Numerical Modeling of Aggradation and Degradation in Alluvial Channels
Publication: Journal of Hydraulic Engineering
Volume 117, Issue 9
Abstract
The Saint‐Venant equations describing unsteady flow in open channels and the continuity equation for the conservation of sediment mass are numerically solved to determine the aggradation and degradation of channel bottom due to an imbalance between water flow and sediment discharge. For this purpose, the MacCormack explicit finite‐difference scheme is introduced. This scheme is second‐order accurate, handles shocks and discontinuities in the solution without any special treatment, and allows simultaneous solution of the water and sediment equations, thereby obviating the need for iterations. The sediment transport relationship in any form may be included in the computations. Computational procedures are outlined for incorporating the typical boundaries for hydraulic engineering applications. The mathematical model presented here is applied to predict (1) Bed‐level changes due to sediment overloading; (2) development of longitudinal profile due to base‐level lowering; (3) and bed‐level changes associated with the migration of knickpoints. The computed results are compared with the available experimental data obtained on laboratory flumes. The agreement between the computed and experimental results is satisfactory.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Begin, Z. B., Meyer, D. F., and Schumm, S. A. (1981). “Development of longitudinal profiles of alluvial channels in response to base‐level lowering.” Earth Surface Processes and Land Forms, 6(1), 49–68.
2.
Brush, L. M., and Wolman, M. G. (1960). “Knickpoint behavior in noncohesive material: A laboratory study.” Bull. Geological Soc. Am., 71, 59–74.
3.
Chaudhry, M. H. (1987). Applied hydraulic transients. 2nd Ed., Van Nostrand Rein‐hold Co., New York, N.Y.
4.
Cunge, J. A., Holly, F. M., Jr., and Verwey, A. (1980). Practical aspects of computational river hydraulics. Pitman Advanced Publishing Program, London, U.K.
5.
Dawdy, D. R., and Vanoni, V. A. (1986). “Modeling alluvial channels.” Water Resour. Res., 22(9), 71S‐81S.
6.
Fennema, R. J. (1985). “Numerical solution of two‐dimensional free‐surface flows,” thesis presented to Washington State University, at Pullman, Wash., in partial fulfillment of the requirements for the degree of Doctor of Philosophy.
7.
Gill, M. A. (1983a). “Diffusion model for aggrading channels.” J. Hydr. Res., 21(5), 355–367.
8.
Gill, M. A. (1983b). “Diffusion model for degrading channels.” J. Hydr. Res., 21(5), 369–378.
9.
Gill, M. A. (1987). “Nonlinear solution of aggradation and degradation in channels.” J. Hydr. Res., 25(5), 537–547.
10.
Holly, F. M., Jr. (1986). “Numerical simulation in alluvial hydraulics.” 5th Congress of the Asian and Pacific Regional Div., International Association for Hydraulic Research, Aug. 18–21.
11.
Jain, S. C. (1981). “Riverbed aggradation due to overloading.” J. Hydr. Div., ASCE, 107(1), 120–124.
12.
Jain, S. C., and Park, I. (1989). “Guide for estimating riverbed degradation.” J. Hydr. Engrg., ASCE, 115(3), 356–366.
13.
Jameson, A., Schmidt, W., and Turkel, E. (1981). “Numerical solutions of the Euler equations by finite volume methods using Runge‐Kutta time‐stepping schemes.” 14th Fluid and Plasma Dyn. Conf. (Paper AIAA‐81‐1259), American Institute of Aeronautics and Astronautics, Palo Alto, Calif.
14.
Jaramillo, W. F., and Jain, S. C. (1984). “Aggradation and degradation of alluvial‐channel beds.” J. Hydr. Engrg., ASCE, 110(8), 1072–1085.
15.
Lane, E. W., and Borland, W. M. (1954). “River‐bed scour during floods.” Trans., ASCE, 119, 1069–1079.
16.
Lu, J.‐Y., and Shen, H. W. (1986). “Analysis and comparisons of degradation models.” J. Hydr. Engrg., ASCE, 112(4), 281–299.
17.
Lyn, D. A. (1987). “Unsteady sediment transport modeling.” J. Hydr. Engrg., ASCE, 113(1), 1–15.
18.
MacCormack, R. W. (1969). “The effect of viscosity in hypervelocity impact cra‐tering.” Paper 69‐354, Am. Inst. Aeronaut, and Astronaut., Cincinnati, Ohio.
19.
Newton, C. T. (1951). “An experimental investigation of bed degradation in an open channel.” Trans., Boston Soc. Civ. Engrs., 28–60.
20.
Park, I., and Jain, S. C. (1986). “River‐bed profiles with imposed sediment load.” J. Hydr. Engrg., ASCE, 112(4), 267–279.
21.
Roache, P. J. (1972). Computational fluid dynamics. Hermosa Publishers, Albuquerque, N.M.
22.
Soni, J. P., Garde, R. J., and Raju, K. G. R. (1980). “Aggradation in streams due to overloading.” J. Hydr. Div., ASCE, 106(1), 117–132.
23.
Suryanarayana, B. (1969). “Mechanics of degradation and aggradation in a laboratory flume,” thesis presented to Colorado State University, at Ft. Collins, Colo., in partial fulfillment of the requirements for the degree of Doctor of Philosophy.
24.
Zhang, H., and Kahawita, R. (1987). “Nonlinear model for aggradation in alluvial channels.” J. Hydr. Engrg., ASCE, 113(3), 353–369.
Information & Authors
Information
Published In
Copyright
Copyright © 1991 ASCE.
History
Published online: Sep 1, 1991
Published in print: Sep 1991
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.