Three-Dimensional Numerical Model for Flow through Natural Rivers
Publication: Journal of Hydraulic Engineering
Volume 124, Issue 1
Abstract
This paper presents a three-dimensional numerical model for simulating flow through natural river reaches. The model solves the Reynolds-averaged Navier-Stokes (RANS) equations closed with the standard k-ε turbulence model. Large-scale roughness and multiple islands are directly resolved by employing boundary-fitted curvilinear coordinates in conjunction with a multiblock approach. Small-scale bed roughness is accounted for using a two-point wall-functions approach. Calculations are carried out for flow through a 4-km stretch of the Columbia River, downstream of the Wanapum Dam, for which detailed field and laboratory measurements were collected for a range of power plant operating conditions. Measurements at one operating discharge are employed to calibrate the small-scale roughness distribution in the numerical model. Subsequently, the calibrated model is validated by comparing the computed results with laboratory and field measurements for other discharge combinations. These comparisons demonstrate the ability of the model to capture most experimental trends with remarkable accuracy.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Alfrink, B. J., and van Rijn, L. C.(1983). “Two-equation turbulence model for flow in trenches.”J. Hydr. Engrg., ASCE, 109(7), 941–958.
2.
Almquist, C. W., and Holley, E. R. (1985). “Transverse mixing in meandering laboratory channels with rectangular and naturally varying cross-sections.”Rep. CRWR 205, Center for Research in Water Resources, The University of Texas at Austin, Austin, Tex., 1–223.
3.
Buelow, P. E. O., Venkateswaran, S., and Merkle, C. L.(1994). “Effect of grid aspect ratio on convergence.”AIAA J., 32(12), 2401–2409.
4.
Buratynski, E. K., and Caughy, D. A.(1986). “An implicit LU scheme for the Euler equations applied to arbitrary cascades.”AIAA J., 24(1), 39–46.
5.
Cebeci, T., and Bradshaw, P. (1977). Momentum transfer in boundary layers. Hemisphere Publishing Corp., New York, N.Y.
6.
Chen, H. C., and Patel, V. C.(1988). “Near-wall turbulence models for complex flows including separation.”AIAA J., 26(6), 641–648.
7.
Chorin, A. J.(1968). “Numerical solution of the Navier-Stokes equations.”Mathematics of Computation, 23(4), 341–354.
8.
Cokljat, D., and Younis, B. A.(1995). “Second-order closure study of open-channel flows.”J. Hydr. Engrg., ASCE, 121(2), 94–107.
9.
Demuren, A. O.(1993). “A numerical model for flow in meandering channels with natural bed topography.”Water Resour. Res., 29(4), 1269–1277.
10.
Demuren, A. O., and Rodi, W.(1986). “Calculation of flow and pollutant dispersion in meandering channels.”J. Fluid Mech., Cambridge, U.K., 172(1), 63–92.
11.
ENSR Consulting and Engineering. (1992). “Field studies for siting of fish release facility.” Document No. 6455–006-014, Dec., Kirkland, Wash.
12.
Gibson, M. M., and Rodi, W.(1989). “Simulation of free-surface effects on turbulence with a Reynolds Stress model.”J. Hydr. Res., Delft, The Netherlands, 27, 233–244.
13.
Jameson, A., and Turkel, E.(1981). “Implicit schemes and LU decompositions.”Mathematics of Computation, 37(156), 385–397.
14.
Krishnappan, B. G., and Lau, Y. L.(1986). “Turbulence modeling of flood plain flows.”J. Hydr. Engrg., ASCE, 112(4), 251–266.
15.
Launder, B. E., and Spalding, D. B.(1974). “The numerical computation of turbulent flow.”Computational Methods of Appl. Mech. and Engrg., 3, 269–289.
16.
Leschziner, M. A., and Rodi, W.(1979). “Calculation of strongly curved open channel flow.”J. Hydr. Engrg., ASCE, 105(10), 1297–1314.
17.
Meselhe, E. A., Sotiropoulos, F., and Patel, V. C. (1995). “Three-dimensional numerical model for open-channels.”Proc., Int. Conf. on Hydropower, Hydropower 1995, ASCE, 2100–2120.
18.
Naot, D., and Rodi, W.(1982). “Calculation of secondary currents in channel flow.”J. Hydr. Engrg., ASCE, 108(8), 948–968.
19.
Nikuradse, J. (1950). “Law of flow in rough pipes.”Tech. Memo. NACA-1292, National Advisory Committee for Aeronautics, Washington, D.C., November.
20.
Obayashi, S., and Fujii, K. (1985). “Computation of three-dimensional viscous transonic flows with the LU factored scheme.”AIAA Paper, 85–1510.
21.
Odgaard, A. J., Cherian, M. P., and Elder, R. A.(1987). “Fish diversion in hydropower intake.”J. Hydr. Engrg., ASCE, 113(4), 505–519.
22.
Odgaard, A. J., Elder, R. A., and Weitkamp, D.(1990). “Turbine-intake fish-diversion system.”J. Hydr. Engrg., ASCE, 116(11), 1301–1316.
23.
