Level Ground Soil‐Liquefaction Analysis Using in Situ Properties: II
Publication: Journal of Geotechnical Engineering
Volume 114, Issue 7
Abstract
Current methods for level ground soil‐liquefaction analysis involve the use of a stress ratio required to cause liquefaction obtained from laboratory testing of small element samples. Limited field evidence and considerable centrifuge model studies have shown that the soil liquefaction is a boundary value problem. There are numerous computer programs available that treat soil liquefaction as a boundary value problem. However, these analysis procedures do not take into consideration the properties of soil at low effective stresses, and most of the input parameters for these procedures have to be determined from test results of small “undisturbed” samples. These procedures have not been verified extensively. A method is presented for level ground soil‐liquefaction analysis, which is treated as a boundary value problem. This method uses a semiempirical, one‐dimensional, elastoplastic constitutive model and finite difference method to solve the governing differential equation for the prediction of pore pressure generation, dissipation, and settlement characteristics during and after dynamic excitation. A compressibility function incorporating effects at low effective stresses is included in this method, which is verified by centrifuge model tests. This procedure utilizes input properties representative of field conditions determined by a nondestructive electrical method. The proposed method for analyzing the generation and redistribution of pore pressure, therefore, provides a means for predicting liquefaction of level ground sites—a boundary value problem—based on the results of in situ testing.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Arulanandan, K., Arulmoli, K., and Dafalias, Y. F. (1982). “In situ prediction of dynamic pore pressures in sand deposits.” Int. Symp. on Numerical Models in Geomech., Zurich, Switzerland.
2.
Arulanandan, K., Anandarajah, A., and Abghari, A. (1983). “Centrifugal modeling of soil liquefaction susceptibility.” J. Geotech. Engrg. Div., ASCE, 109(3), 281–300.
3.
Arulanandan, K. et al. (1986). “Comparison of the SPT, CPT, shear wave velocity and electrical methods of evaluating earthquake induced liquefaction susceptibility in Ying Kou City during the Haicheng earthquake, People's Republic of China.” Proc. in Situ '86, Specialty Conf., ASCE, Blacksburg, Va., 389–415.
4.
Arulanandan, K., and Muraleetharan, K. K. (1985). “Soil liquefaction—A boundary value problem (a priori prediction of pore pressure generation and dissipation during earthquakes).” Dept. of Civ. Engrg. Report, Univ. of California, Davis, Ca.
5.
Arulanandan, K., and Muraleetharan, K. K. (1988). “Level ground soil liquefaction analysis using in situ properties—Part I.” J. Geotech. Engrg. Div., ASCE, 114(7), 753–770.
6.
Castro, G., et al. (1982). “Liquefaction induced by cyclic loading.” Report to Natl. Sci. Foundation, Geotechnical Engineers, Inc., Winchester, Mass.
7.
Cheney, J. A., and Arulanandan, K. (1975). Discussion of “Fundamentals of liquefaction under cyclic loading.” by Martin, G. R., Finn, W. D. L., and Seed, H. B. Geotech. Engrg. Div., ASCE, 101(12), 423–438.
8.
Cheney, J. A., and Arulanandan, K. (1977). “Stress relaxation in sand and clay.” Constitutive Equations of Soils—Proc. of Specialty Session 9, 9th Int. Conf. on Soil Mech. and Foundation Engrg., Tokyo, Japan, 279–285.
9.
Dean, E. T. R., and Schofield, A. N. (1983). “Two centrifuge model tests: Earthquakes on submerged embankments.” Atti del XV Convegno Nazionale di Geotechnica Spoleto, Geotechnical Association of Italy, Vol. 1, pp. 115–129, 1983.
10.
Heidari, M., and James, R. G., “Centrifugal Modelling of Earthquake Induced Liquefaction in a Column of Sand,” Proceedings of the Conference on Soil Dynamics and Earthquake Engineering, Southampton, England, 1, 271–281.
11.
Ishihara, K. (1981). “Pore water pressure rises during earthquakes.” Proc. Int. Conf. on Recent Advances in Geotech. Engrg. and Soil Mech., III, Univ. of Missouri, Rolla, 1201–1204.
12.
