Local Scour at Bridge Abutments
Publication: Journal of Hydraulic Engineering
Volume 118, Issue 4
Abstract
Laboratory data for local scour depth at bridge abutments are presented. These include sufficient data to demonstrate the effects on scour depth of abutment length, flow depth, and abutment shape and alignment. In addition, some data for the effects of sediment characteristics, flow intensity, and approach channel geometry are given. The data are rationalized in terms of the ratio of abutment length to flow depth, L/y. Two limiting cases are identified. For large and small values of L/y, the abutments are termed long and short, respectively, and it is shown that the maximum scour depths measured in the laboratory for these cases are 2L and 10 y. Most actual cases of abutment scour lie between the limiting cases, and it is demonstrated that, in such situations, scour depth is proportional to the square root of the product L/y. These relationships are formulated in a simple design method, which is used on some illustrative examples. Limitations to the design method are discussed.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Ahmad, M. (1953). “Experiments on design and behaviour of spur‐dikes.” Proc., Int. Hydr. Convention, ASCE, New York, N.Y.
2.
Baker, R. E. (1986). “Local scour at bridge piers in non‐uniform sediment,” thesis presented to the University of Auckland, at Auckland, New Zealand, in partial fulfillment of the requirements for the degree of Master of Philosophy.
3.
Brice, J. C., Blodgett, J. C. (1978). Countermeasures for hydraulic problems and bridges. Vols. 1 and 2, Federal Highway Administration, U.S. Dept. of Transportation, Washington, D.C.
4.
Chiew, Y. M. (1984). “Local scour at bridge piers,” thesis presented to the University of Auckland, at Auckland, New Zealand, in partial fulfilment of the requirements for the degree of Doctor of Philosophy.
5.
Ettema, R. E. (1980). “Scour at bridge piers,” thesis presented to the University of Auckland, at Auckland, New Zealand, in partial fulfillment of the requirements for degree of Doctor of Philosophy.
6.
Garde, R. J., Subramanya, K., and Nambudripad, K. D. (1961). “Study of scour around spur‐dikes.” J. Hydr. Div., ASCE, 87(6), 23–37.
7.
Gill, M. A. (1972). “Erosion of sand beds around spur‐dikes.” J. Hydr. Div., ASCE, 98(9), 1537–1602.
8.
Kandasamy, J. K. (1985). “Local scour at skewed abutments.” Report No. 375, School of Engineering, University of Auckland, Auckland, New Zealand.
9.
Kandasamy, J. K. (1989). “Abutment scour.” Report No. 458, School of Engineering, University of Auckland, Auckland, New Zealand.
10.
Kandasamy, J. K., and Melville, B. W. (1989). “Bridge damage due to Cyclone Bora.” Report No. 459, School of Engineering, University of Auckland, Auckland, New Zealand.
11.
Kwan, T. F. (1984). “Study of abutment scour.” Report No. 328, School of Engineering, University of Auckland, Auckland, New Zealand.
12.
Kwan, T. F. (1988). “A study of abutment scour.” Report No. 451, School of Engineering, University of Auckland, Auckland, New Zealand.
13.
Laursen, E. M. (1958). “Scour at bridge crossings.” Bull. No. 8, Iowa Highway Research Board, Ames, Iowa.
14.
Laursen, E. M. (1962). “Scour at bridge crossings.” Trans. ASCE, 127(1), 116–179.
15.
Laursen, E. M. (1963). “Analysis of relief bridge scour.” J. Hydr. Div., ASCE, 89(3), 93–118.
16.
Laursen, E. M., and Toch, A. (1956). “Scour around bridge piers and abutments.” Bull. No. 5, Iowa Highways Research Board, Ames, Iowa.
17.
Macky, G. H. (1990). “Survey of roading expenditure due to scour.” C.R. 90.09, Department of Scientific and Industrial Research (DSIR) Hydrology Centre, Christchurch, New Zealand.
18.
Melville, B. W., and Sutherland, A. J. (1988). “Design method for local scour at bridge piers.” J. Hydr. Engrg., ASCE, 114(10), 1210–1226.
19.
Richardson, E. V., Simons, D. B., and Julien, P. Y. (1988). Highways in the river environment. Federal Highway Administration, U.S. Dept. of Transportation, Ft. Collins, Colorado.
20.
Sastry, C. L. N. (1962). “Effect of spur‐dike inclination on scour characteristics,” thesis presented to the University of Roorkee, Roorkee, India, in partial fulfillment of the requirements for the degree of Master of Engineering.
21.
Sutherland, A. J. (1986). “Reports on bridge failure.” R. R. U. Occasional Paper, National Roads Board, Wellington, New Zealand.
22.
Tey, C. B. (1984). “Local scour at bridge abutments.” Report No. 329, School of Engineering, University of Auckland, Auckland, New Zealand.
23.
Wong, W. H. (1982). “Scour at bridge abutments.” Report No. 275, School of Engineering, University of Auckland, Auckland, New Zealand.
24.
Zaghloul, N. A. (1983). “Local scour around spur‐dikes.” J. Hydrol., 60, 123–140.
Information & Authors
Information
Published In
Journal of Hydraulic Engineering
Volume 118 • Issue 4 • April 1992
Pages: 615 - 631
Copyright
Copyright © 1992 ASCE.
History
Published online: Apr 1, 1992
Published in print: Apr 1992
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.