Sediment Removal Efficiency of Vortex Chamber Type Sediment Extractor
Publication: Journal of Hydraulic Engineering
Volume 128, Issue 12
Abstract
Experimental results on sediment removal efficiency of vortex chamber type sediment extractors are reported. A geometric configuration of the extractor is identified that is able to remove even the fine sediment from flow with high efficiency. For the purpose of analysis, the experimental data of present study are compiled with the data from other laboratories and the field that were collected previously by other investigators. Since the existing relations are not found to produce satisfactory results, a new relationship is developed for determination of the sediment removal efficiency of the vortex chamber type sediment extractors.
Get full access to this article
View all available purchase options and get full access to this article.
References
Athar, M. (2000). “Study of vortex chamber type extractor.” PhD thesis, Univ. of Roorkee, Roorkee, India.
Cecen, K., and Akmandor, N. (1973). “Circular settling basins with horizontal floor.” MAG Rep. No. 183, TBTAK, Ankara, India.
Cecen, K., and Bayazit, M. (1975). “Some laboratory studies of sediment controlling structures.” Proc., 9th Congress of ICID, Moscow, Soviet Union, 107–111.
Churi et al. (1977).
Curi, K. V., Esen, I. I., and Velioglu, S. G.(1979). “Vortex type solid liquid separator.” Prog. Water Technol., 7(2), 183–190.
Esen, I. I. (1989). “Solid liquid separation by vortex motion, solid-liquid flow,” 1(1), 21–27, 31005, Toulouse, Cedex, France.
Garde, R. J., and Ranga Raju, K. G. (2000). Mechanics of sediment transportation and alluvial stream problems, 3rd Ed., New Age International, New Delhi, India.
Irrigation and Power Research Institute (IPRI), (1989). “Design norms for vortex settling basin.” Rep. No. HY/R/17/89-90, Amritsar, Punjab, India.
Julien, P. Y. (1986). “Concentration of very fine silts in a steady vortex.” Proc., IAHR, 255–264.
Kothyari, U. C., Pande, P. K., and Gahlot, A. K.(1994). “Design for tunnel-type sediment excluder.” J. Irrig. Drain Eng., 120(1), 36–47.
Leith, D., and Licht, W.(1972). “The collection efficiency of cyclone type particle collectors, a new theoretical approach.” AIChE Symp. Ser., 68(126), 196–206.
Mashauri, D. A. (1981). “Selection of settling basin for sediment removal.” MSc Engineering thesis, Tampere Univ. of Technology, Tampere, Finland.
Mashauri, D. A. (1986). “Modelling of a vortex settling basin for primary clarification of water.” PhD thesis, Tampere Univ. of Technology, Tampere, Finland.
Ogihara, H., and Sakaguchi, S. (1984). “New system to separate the sediments from the water flow by using the rotating flow.” Proc., 4th Congress of the Asian and Pacific Division, IAHR, Chiang Mai, Thailand, 753–766.
Paul, T. C. (1988). “Designing circulation chamber sediment extractor.” Rep. No. OD 91, Hydraulics Research Limited, Wallingford, England.
Paul, T. C., Sayal, S. K., Sakhuja, V. S., and Dhillon, G. S.(1991). “Vortex-settling basin design considerations.” J. Hydraul. Eng., 117(2), 172–189.
Ranga Raju, K. G., Kothyari, U. C., Srivastav, S., and Saxena, M.(1999). “Sediment removal efficiency of settling basins.” J. Irrig. Drain. Eng.,125(5), 308–314.
Salakhov, F. S. (1975). “Rational designs and methods of hydraulic calculations of load-controlling water intake structures for mountain rivers.” Proc., 9th Congress of ICID, Moscow, Soviet Union, 151–161.
Sanmuganthan, K. (1985). “A note on outlet pipe design for circulation chamber silt extractor.” Rep. No. 87, Hydraulic Research Wallingford Limited, Wallingford, England.
Sullivan, R. H., Cohn, M. M., Ure, J. E., Parkinson, F., Galina, G., Boericke, R. R., Kock, C., and Zielinki, P. (1978). “The swirl primary separator; development and pilot demonstration.” Rep. No. EPA-600/2-78-122, U.S. Environmental Protection Agency, Cincinnati.
Svarovsky, L. (1981). Solid–liquid separation, Butterworth and Co. Ltd., Essex, U.K., 162–188.
Velioglu, S. G. (1972). “Vortex type sedimentation tank.” MSc Engineering thesis, Bogasiqi Univ., Turkey.
Vokes, F. C., and Jenkins, S. H. (1943). Experiments with a circular sedimentation tank, JICE, London.
Zhou, Z., Hou, J., and Tang, Yi. (1997). “Flow field measurement of sand funnel and its influence on sediment transport.” Proc., 27th Congress, IAHR, San Fransisco.
Zhou, Z., Wang, C., and Hou, J. (1989). “Model study on flushing cone with strong spiral flow.” Proc., 4th Int. Symposium on River Sedimentation, Beijing, 1213–1219.
Information & Authors
Information
Published In
Copyright
Copyright © 2002 American Society of Civil Engineers.
History
Received: Mar 30, 2001
Accepted: May 30, 2002
Published online: Nov 15, 2002
Published in print: Dec 2002
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.