Shear Strength of Reinforced Geosynthetic Clay Liner
Publication: Journal of Geotechnical Engineering
Volume 122, Issue 4
Abstract
Direct shear tests are conducted to evaluate the internal strength of a reinforced geosynthetic clay liner (GCL) at normal stresses between 3.45 and 69.0 kPa. The polypropylene reinforcement increases the peak internal strength compared to that reported in the literature for unreinforced GCLs; however, the reinforced GCL exhibits a postpeak reduction in strength with displacement due to failure of the reinforcement. Direct shear tests are also conducted to evaluate the interface strength between the reinforced GCL and other geosynthetic materials. Extrusion of bentonite from the GCL into the interfaces is noticed and may reduce the interface strengths. Peak interface strengths between the GCL and a smooth geomembrane or a drainage geocomposite are less than the internal strength at all normal stresses tested. However, the peak interface strength between the GCL and a textured geomembrane is limited by the peak internal strength for normal stresses exceeding 13.8 kPa. Postpeak reductions in strength with displacement occur for this interface at these higher normal stresses due to reinforcement failure.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Byrne, R. J. (1994). “Design issues with strain-softening interfaces in landfill liners.”Proc., Waste Tech '94, San Francisco, Calif.
2.
Casagrande, A., and Wilson, S. D.(1951). “Effect of rate of loading on strength of clays and shales at constant water content.”Geotechnique, 2(3), 251–263.
3.
Daniel, D. E., and Shan, H.-Y. (1991). “Results of direct shear tests on hydrated bentonitic blankets.”Project Report, Geotech. Engrg. Ctr., The Univ. of Texas at Austin, Tex.
4.
Daniel, D. E., Shan, H.-Y., and Anderson, J. D. (1993). “Effects of partial wetting on the performance of the bentonite component of a geosynthetic clay liner.”Proc., Geosynthetics '93, Vancouver, B. C., 1483–1496.
5.
Daniel, D. E. (1993). “Geosynthetic clay liners (GCLs) in landfill covers.”Proc., SWANA Conf., San Jose, Calif.
6.
Daniel, D. E., and Koerner, R. M. (1993). “Technical equivalency assessment of GCLs to CCLs.”Proc., 7th Annu. GRI Seminar, Geosynthetics Res. Inst., Philadelphia, Pa., 255–275.
7.
Duncan, J. M., Byrne, P., Wong, K. S., and Mabry, P. (1978). “Strength, stress-strain and bulk modulus parameters for finite element analyses of stresses and movements in soil masses.”Rep. No. UCB/GT/78-02, Univ. of California, Berkeley, Calif.
8.
Geosynthetic Research Institute. (1991). “Progress report #3—prefabricated bentonite clay (PBC) liner test program.” Drexel Univ., Philadelphia, Pa.
9.
Gilbert, R. B., Long, J. H., and Moses, B. E. (1996). “Analytical model of progressive failure in waste containment systems.”Int. J. for Num. and Anal. Methods in Geomech., in press.
10.
Gleason, M. H. (1993). “Comparative testing of calcium and sodium smectite clays for geotechnical and environmental applications,” MS thesis, Univ. of Texas, Austin, Tex.
11.
Gray, D. H., and Ohashi, H.(1983). “Mechanics of fiber reinforcement in sand.”J. Geotech. Engrg., ASCE, 109(3), 335–353.
12.
“Laboratory testing, contract no. 34-670-S-88-0066, special study no. 2: Claymax.” (1988). Chen-Northern, Inc., Denver, Colo.
13.
Mesri, G., and Olson, R. E.(1970). “Shear strength of montmorillonite.”Geotechnique, 20(3), 261–270.
14.
Scheu, C., JohannBen, K., and Saathoff, F. (1990). “Non-woven bentonite fabrics—a new fibre reinforced mineral liner system.”Geotextiles, geomembranes and related products, D. Hoedt, ed., Balkema, Rotterdam, 467–474.
15.
Shan, H.-Y. (1993). “Stability of final covers placed on slopes containing geosynthetic clay liners,” PhD dissertation, Univ. of Texas, Austin, Tex.
16.
Singh, A., and Mitchell, J. K. (1969). “Creep potential and creep rupture of soils.”Proc., 7th Int. Conf. on Soil Mech. and Found. Engrg., Mexico City, Mexico, 379–384.
17.
“Standard test method for determining the coefficient of friction of soil and geosynthetic or geosynthetic and geosynthetic friction by the direct shear method.” (1992). D 5321, ASTM, Philadelphia, Pa.
18.
“Standard test method for direct shear test of soils under consolidated drained conditions.” (1990) D 3080, ASTM, Philadelphia, Pa.
19.
U.S. Environmental Protection Agency. (1987). “Draft minimum technology guidance for single and double liner systems for landfills and surface impoundments.”EPA/530-SW-87-013, PB87-182291, Office of Solid Waste, Washington, D.C.
20.
U.S. Environmental Protection Agency. (1991). “Solid waste disposal facility criteria.”EPA/OSW-FR-91-004, Office of Solid Waste, Washington, D.C.
Information & Authors
Information
Published In
Copyright
Copyright © 1996 American Society of Civil Engineers.
History
Published online: Apr 1, 1996
Published in print: Apr 1996
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.