Sand Reinforced with Shredded Waste Tires
Publication: Journal of Geotechnical Engineering
Volume 122, Issue 9
Abstract
The objective of this study was to investigate the feasibility of using shredded waste tires to reinforce sand. Direct shear tests were conducted on mixtures of dry sand and shredded waste tires. The following factors were studied to evaluate their influence on shear strength: normal stress, sand matrix unit weight, shred content, shred length, and shred orientation. From results of the tests, three significant factors affecting shear strength were identified: normal stress, shred content, and sand matrix unit weight. A model for estimating the strength of reinforced soils was also evaluated to determine its applicability to mixtures of sand and tire shreds. When the model is calibrated using results from one shred content, it may be useful for estimating the friction angle for other shred contents. In all cases, adding shredded tires increased the shear strength of sand, with an apparent friction angle (ϕ′) as large as 67° being obtained. Shred content and sand matrix unit weight were the most significant characteristics of the mixes influencing shear strength. Increasing either of these variables resulted in an increase in ϕ′. Tests were also conducted on specimens consisting of only shredded tires (no sand), and the friction angle obtained was 30°.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Ahmed, I., and Lovell, C. (1993). “Use of rubber tires in highway construction.”Utilization of Waste Mat. in Civ. Engrg. Constr., ASCE, New York, N.Y., 166–181.
2.
Bader, C.(1992). “Where will all the tires go?”Municipal Solid Waste Mgmt., 2(7), 26–34.
3.
Benson, C., and Khire, M.(1994). “Soil reinforcement with strips of reclaimed HDPE.”J. Geotech. Engrg., ASCE, 120(5), 838–855.
4.
Blumenthal, M., and Zelibor, J. (1993). “Scrap tires used in rubber-modified asphalt pavement and civil engineering applications.”Utilization of Waste Mat. in Civ. Engrg. Constr., ASCE, New York, N.Y., 182–201.
5.
Bosscher, P. J., Edil, T. B., and Eldin, N. (1993). “Construction and performance of shredded waste tire test embankment.”Transp. Res. Rec., No. 1345, Transp. Res. Board, Washington, D.C., 44–52.
6.
Box, G., Hunter, W., and Hunter, J. (1978). Statistics for experimenters . Wiley-Interscience, New York, N.Y.
7.
Edil, T., and Bosscher, P. (1992). “Development of engineering criteria for shredded waste tires in highway applications, final report.”Res. Rep. GT-92-9, Wis. Dept. of Transp., Madison, Wis.
8.
Edil, T., and Bosscher, P.(1994). “Engineering properties of waste tire chips and soil mixtures.”Geotech. Testing J., 17(4), 453–464.
9.
Edwards, J.(1992). “Markets first.”Municipal Solid Waste Mgmt., 2(6), 6.
10.
Foose, G. (1993). “Shear strength of sand reinforced with shredded waste tires,” MSc thesis, Dept. of Civ. and Envir. Engrg., Univ. of Wisconsin-Madison, Wis.
11.
Gray, D., and Al-Refeai, T.(1986). “Behavior of fabric-versus fiber-reinforced sand.”J. Geotech. Engrg., ASCE, 112(8), 804–820.
12.
Gray, D., and Ohashi, H.(1983). “Mechanics of fiber reinforcement in sand.”J. Geotech. Engrg., ASCE, 109(3), 335–353.
13.
Hall, T. (1991). “Reuse of shredded tire material for leachate collection systems.”Proc., 14th Annu. Madison Waste Conf., Dept. of Engrg. Prof. Devel., Univ. of Wisconsin, Madison, Wis., 367–376.
14.
“How to `burn rubber' on a gravel road.” (1996). East Washingtonian, (114:31; Jan. 31).
15.
Humphrey, D., and Manion, W. (1992). “Properties of tire chips for lightweight fill.”Grouting, Soil Improvement, and Geosynthetics, Vol. 2, ASCE, New York, N.Y., 1344–1355.
16.
Humphrey, D., Sandford, T., Cribbs, M., and Manion, W. (1993). “Shear strength and compressibility of tire chips for use as retaining wall backfill.”Transp. Res. Rec., No. 1422, Transp. Res. Board, Washington, D.C., 29–35.
17.
Maher, M., and Gray, D.(1990). “Static response of sands reinforced with randomly distributed fibers.”J. Geotech. Engrg., ASCE, 116(11), 1661–1677.
18.
“Markets for scrap tires.” (1991). EPA/530-SW-90-074A, U.S. Envir. Protection Agency, Office of Solid Waste, Washington, D.C.
19.
Park, J., Kim, J., and Edil, T. (1993). “Sorption capacity of shredded waste tires.”Green 93, An Int. Symp. on Geotech. Related to the Envir., A. A. Balkema, Rotterdam, The Netherlands, 341–348.
20.
Read, J., Dodson, T., and Thomas, J. (1991). “Use of shredded tires for lightweight fill.”Rep. No. DTFH-71-90-501-OR-11, Oregon Dept. of Transp., Hwy. Div., Rd. Sec., Salem, Oreg.
21.
“Recycled rubber roads.” (1989). Biocycle, 30(2).
22.
Shewbridge, S., and Sitar, N.(1989). “Deformation characteristics of reinforced sand in direct shear.”J. Geotech. Engrg., ASCE, 115(8), 1134–1147.
23.
“State on recycling edge—despite new laws, plenty of trash still goes to waste.” (1994). Wisconsin State J., Jan. 9, 9A.
24.
Tarricone, P.(1993). “Recycled roads.”Civ. Engrg., ASCE, 63(4), 46–49.
25.
Tatlisoz, N. (1996). “Using tire chips in earthen structures,” MSc thesis, Dept. of Civ. and Envir. Engrg., Univ. of Wisconsin, Madison, Wis.
26.
“Tire fill stabilizes roadway embankment.” (1990). Public Works, 120(11), 68.
27.
Turgeon, C. (1989). “The use of asphalt-rubber products in Minnesota.”Rep. No. 89-06, Minnesota Dept. of Transp., Minneapolis, Minn.
28.
Upton, R., and Machan, G. (1993). “Use of shredded tires for lightweight fill.”Transp. Res. Rec., No. 1422, Transp. Res. Board, Washington, D.C., 36–45.
Information & Authors
Information
Published In
Copyright
Copyright © 1996 American Society of Civil Engineers.
History
Published online: Sep 1, 1996
Published in print: Sep 1996
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.