger, N., and Hondzo, M. (1999). “Diffusional mass transfer at sediment-water interface.” J. Environ. Eng., 125(2), 192–200.
Takatsu, Y., and Masuoka, T. (1998). “Turbulent phenomena in flow through porous media.” J. Porous Media, 1(3), 243–251.
Travkin, V. S., and Catton, I. (1995). “A two temperature model for turbulent flow and heat transfer in a porous layer.” J. Fluids Eng., 117(1), 181–188.
Vafai, K. (1984). “Convective flow and heat transfer in variable-porosity media.” J. Fluid Mech., 147, 233–259.
Vafai, K., and Tien, C. L. (1981). “Boundary and inertia effects on flow and heat transfer in porous media.” Int. J. Heat Mass Transfer, 24(6), 195–203.
Wang, H., and Takle, E. S. (1995). “Boundary-layer flow and turbulence near porous obstacles.” Boundary-Layer Meteorol., 74(1), 73–88.
Zhou, D., and Mendoza, C. (1993). “Flow through porous bed of turbulent stream.” J. Eng. Mech., 119(2), 365–383.
Information & Authors
Information
Published In
Copyright
© 2007 ASCE.
History
Received: Oct 4, 2004
Accepted: Sep 25, 2006
Published online: Jun 1, 2007
Published in print: Jun 2007
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.