Vortex‐Settling Basin Design Considerations
Publication: Journal of Hydraulic Engineering
Volume 117, Issue 2
Abstract
The vortex‐settling basin (VSB) is a fluidic device that uses only the vortices of the flow to remove sediment. This is an economical, efficient, and water‐conserving alternative to the other available sediment‐extraction devices. This paper presents guidelines for designing and modeling VSBs. It shows that the circular basin should have diameter equal to five times (as compared with six times stipulated in American practice) the bed width of inlet canal. The distinctive features of the proposed design are formation of free vortex in the outer region and flow in the basin traversing a relatively longer path before reaching the overflow weir. Extraction of sediment smaller than 0.5 mm is optimized when a diaphragm and a deflector are incorporated in the inlet canal and basin, respectively. Diameter of the flushing pipe and the flushing discharge to be adopted for the extraction of different sediment fractions are specified. Formulas suggested for prediction of trapping efficiency are simpler and more reliable than several existing formulas. Experiments indicate 76% utilization of the VSB volume and, therefore, show a better performance compared to standard sediment tanks.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Alquier, M., Delmas, D., and Pellerej, M. (1982). “Improvement of swirl concentrator.” J. Envir. Engrg. Div., ASCE, 108(2), 379–390.
2.
Anwar, H. O. (1967). “Vortices at low head intakes.” Water Power and Dam Constr., 19(11), 445–457.
3.
Anwar, H. O. (1969). “Turbulent flow in a vortex.” J. Hydr. Res., 7(1), 1–29.
4.
Cecen, K. (1977). “Hydraulic criteria of settling basins for water treatment, hydro‐power and irrigation.” Proc. 17th Congress of the Int. Assoc. of Hydr. Res., Baden‐Baden, West Germany, 275–294.
5.
Cecen, K., and Akmandor, N. (1973). “Circular settling basins with horizontal floor.” MAG Report No 183, TETAK, Ankara, Turkey.
6.
Cecen, K., and Bayazit, M. (1975). “Some laboratory studies of sediment controlling structures.” Proc. Ninth Congress of ICID, Moscow, Soviet Union, 107–111.
7.
Chrysostomou, V. (1983). “Vortex‐type settling basin,” thesis presented to the University of Southampton, at Southampton, England, in partial fulfillment of the requirements for the degree of Master of Science.
8.
Hufferd, J. A., Vance, R. L., and Wafkins, J. J. (1975). “Sediment control methods.” Sedimentation engineering, V. A. Vanoni, ed., ASCE, New York, N.Y., 546–587.
9.
Julien, P. Y. (1986). “Concentration of very fine silts in a steady vortex.” J. Hydr. Res., 24(4), 255–264.
10.
Lawrence, P., and Atkinson, E. (1984). “A quantitative design method for tunnel type sediment extractors.” Proc. Fourth Congress of the Asian and Pacific Division, Int. Assoc. of Hydr. Res., Chiang Mai, Thailand, 767–781.
11.
Mashauri, D. A. (1986). “Modelling of a vortex settling basin for primary clarification of water,” thesis presented to the Tampere University of Technology, at Tampere, Finland, in partial fulfillment of the requirements for the degree of Doctor of Technology.
12.
Ogihara, K., and Sakaguchi, S. (1984). “New systems to separate the sediments from the water flow by using the rotating flow.” Proc. Fourth Congress of the Asian and Pacific Division, Int. Assoc. of Hydr. Res., Chiang Mai, Thailand, 753–766.
13.
Paul, T. C. (1983). “Circulation chamber sediment extractor.” Report OD 58, Hydraulics Research Limited, Wallingford, England.
14.
Paul, T. C. (1988a). “Designing circulation chamber sediment extractor.” Report OD 91, Hydraulics Research Limited, Wallingford, England.
15.
Paul, T. C. (1988b). “Augmentation of Bhuri Singh power house, hydraulic design of vortex type desilting tank—A model study.” Report No: HY/R/15/88‐89, Irrig. and Power Res. Inst., Punjab, Amritsar, India.
16.
Paul, T. E., Sakhuja, V. S., and Dhillon, G. S. (1987). “Analytical models for free‐surface air‐core vortex.” Indian J. of Power and River Valley Development, 37(8/9), 161–170.
17.
Rea, Q. (1984). “Secondary currents within the circulation chamber sediment extractor,” thesis presented to the University of Southampton, at Southampton, England, in partial fulfillment of the requirements for the degree of Master of Science.
18.
Salakhov, F. S. (1975). “Rotational designs and methods of hydraulic calculation of load‐controlling water intake structures for mountain rivers.” Proc. of Ninth Congress of the ICID, Moscow, Soviet Union, 151–161.
19.
Sullivan, R. H. (1972). “The swirl concentrator as a combined sewer over‐flow regulatory facility.” Report No: EPA‐R2‐72‐008, U.S. Environmental Protection Agency, Washington, D.C.
Information & Authors
Information
Published In
Journal of Hydraulic Engineering
Volume 117 • Issue 2 • February 1991
Pages: 172 - 189
Copyright
Copyright © 1991 ASCE.
History
Published online: Feb 1, 1991
Published in print: Feb 1991
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.