Distribution of Bed Shear Stress in Rotating Circular Flume
Publication: Journal of Hydraulic Engineering
Volume 130, Issue 4
Abstract
Distributions of bed shear stress across the width of a rotating circular flume with smooth and rough bed surfaces were obtained by measurement and model prediction. Results with flows over smooth beds showed that the flow in the central part may be considered to be two-dimensional and that effects of flow depth over the operating range of the flume are minor for flow depths not exceeding 0.14 m. For rough beds, the bed shear stress distributions were found to be skewed toward the inner wall. This can be corrected if a compensating roughness is added to the bottom of the ring. Such measures are also effective for flumes with smooth beds. Measured bed shear stress distributions agreed well with the predicted distributions for smooth beds and reasonably well for rough beds. The modified Preston tube, for measurement of bed shear stress in flows over rough beds, was found to give promising results. Further tests are required to completely define the uncertainty in bed shear stress measurements made with this instrument.
Get full access to this article
View all available purchase options and get full access to this article.
References
Cebeci, T., and Chang, K. C.(1978). “Calculation of incompressible rough boundary-layer flows.” J. Amer. Inst. Aeronaut. Astronaut., 16(7), 730–735.
Coleman, N. L., and Alonso, C.(1983). “Two dimensional channel flows over rough surfaces.” J. Hydraul. Eng., 109(2), 175–188.
Fukuta, M. K., and Lick, W.(1980). “The entrainment of cohesive sediments in fresh water.” J. Geophys. Res., [Space Phys.] 85(C5), 2813–2824.
Graham, D. I., James, P. W., Jones, T. E. R., Davies, J. M., and Delo, E. A.(1992). “Measurement and prediction of surface shear stress in annular flume.” J. Hydraul. Eng., 118(9), 1270–1286.
Jin, M.(1995). “Boundary shear stress measurements by two tubes.” J. Hydraul. Res., 33(3), 385–395.
Krishnappan, B. G. (1991). “A rotating circular flume for cohesive sediment transport research.” NWRI Contribution No. 91–82, National Water Research Institute, Canada Centre for Inland Waters, Burlington Ont., Canada.
Krishnappan, B. G.(1993). “Rotating circular flume.” J. Hydraul. Eng., 119(6), 758–767.
Krishnappan, B. G., and Engel, P. (1994). “Critical shear stresses for erosion and deposition of fine suspended sediments in the Fraser river.” Proc., 4th Nearshore and Estuarine Cohesive Sediment Conf., INTERCOH ’94, Paper 21, Wallingford, England, 1–9.
Krishnappan, B. G., and Marsalek, J.(2002). “Modeling of flocculation and transport of cohesive sediment from an on-stream stormwater detention pond.” Water Res., 36(15), 3849–3859.
Krone, R. B. (1962). “Flume studies of the transport of sediment in estuarial shoaling processes.” Final Rep., Hydraulic Engineering Laboratory and Sanitary Engineering Research Laboratory, University of California, Berkeley, California.
Kuijper, C., Cornelisse, J. M., and Winterwerp, J. C.(1989). “Research on erosive properties of cohesive sediments.” J. Geophys. Res., [Space Phys.], 94(C10), 14341–14350.
Lick, W.(1982). “Entrainment, deposition, and transport of fine grained sediments in lakes.” Hydrobiologia, 91, 31–40.
Mehta, A. J., and Partheniades, E.(1975). “An investigation of the depositional properties of flocculated fine sediments.” J. Hydraul. Res., 13, 361–381.
Parchure, T. M., and Mehta, A. J.(1985). “Erosion of soft cohesive sediment deposits.” J. Hydraul. Eng., 111(10), 1308–1326.
Partheniades, E., and Kennedy, J. F. (1966). “Depositional behaviour of fine sediment in a turbulent fluid motion.” Proc., 10th Conf. Coastal Engineering, Tokyo, ASCE, Reston, Va., 707–724.
Partheniades, E., Kennedy, J. F., Etter, R. J., and Hoyer, R. P. (1966). “Investigation of the depositional behavior of fine cohesive sediments in an annular rotating channel.” Hydrodynamics Lab. Rep. No. 96, Massachusetts Institute of Technology, Cambridge, Mass.
Patel, V. C.(1965). “Calibration of the Preston tube and limitation on its use in pressure gradients.” J. Fluid Mech., 23(1), 185–208.
Peterson, O., and Krishnappan, B. G.(1994). “Measurement and analysis of flow characteristics in a rotating circular flume.” J. Hydraul. Res., 32(4), 483–494.
Rosten, H. I., and Spalding, D. B. (1984). The PHOENICS reference manual, TR/200, CHAM Ltd., Wimbledon, London.
Rotta, J.(1962). “Turbulent boundary layer in incompressible flow.” Progr. Aerospace Sci., 2, 1–219.
van Driest, E. R.(1956). “On turbulent flow near a wall.” J. Aeronaut. Sci., 23, 1007–1011, 1036.
Zreik, D., Krishnappan, B. G., Germaine, J. T., Madsen, O. S., and Ladd, C. C.(1998). “Erosional and mechanical strengths of deposited cohesive sediments.” J. Hydraul. Res., 124(11), 1076–1085.
Information & Authors
Information
Published In
Copyright
Copyright © 2004 American Society of Civil Engineers.
History
Received: Oct 22, 2002
Accepted: Sep 26, 2003
Published online: Mar 15, 2004
Published in print: Apr 2004
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.