Olsen, N. R. B., and Stokseth, S.(1995). “Three-dimensional numerical modeling of water flow in a river with large bed roughness.”J. Hydr. Res., Delft, The Netherlands, 33, 571–581.
24.
Pan, D., and Lomax, H.(1988). “A new approximate LU factorization scheme for the Reynolds-averaged Navier-Stokes equations.”AIAA J., 26, 163–171.
25.
Patel, V. C., Chen, H. C., and Ju, S. (1988). “Ship stern and wake flows: Solutions of the fully-elliptic Reynolds-averaged Navier-Stokes equations and comparison with experiments.”Rep. No. 323, Iowa Institute of Hydraulic Research (IIHR), The University of Iowa, Iowa City, Iowa, 1–261.
26.
Prendergast, J.(1991). “Hydropower's balancing act.”Civ. Engrg., ASCE, 61(10), 42–50.
27.
Rastogi, A. and Rodi(1978). “Predictions of heat and mass transfer in open channels.”J. Hydr. Engrg., ASCE, 104(3), 397–420.
28.
Shyy, W., and Vu, T. C.(1991). “On the adoption of velocity variable and grid system for fluid flow computations in curvilinear coordinates.”J. Computational Phys., 52, 82–105.
29.
Sinha, S. K. (1997). “An algebraic grid generation technique for three-dimensional natural river reaches.”Communications in Numerical Methods in Engineering, Vol. 13, John Wiley & Sons, Inc., New York, N.Y., 475–485.
30.
Sinha, S. K. (1996). “Three-dimensional numerical model for turbulent flows through natural rivers of complex bathymetry,” PhD thesis, Dept. of Civ. and Envir. Engrg., The University of Iowa, Iowa City, Iowa, 1–294.
31.
Sinha, S. K., Weber, L. J., and Odgaard, A. J. (1996a). “Hydraulic model studies for fish diversion at Wanapum/Priest Rapids development Part IX: Identification of a fish bypass outfall location for Wanapum Dam tailrace.”Rep. No. 252, Iowa Institute of Hydraulic Research (IIHR), The University of Iowa, Iowa City, Iowa, 1–74.
32.
Sinha, S. K., Sotiropoulos, F., and Odgaard, A. J. (1996b). “Numerical model studies for fish diversion at Wanapum/Priest Rapids development Part I: Three-dimensional numerical model for turbulent flows through Wanapum Dam tailrace reach.”Rep. No. 250, Iowa Institute of Hydraulic Research (IIHR), The University of Iowa, Iowa City, Iowa.
33.
Sinha, S. K., Sotiropoulos, F., and Odgaard, A. J. (1996c). “Three-dimensional numerical model for turbulent flows through natural rivers of complex bathymetry.”Proc., 6th Int. Symp. on Flow Modeling and Turbulence Measurements, Balkema Publishers, Rotterdam, The Netherlands, 573–580.
34.
Sotiropoulos, F., and Abdallah, S.(1991). “The discrete continuity equation in primitive variable solutions of incompressible flow.”J. Computational Phys., 95, 212–227.
35.
Sotiropoulos, F., and Patel, V. C. (1992). “Flow in curved ducts of varying cross-section.”Rep. No. 358, Iowa Institute of Hydraulic Research (IIHR), The University of Iowa, Iowa City, Iowa, 1–194.
36.
Spasojevic, M. (1988). “Numerical simulation of two-dimensional (plan view) unsteady water and sediment movement in natural watercourses,” PhD thesis, Dept. of Civ. and Envir. Engrg., The University of Iowa, Iowa City, Iowa, 1–238.
37.
Temam, R.(1969). “Sur l'approximation de la solution des equations de Navier-Stokes par la methode des pas fractionnaires.”Archive for Rational Mech. and Anal., 32(2), 135–153.
38.
Tingsanchali, T., and Rodi, W. (1986). “Depth average calculation of suspended sediment transport in rivers.”Proc., 3rd Int. Symp. on River Sedimentation, University of Mississippi Press, University, Miss., 1416–1425.
39.
Waldrop, W. R. (1991). “Overview of autoventing turbine technology development project.”Proc., Annu. Nat. Hydr. Engrg. Conf., ASCE, 257–267.
40.
Weitkamp, D. E., and Elder, R. E. (1994). “Recommendations for fish bypass outfall locations at Wanapum Dam.” Parametrix Inc., Washington, D.C., 1–40.
41.
Wenka, T., Valenta, P., and Rodi, W. (1991). “Depth-average calculation of flood flow in a river with irregular geometry.” Proc., XXIV IAHR Congr., Japan Society of Civil Engineers, Tokyo, Japan, A225–A232.
42.
Yoon, J. Y., and Patel, V. C. (1993). “A numerical model of flow in channels with sand-dune beds and ice covers.”Rep. No. 362, Iowa Institute of Hydraulic Research (IIHR), The University of Iowa, Iowa City, Iowa, 1-179.
Information & Authors
Information
Published In
Copyright
Copyright © 1998 American Society of Civil Engineers.
History
Published online: Jan 1, 1998
Published in print: Jan 1998
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.