Bearing Capacity of Footings over Two-Layer Foundation Soils
This article has a reply.
VIEW THE REPLYThis article has a reply.
VIEW THE REPLYPublication: Journal of Geotechnical Engineering
Volume 121, Issue 5
Abstract
The bearing capacity of strip footings over a two-layer foundation soil is considered. The kinematic approach of limit analysis is used to calculate the average limit pressure under footings. The method is applicable to any combination of parameters of the two layers, but the results are presented only for a specific case when a footing is placed on a layer of granular soil resting on clay. The depth of the collapse mechanism is found to be very much dependent on the strength of the clay. Very weak clay can “attract” the mechanism even at great depths. The results are presented as limit pressures rather than traditional bearing-capacity coefficients. The latter are strongly dependent not only on the internal friction angle of the sand, but also on the thickness of the sand layer, cohesion of the clay, and surcharge pressure. Results are presented in the form of dimensionless charts for different internal friction angles of sand. It was found that linear interpolation within 5° increments is acceptable in the range of φ from 30° to 45°.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Bowles, J. E. (1988). Foundation analysis and design, 4th Ed., McGraw-Hill, New York, N.Y.
2.
Chen, W. F., and Davidson, H. L. (1973). “Bearing capacity determination by limit analysis.”J. Soil Mech. Found. Div., 99(6), 433–449.
3.
Davis, E. H. (1968). “Theories of plasticity and the failure of soil masses.”Soil mechanics: selected topics, I. K. Lee, Ed., Butterworth, London, England, 341–380.
4.
Drescher, A., and Detournay, E.(1993). “Limit load in translational failure mechanisms for associative and non-associative materials.”Géotechnique, London, England, 43(3), 443–456.
5.
Florkiewicz, A.(1989). “Upper bound to bearing capacity of layered soils.”Can. Geotech. J., 26(4), 730–736.
6.
Griffiths, D. V. (1982). “Computation of bearing capacity on layered soil.”Proc., 4th Int. Conf. Num. Meth. Geomech., Z. Eisenstein, Ed., Balkema, Rotterdam, The Netherlands, 163–170.
7.
Hanna, A. M., and Meyerhof, G. G.(1980). “Design charts for ultimate bearing capacity of foundations on sand overlying soft clay.”Can. Geotech. J., 17(2), 300–303.
8.
Hansen, J. B.(1970). “A revised and extended formula for bearing capacity.”Geoteknisk Inst., Bull., 28, 5–11.
9.
Karal, K. (1979). “Energy method for soil stability analysis,” PhD thesis, Norwegian Institute of Technology, Trondheim, Norway.
10.
Meyerhof, G. G.(1974). “Ultimate bearing capacity of footings on sand layer overlying clay.”Can. Geotech. J., 11(2), 223–229.
11.
Meyerhof, G. G., and Hanna, A. M.(1978). “Ultimate bearing capacity of foundations on layered soils under inclined load.”Can. Geotech. J., 15(4), 565–572.
12.
Michalowski, R. L.(1989). “Three-dimensional analysis of locally loaded slopes.”Géotechnique, London, England, 39, 27–38.
13.
Michalowski, R. L.(1993). “Limit analysis of weak layers under embankments.”Soils and Fond., 33(1), 155–168.
14.
Michalowski, R. L., and Shi, L.(1993). “Bearing capacity of nonhomogeneous clay layers under embankments.”J. Geotech. Engrg., ASCE, 119(10), 1657–1669.
15.
Mróz, Z., and Drescher, A.(1969). “Limit plasticity approach to some cases of flow of bulk solids.”J. Eng. Ind., 51(2), 357–364.
16.
Prandtl, L. (1920). “Über die Härte plastischer Körper.”Nachr. Ges. Wissensch, Göttingen, math.-phys. Klasse, 74–85 (in German).
17.
Reddy, A. S., and Srinivasan, R. J.(1967). “Bearing capacity of footings on layered clays.”J. Soil. Mech. Found. Div., ASCE, 93(2), 83–99.
18.
Reissner, H. (1924). “Zum Erddruckproblem.”Proc., First Int. Congr. for Appl. Mech., C. B. Biezeno and J. M. Burgers, Eds., Technische Boekhandel en Drukkerii J. Waltman Jr., The Netherlands, Delft, 295–311.
19.
Salençon, J.(1990). “An introduction to the yield design theory and its applications to soil mechanics.”Eur. J. Mech., Ser. A/Solids, 9(5), 477–500.
20.
Shield, R. T.(1954). “Plastic potential theory and Prandtl bearing capacity solution.”J. Appl. Mech., 21(2), 193–194.
21.
Terzaghi, K. (1943). Theoretical soil mechanics . J. Wiley & Sons, New York, N.Y.
Information & Authors
Information
Published In
Copyright
Copyright © 1995 American Society of Civil Engineers.
History
Published online: May 1, 1995
Published in print: May 1995
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.