Efficient Treatment of the Vardy–Brown Unsteady Shear in Pipe Transients
Publication: Journal of Hydraulic Engineering
Volume 128, Issue 1
Abstract
An accurate, simple, and efficient approximation to the Vardy–Brown unsteady friction equation is derived and shown to be easily implemented within a one-dimensional characteristics solution for unsteady pipe flow. For comparison, the exact Vardy–Brown unsteady friction equation is used to model shear stresses in transient turbulent pipe flows and the resulting waterhammer equations are solved by the method of characteristics. The approximate Vardy–Brown model is more computationally efficient (i.e., requires one-sixth the execution time and much less memory storage) than the exact Vardy–Brown model. Both models are compared with measured data from different research groups and with numerical data produced by a two-dimensional turbulence waterhammer model. The results show that the exact Vardy–Brown model and the approximate Vardy–Brown model are in good agreement with both laboratory and numerical experiments over a wide range of Reynolds number and wave frequencies. The proposed approximate model only requires the storage of flow variables from a single time step while the exact Vardy–Brown model requires the storage of flow variables at all previous time steps and the two-dimensional model requires the storage of flow variables at all radial nodes.
Get full access to this article
View all available purchase options and get full access to this article.
References
Axworthy, D. H., Ghidaoui, M. S., and McInnis, D. A.(2000). “Extended thermodynamics derivation of energy dissipation in unsteady pipe flow.” J. Hydraul. Div., Am. Soc. Civ. Eng., 126(4), 276–287.
Bergant, A., and Simpson, A. R. (1994). “Estimating Unsteady Friction in Transient Cavitating Pipe Flow” Proc., 2nd Int. Conf. on Water Pipeline Systems, Edinburgh, UK, 24–26 May 1994, BHRA Group Conf. Series Publ. No. 110, 3–15.
Brunone, B., Golia, U. M., and Greco, M.(1995). “Effects of two-dimensionality of pipe transients modeling.” J. Hydraul. Div., Am. Soc. Civ. Eng., 121(12), 906–912.
Brunone, B., Karney, B., Mecarelli, M., and Ferrante, M.(2000). “Velocity profiles and unsteady pipe friction in transient flow.” J. Water Resour. Plann. Manage. Div., Am. Soc. Civ. Eng. 126(4), 236–244.
Chaudhry, M. H. (1987). Applied hydraulic transients, Van Nostrand Reinhold, New York.
Dailey, J. W., Hankey, W. L., Olive, R. W., and Jordaan, J. M.(1956). “Resistance coefficient for accelerated and decelerated flows through smooth tubes and orifices.” J. Basic Eng., 78, 1071–1077.
Das, D., and Arakeri, J. H.(1998). “Transition of unsteady velocity profiles with reverse flow.” J. Fluid Mech., 374, 251–283.
Greco, M. (1990). “Some recent findings on column separation during water hammer.” Excerpta, G.N.I., Libreria Progetto Ed., Padua, Italy, Vol. 5, 261–272.
Holmboe, E. L., and Roleau, W. T.(1967). “The effect of viscous shear on transients in liquid lines.” J. Basic Eng., 89(1), 174–180.
Jelev, I.(1989). “The damping of flow and pressure oscillation in water hammer analysis.” J. Hydraul. Res., 27(1), 91–114.
Karney, B. W., and McInnis, D. A.(1992). “Efficient calculation of transient flow in simple pipe networks.” J. Hydraul. Div., Am. Soc. Civ. Eng., 118(7), 1014–1030.
Pezzinga, G.(1999). “Quasi-2D Model for unsteady flow in pipe networks.” J. Hydraul. Div., Am. Soc. Civ. Eng., 125(7), 676–685.
Pezzinga, G., and Scandura, P.(1995). “Unsteady flow in installations with polymeric additional pipe.” J. Hydraul. Div., Am. Soc. Civ. Eng., 121(11), 802–811.
Safwat, H. H., and Polder, J.(1973). “Friction-frequency dependence for oscillatory flows in circular pipe.” J. Hydraul. Div., Am. Soc. Civ. Eng., 99(11), 1933–1945.
Shuy, E. B.(1996). “Wall shear stress in accelerating and decelerating turbulent pipe flows.” J. Hydraul. Res., 34(2), 173–183.
Silva-Araya, W. F., and Chaudhry, M. H.(1997). “Computation of energy dissipation in transient flow.” J. Hydraul. Div., Am. Soc. Civ. Eng., 123(2), 108–115.
Suo, L., and Wylie, E. B.(1989). “Impulse response method for frequency-dependent pipeline transients.” J. Fluids Eng., 111(4), 478–483.
Suzuki, K., Taketomi, T., and Sato, S.(1991). “Improving Zielke’s method of simulating frequency-dependent friction in laminar pipe flow.” J. Fluids Eng., 113, 569–573.
Trikha, A. K.(1975). “An efficient method for simulating frequency-dependent friction in transient liquid flow.” J. Fluids Eng., 97(1), 97–105.
Vardy, A. E., and Brown, J.(1995). “Transient, turbulent, smooth pipe friction.” J. Hydraul. Res., 33(4), 435–456.
Vardy, A. E., and Hwang, K. L.(1991). “A characteristic model of transient friction in pipes.” J. Hydraul. Res., 29(5), 669–685.
Vardy, A. E., Hwang, K. L., and Brown, J. M. B.(1993). “A weighting function model of transient turbulent pipe friction.” J. Hydraul. Res., 31(4), 533–548.
Watters, G. Z. (1984). Analysis and control of unsteady flow in pipelines, Butterworth, Boston.
Wylie, E. B., and Streeter, V. L. (1993). Fluid transient in systems, Prentice–Hall, Englewood Cliffs, N.J.
Zeilke, W.(1968). “Frequency-dependent friction in transient pipe flow.” J. Basic Eng., 90(1), 109–115.
Information & Authors
Information
Published In
Copyright
Copyright © 2002 American Society of Civil Engineers.
History
Accepted: Jul 18, 2001
Published online: Jan 1, 2002
Published in print: Jan 2002
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.