Discrete Element Method for Slope Stability Analysis
Publication: Journal of Geotechnical Engineering
Volume 118, Issue 12
Abstract
Limit equilibrium methods for slope stability analysis do not, in general, satisfy the overall equilibrium conditions; they must make assumptions regarding the inclination and location of the interslice forces. An alternative slope analysis based on the discrete element method is presented to avoid these drawbacks. A slope in the present model is treated as comprised of slices that are connected by elastoplastic Winkler springs. By considering the conditions of compatibility, stresses on the mobilized surface can be obtained that are statically admissible and consistent with the material strength. The formulation of the method is presented and followed by a comparison of the method with limit equilibrium methods. Examples are also shown that demonstrate the applicability of the method to the analysis of progressive failure involving local yield and subsequent stress redistribution.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Bishop, A. W. (1955). “The use of slip circle in the stability analysis of slopes.” Geotechnique, 5(1), 7–17.
2.
Bjerrum, L. (1967). “Progressive failure in slopes of overconsolidated plastic clay shales.” J. Soil Mech. Found. Div., ASCE, 93(5), 3–49.
3.
Burland, J. B., Longworth, T. I., and Moore, J. F. A. (1977). “A study of ground movement and progressive failure caused by deep excavation in Oxford clay.” Geotechnique, 27(4), 557–591.
4.
Chang, C. S., and Ma, L. (1990). “Modeling of discrete granulates as micropolar continuum.” J. Engrg. Mech., ASCE, 116(12), 2703–2721.
5.
Chang, C. S., and Misra, A. (1990). “Computer simulation and modelling of mechanical properties of particulates.” J. Comput. Geotechniques, 7(4), 269–287.
6.
Cundall, P. A. (1971). “A computer model for simulating progressive, large‐scale movements in block rock systems.” Proc. Int. Symp. on Rock Fracture, Nancy, France, vol. 1, 8–17.
7.
Duncan, J. M., and Wright, S. G. (1980). “The accuracy of equilibrium methods of slope stability analysis.” Engrg. Geol., Amsterdam, the Netherlands, 16(1/2), 5–17.
8.
Fellinius, W. (1936). “Calculation of the stability of earth dams.” Proc. Second Congress on Large Dams, 4, 445–463.
9.
Fredlund, D. G., and Krahn, J. (1977). “Comparison of slope stability methods of analysis.” Can. Geotech. J., 14(3), 429–439.
10.
Janbu, N. (1954a). “Application of composite slip surfaces for stability analysis.” European Conf. on Stability of Earth Slopes, 3, 43–49.
11.
Janbu, N. (1954b). “Stability analysis of slopes with dimensionless parameters.” Harvard Soil Mechanics Series 46, Harvard Univ., Cambridge, Mass., 8–11.
12.
Janbu, N. (1957). “Earth pressure and bearing capacity by generalized procedure of slices.” Proc. Fourth Int. Conf. Soil Mechanics, 2, 207–212.
13.
Law, K. T., and Lumb, P. (1978). “A limit equilibrium analysis of progressive failure in the stability of slopes.” Can. Geotech. J., 15(1), 113–122.
14.
Leshchinsky, D. (1990). “Slope stability analysis: generalized approach.” J. Geotech. Engrg., ASCE, 116(5), 851–867.
15.
Lo, K. Y., and Lee, C. F. (1973). “Stress analysis and slope stability in strain softening soils.” Geotechnique, 23(1), 1–11.
16.
Lowe, J., and Karafiath, L. (1960). “Stability of earthdams upon drawdown.” Proc. First Pan‐American Conf. on Soil Mechanics and Foundation Engrg., 2, 537–552.
17.
Morgenstern, N. R., and Price, V. E. (1965). “The analysis of the stability of general slip surfaces.” Geotechnique, 15(1), 79–93.
18.
Nash, D. T. F. (1987). “A comprehensive review of limit equilibrium methods of slope stability analysis.” Slope stability, M. G. Anderson and K. S. Richards, ed., John Wiley, New York, N.Y., 11–75.
19.
Shi, G. H. (1988). “Discontinuous deformation analysis: A new numerical model for the static and dynamics of block systems.” PhD thesis, Univ. of California, Berkeley, Calif.
20.
Skempton, A. W., and Brown, J. D. (1961). “A landslide in boulder clay at Selset, Yorkshire.” Geotechnique, 11(4), 280–293.
21.
Skempton, A. W., and Delory, F. A. (1957). “Stability of natural slopes in London clay.” Proc. Fourth Int. Conf. Soil Mechanics, 2, 378–381.
22.
Spencer, E. (1967). “A method of analysis of the stability of embankments assuming parallel interslice forces.” Geotechnique, 17(1), 11–26.
23.
Turnbull, W. J., and Hvorslev, M. L. (1967). “Special problems in slope stability.” J. Soil Mech. Found. Div., ASCE, 93(4), 499–528.
24.
Whitman, R. V., and Bailey, W. A. (1967). “Use of computers for slope stability analysis.” J. Soil Mech. Found. Div., ASCE, 93(4), 475–498.
25.
Wright, S. G., Kulhawy, F. H., and Duncan, J. M. (1973). “Accuracy of equilibrium slope stability analysis.” J. Soil Mech. Found. Div., ASCE, 99(10), 783–791.
Information & Authors
Information
Published In
Copyright
Copyright © 1992 ASCE.
History
Published online: Dec 1, 1992
Published in print: Dec 1992
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.