Lambe, P. C. (1981). “Dynamic centrifugal modelling of a horizontal sand stratum,” thesis presented to M.I.T., at Cambridge, Mass., in partial fulfillment of the requirements for the degree of Doctor of Science.
13.
Martin, G. R., Finn, W. D. L., and Seed, H. B. (1975). “Fundamentals of liquefaction under cyclic loading.” J. Geotech. Engrg. Div., ASCE, 101(5), 423–438.
14.
Martin, P. P. (1975). “Non‐linear methods for dynamic analysis of ground response,” thesis presented to the Univ. of California at Berkeley, Calif., in partial fulfillment of the requirements for the degree of Doctor of Philosophy.
15.
Martin, P. P., and Seed, H. B. (1978). “MASH: A computer program for the non‐linear analysis of vertically propagating shear waves in horizontally layered soil deposits.” Earthquake Engrg. Res. Center Report No. UCB/EERC‐78/23, Univ. of California, Berkeley, Calif.
16.
Poulos, S. J., Castro, G., and France, J. W. (1985). “Liquefaction, evaluation procedure.” J. Geotech. Engrg. Div., ASCE, 111(6), 772–792.
17.
Prevost, J. H. (1981). “DYNAFLOW: A non‐linear transient finite element analysis program.” Report 81‐SM‐l, Dept. of Civ. Engrg., Princeton Univ., Princeton, N.J.
18.
Schnabel, P. B., Lysmer, T., and Seed, H. B. (1972). “SHAKE: A computer program for earthquake response analysis of horizontally layered sites.” Earthquake Engrg. Res. Center Report No. UCB/EERC‐72/12, Univ. of California, Berkeley, Calif.
19.
Seed, H. B., and Idriss, I. M. (1970). “Soil moduli and damping factors for dynamic response analysis.” Earthquake Engrg. Res. Center Report No. UCB/EERC‐70/10, Univ. of California, Berkeley, Calif.
20.
Seed, H. B., and Idriss, I. M. (1971). “Simplified procedure for evaluating soil liquefaction potential.” J. Soil Mech. and Found. Engrg. Div., ASCE, 97(9), 1249–1274.
21.
Seed, H. B., Martin, P. P., and Lysmer, J. (1976). “Pore water pressure changes during soil liquefaction.” J. Geotech. Engrg. Div., ASCE, 102(4), 323–346.
22.
Seed, H. B. (1979a). “Soil liquefaction and cyclic mobility evaluation for level ground during earthquakes.” J. Geotech. Engrg. Div., ASCE, 105(2), 201–255.
23.
Seed, H. B. (1979b). “Considerations in the earthquake resistant design of earth and rockfill dams.” Geotechnique, XXIX(3), 215–263.
24.
Seed, H. B., et al. (1985). “Influence of SPT procedures in soil liquefaction resistance evaluations.” J. Geotech. Engrg. Div., ASCE, 111(12), 1425–1445.
25.
Siddharthan, R., and Finn, W. D. L. (1982). “TARA‐2, two‐dimensional non‐linear static and dynamic response analysis.” Tech. Report, Soil Dynamics Group, Univ. of British Columbia, Vancouver, B.C., Canada.
26.
Silver, M. L., and Seed, H. B. (1971a). “Deformation characteristics of sands under cyclic loading.” J. Soil Mech. and Found. Engrg. Div., ASCE, 97(8), 1081–1098.
27.
Silver, M. L., and Seed, H. B. (1971b). “Volume changes in sands during cyclic loading.” J. Soil Mech. and Found. Engrg. Div., ASCE, 97(9), 1171–1182.
28.
Whitman, R. V., Lambe, P. C., and Kutter, B. L. (1981). “Initial results from a stacked‐ring apparatus for simulation of a soil profile.” Proc. Int. Conf. on Recent Advances in Geotech. Engrg. and Soil Dynamics, III, University of Missouri, Rolla, 1105–1110.
29.
Whitman, R. V., Lambe, P. C., and Junichi Akiyama. (1982). “Consolidation during dynamics tests on a centrifuge.” Physical Modeling of Soil Dynamics Problems, Session No. 67, ASCE Natl. Convention, Las Vegas, Nev.
Information & Authors
Information
Published In
Copyright
Copyright © 1988 ASCE.
History
Published online: Jul 1, 1988
Published in print: Jul 1988
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.