Clear-Water Scour at Abutments in Thinly Armored Beds
Publication: Journal of Hydraulic Engineering
Volume 130, Issue 7
Abstract
Experiments on local scour at short abutments (ratio of abutment length to approaching flow depth less than unity), namely vertical-wall, wing-wall, and semicircular, embedded in a bed of relatively fine noncohesive sediment overlain by a thin armor-layer of coarser sediment, were conducted for different flow conditions, thickness of armor-layers, armor-layer, and bed sediments. The abutments were aligned with the approaching flow in a rectangular channel. The armor-layer and the bed underneath it were composed of different combinations of uniform sediments. In the experiments, the approaching flow velocities were restricted to the clear-water scour condition with respect to the armor-layer particles. Depending on the approaching flow conditions, three cases of scour at abutments in armored beds were identified. Effects of different parameters pertaining to scour at abutments are examined. The comparison of the experimental data shows that the scour depth at an abutment with an armor-layer in clear-water scour condition under limiting stability of the surface particles (approaching flow velocity nearly equaling critical velocity for the threshold motion of surface particles) is always greater than that without armor-layer for the same bed sediments. The characteristic parameters affecting the maximum equilibrium nondimensional scour depth (scour depth-abutment length ratio), identified based on the physical reasoning and dimensional analysis, are excess abutment Froude number, flow depth-abutment length ratio, armor-layer thickness-armor particle diameter ratio, and armor particle-bed sediment diameter ratio. The experimental data of clear-water scour condition in thinly armored beds under limiting stability of surface particles were used to determine the equation of maximum equilibrium scour depth through regression analysis. The estimated scour depths were in agreement with the experimental scour depths. Also, an equation of maximum equilibrium scour depth in uniform sediments was obtained.
Get full access to this article
View all available purchase options and get full access to this article.
References
Barbhuiya, A. K. (2003). “Clear-water scour at abutments.” PhD thesis, Department of Civil Engineering, Indian Institute of Technology, Kharagpur, India.
Borah, D. K.(1989). “Scour-depth prediction under armoring conditions.” J. Hydraul. Eng., 115(10), 1421–1425.
Dey, S. (1995). “Three-dimensional vortex flow field around a circular cylinder in a quasi-equilibrium scour hole.” Sadhana: Proc., Indian Acad. Sci., 20(Dec), 771–785.
Dey, S.(1999). “Time variation of scour in the vicinity of circular piers.” Proc. Inst. Civ. Eng., Waters. Maritime Energ., 136(June), 67–75.
Dey, S., Bose, S. K., and Sastry, G. L. N.(1995). “Clear water scour at circular piers: A model.” J. Hydraul. Eng., 121(12), 869–876.
Dey, S., and Debnath, K.(2001). “Sediment pick-up on streamwise sloping beds.” J. Irrig. Drain Eng., 127(1), 39–43.
Dongol, D. M. S. (1994). “Local scour at bridge abutments.” Rep. No. 544, School of Engineering, Univ. of Auckland, Auckland, New Zealand.
Ettema, R. (1980). “Scour at bridge piers.” Rep. No. 216, School of Engineering, Univ. of Auckland, Auckland, New Zealand.
Froehlich, D. C. (1989). “Abutment scour prediction.” Presentation, Transportation Research Board, Washington, DC.
Froehlich, D. C.(1995). “Armor-limited clear-water contraction scour at bridges.” J. Hydraul. Eng., 121(6), 490–493.
Gill, M. A.(1972). “Erosion of sand beds around spur dikes.” J. Hydraul. Div., Am. Soc. Civ. Eng., 98(9), 1587–1602.
Kandasamy, J. K. (1989). “Abutment scour.” Rep. No. 458, School of Engineering, Univ. of Auckland, Auckland, New Zealand.
Kwan, T. F. (1984). “Study of abutment scour.” Rep. No. 328, School of Engineering, Univ. of Auckland, Auckland, New Zealand.
Kwan, T. F. (1989). “A study of abutment scour.” Rep. No. 451, School of Engineering, Univ. of Auckland, Auckland, New Zealand.
Lauchlan, C. S., and Melville, B. W.(2001). “Riprap protection at bridge piers.” J. Hydraul. Eng., 127(5), 412–418.
Lim, S. Y.(1997). “Equilibrium clear-water scour around an abutment.” J. Hydraul. Eng., 123(3), 237–243.
Lim, F. H., and Chiew, Y. M.(2001). “Parametric study of riprap failure around bridge piers.” J. Hydraul. Res., 39(1), 61–72.
Liu, H. K., Chang, F. M., and Skinner, M. M. (1961). “Effect of bridge construction on scour and backwater.” CER 60 HKL 22, Colorado State Univ., Civil Engineering Section, Fort Collins, Colo.
Melville, B. W. (1975). “Scour at bridge sites.” Rep. No. 117, School of Engineering, Univ. of Auckland, Auckland, New Zealand.
Melville, B. W.(1992). “Local scour at bridge abutments.” J. Hydraul. Eng., 118(4), 615–631.
Melville, B. W.(1997). “Pier and abutment scour: Integrated approach.” J. Hydraul. Eng., 123(2), 125–136.
Melville, B. W., and Coleman, S. E. (2000). Bridge scour, Water Resources Publications, Fort Collins, Colo.
Neill, C. R., and Morris, L. R.(1980). “Scour problems at railway bridges on the Thompson River, B.C.” Can. J. Civ. Eng., 7, 357–372.
Oliveto, G., and Hager, W. H.(2002). “Temporal evolution of clear-water pier and abutment scour.” J. Hydraul. Eng., 128(9), 811–820.
Raudkivi, A. J., and Ettema, R.(1983). “Clear water scour at cylindrical piers.” J. Hydraul. Eng., 109(3), 338–350.
Raudkivi, A. J., and Ettema, R.(1985). “Scour at cylindrical bridge piers in armored beds.” J. Hydraul. Eng., 111(4), 713–731.
Richardson, E. V., and Davis, S. R. (2001). “Evaluating scour at bridges.” HEC18 FHWA NHI-001, Federal Highway Administration, U.S. Department of Transportation, Washington, D.C.
Richardson, E. V., Simons, D. B., and Lagasse, P. F. (2001). “River engineering for highway encroachments—highways in the river environment.” HS6 FHWA NHI-01-004, Federal Highway Administration, U.S. Department of Transportation, Washington, D.C.
Tey, C. B. (1984). “Local scour at bridge abutments.” Rep. No. 329, School of Engineering, Univ. of Auckland, Auckland, New Zealand.
Wong, W. H. (1982). “Scour at bridge abutments.” Rep. No. 275, School of Engineering, Univ. of Auckland, Auckland, New Zealand.
Information & Authors
Information
Published In
Copyright
Copyright © 2004 American Society of Civil Engineers.
History
Received: May 20, 2002
Accepted: Feb 2, 2004
Published online: Jun 15, 2004
Published in print: Jul 2004
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.