Physically Based Hydraulic Jump Model for Depth-Averaged Computations
Publication: Journal of Hydraulic Engineering
Volume 122, Issue 10
Abstract
Consideration of momentum conservation within a hydraulic jump leads to the conclusion that both the momentum correction due to the nonuniform mean velocity profile and the depth-averaged turbulent normal stress are important mechanisms. A model is constructed where the turbulent stresses are approximated with a simplified algebraic stress model. These stresses are shown to depend primarily on the vertical gradient of the longitudinal velocity. An estimate for the jump velocity distribution is then obtained from a moment of momentum equation. A single new term in the St. Venant momentum equation, combining the turbulent stress and velocity distribution effects, in terms of the depth and depth-averaged velocity is proposed. The new jump momentum flux term is nonlinear and diffusive in character. With an appropriate calibration of a single coefficient, the model gives good results for the location, length, and profile of hydraulic jumps ranging in Froude numbers from 2 to 7. The numerical results are obtained from a finite-element model with and without numerical dissipation.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Abbott, M. B., Marshall, G., and Rodenhius, G. S. (1969). “Amplitude-dissipative and phase-dissipative scheme for hydraulic jump simulation.”Proc., 13th Congr. IAHR, Int. Assn. for Hydr. Res. (IAHR), Delft, The Netherlands, Vol. 1, 313–329.
2.
ASCE Task Committee on Turbulence Models in Hydraulic Computations.(1988). “Turbulence modeling of surface water flow and transport: Part II.”J. Hydr. Engrg., ASCE, 114(9), 992–1014.
3.
Garcia-Navarro, P., Priestley, A., and Alcrudo, F.(1994). “An implicit method for water flow modeling in channels and pipes.”J. Hydr. Res., 32(5), 721–742.
4.
Gharangik, A. M. (1988). “Numerical simulation of hydraulic jump,” MSc thesis, Washington State Univ., Pullman, Wash.
5.
Gharangik, A. M., and Chaudhry, M. H.(1991). “Numerical simulation of hydraulic jump.”J. Hydr. Engrg., ASCE, 117(9), 1195–1211.
6.
Hager, W. H. (1992). Energy dissipators and hydraulic jump . Kluwer Academic Publishers, Dordrecht, The Netherlands.
7.
Hicks, F. E., and Steffler, P. M.(1992). “Characteristic dissipative Galerkin scheme for open-channel flow.”J. Hydr. Engrg., ASCE, 118(2), 337–352.
8.
Jha, A. K., Akiyama, J., and Ura, M.(1994). “Modeling unsteady open-channel flows—modification to beam and warming scheme.”J. Hydr. Engrg., ASCE, 120(4), 461–476.
9.
Katopodes, N. D.(1984). “A dissipative Galerkin scheme for open-channel flow.”J. Hydr. Engrg., ASCE, 118(2), 337–352.
10.
Khan, A. A., and Steffler, P. M.(1996). “Vertically averaged and moment equations model for flow over curved beds.”J. Hydr. Engrg., ASCE, 122(1), 3–9.
11.
Leutheusser, H. J., and Kartha, V. C.(1972). “Effects of inflow conditions on hydraulic jump.”J. Hydr. Div., ASCE, 98(8), 1367–1385.
12.
Madsen, P. A., and Svendsen, I. A.(1983). “Turbulent bores and hydraulic jumps.”J. Fluid Mech., 129, 1–25.
13.
McCorquodale, J. A., and Khalifa, A.(1983). “Internal flow in hydraulic jumps.”J. Hydr. Engrg., ASCE, 109(5), 684–701.
14.
Narayanan, R.(1975). “Wall jet analogy to hydraulic jump.”J. Hydr. Div., ASCE, 101(3), 347–359.
15.
Resch, F. J., and Leutheusser, H. J.(1972). “Reynolds stress measurements in hydraulic jumps.”J. Hydr. Res., 10(4), 409–429.
16.
Rouse, H., Siao, T. T., and Nagaratnam, S. (1958). “Turbulence characteristics of the hydraulic jump.”J. Hydr. Div., ASCE, 84(1), 1528-1–1528-30.
17.
Steffler, P. M., and Jin, Y.(1993). “Depth averaged and moment equations for moderately shallow free surface flow.”J. Hydr. Res., 31(1), 5–17.
18.
Younus, M., and Chaudhry, M. (1994). “A depth averaged k -ε model for the computation of free surface flow.”J. Hydr. Res., 32(3), 415–444.
Information & Authors
Information
Published In
Copyright
Copyright © 1996 American Society of Civil Engineers.
History
Published online: Oct 1, 1996
Published in print: Oct 1996
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.