Pile‐Group Settlement Using Independent Shaft and Point Loads
Publication: Journal of Geotechnical Engineering
Volume 114, Issue 4
Abstract
A method of predicting pile‐group settlements is presented herein for cases in which the piles are held together by means of a rigid cap. Piles in the group are assumed to be of the same material, length, and diameter. Settlement influence and interaction factors are obtained using a finite element code, modeling the pile as a hollow cylindrical insert in the interior of a homogeneous, linear, elastic, isotropic halfspace. These factors are tabulated and can be used with the results of individual, full‐scale, pile load tests to provide a very effective means of estimating pile‐group settlements. Shaft and point loads are treated independently when applying the method, thus allowing for simulation of implicitly variable shaft and point load ratios during loading. Uniform shaft load distributions are assumed, but other distributions can be considered as well. Few parameters are needed to apply the method, which therefore retains the simplicity of existing elastic methods. A full‐scale, pile‐group load test reported in the literature is analyzed to show the reliability of the proposed method. Results are presented that indicate excellent agreement between predicted and measured values.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Banerjee, P. K. (1969). A contribution to the study of pile foundations, thesis presented to the University of Southampton, at Southampton, England, in partial fulfillment of the requirements for the degree of Doctor of Philosophy.
2.
Banerjee, P. K. (1976). “Analysis of vertical pile groups embedded in nonhomogeneous soil.” Proc. 6th European Conf. Soil Mech., held Vienna, Austria, 345–350.
3.
Bannerjee, P. K., and Davies, T. G. (1977). “Analysis of pile groups embedded in Gibson soil.” Proc. 9th ICOSOMEF, 1, Tokyo, Japan, 381–386.
4.
Briaud, J. L., and Tucker, L. (1984). “Piles in Sand: A method including residual stresses.” J. Geotech. Engrg., ASCE, 110(11), 1666–1680.
5.
Butterfield, R., and Bannerjee, P. K. (1971). “The elastic analysis of compressible piles and pile groups.” Geotech., 21(1), 135–142.
6.
Cooke, R. W., and Price, G. (1973). “Strains and displacements around friction piles.” Bldg. Res. Est. Current Paper 28173, Garston, England.
7.
Coyle, H. M., and Reese, L. C. (1966). “Load transfer for axially loaded piles in clay.” JSMFD/ASCE, 92(2), 1–26.
8.
Ellison, R. D., D'Appolonia, E., and Thiers, G. (1971). “Load‐deformation mechanism for bored piles.” JSMFD/ASCE, 97(4), 661–678.
9.
Focht, J. A., and Koch, K. J. (1973). “Rational analysis of the lateral performance of offshore pile groups.” Preprint, 5th Offshore Tech. Conf., Paper No. OTC 1896.
10.
Holloway, D. M., Clough, G. W., and Vesic, A. S. (1975). “Mechanics of pile‐soil interaction in cohesionless soil.” Contract Report S‐75‐5, U.S. Army Wtrways. Exper. Sta., Vicksburg, Miss.
11.
Kezdi, A. (1957). “The bearing capacity of piles and pile groups.” Proc. 4th ICOSOMEF, II, London, England, 46–51.
12.
Mahar, L. J., and Ingram, W. B. (1979). “Geotechnical investigation for a field study of pile group action.” Interim Report for Federal Highway Admin., Fugro Gulf, Inc., Houston, Tex., 280 pp.
13.
Mattes, N. S. (1969). “Correspondence on the influence of radial displacement compatibility on pile settlements.” Geotech., 19(1), 157–159.
14.
Mattes, N. S., and Poulos, H. G. (1969). “Settlement of single compressible pile.” JSMFD/ASCE, 95(1), 189–207.
15.
Meyerhof, G. G. (1960). “Compaction of sands and bearing capacity of piles.” JSMFD/ASCE, 85(6), 1–29.
16.
Mindlin, R. D. (1936). “Force at a point in the interior of a semi‐infinite solid.” Physics, 7, 195–202.
17.
Ottaviani, M. (1975). “Three‐dimensional finite element analysis of vertically loaded pile groups.” Geotech., 25(2), 159–174.
18.
O'Neill, M. W., Ghazzaly, O. I., and Ha, H. B. (1977). “Analyses of three‐dimensional pile groups with non‐linear soil response and pile‐soil‐pile interaction.” Proc. 9th Annual Offshore Tech. Conf., Paper No. OTC 2838.
19.
Polo, J. M. (1982). Analysis of settlements of pile groups, thesis presented to Duke University, at Durham, N.C., in partial fulfillment of the requirements for the degree of Doctor of Philosophy.
20.
Poulos, H. G. (1968). “Analysis of the settlement of pile groups.” Geotech., 18(4), 449–471.
21.
Poulos, H. G. (1972). “Load‐settlement prediction for piles and piers.” JSMFD/ASCE, 98(9), 879–897.
22.
Poulos, H. G. (1979). “Settlement of single piles in non‐homogeneous soil.” J. Geotech. Engrg. Div., ASCE, 105(5), 627–641.
23.
Poulos, H. G., and Davis, E. H. (1968). “The settlement of single axially loaded incompressible piles and piers.” Geotech., 18(3), 351–371.
24.
Poulos, H. G., and Davis, E. H. (1980). Pile foundation analysis and design, John Wiley & Sons, Inc., New York, N.Y.
25.
Poulos, H. G., and Mattes, N. S. (1969). “The behavior of axially‐loaded endbearing piles.” Geotech., 19, 285–300.
26.
Poulos, H. G., and Mattes, N. S. (1971). “Settlement and load distribution analysis of pile groups.” Australian Geomech. J., 1(1), 18–28.
27.
Poulos, H. G., and Mattes, N. S. (1972). “Displacements in a soil mass due to pile groups.” Australian Geomech. J., 2(1), 29–35.
28.
Poulos, H. G., and Mattes, N. S. (1974). “Settlement of pile groups bearing on stiffer strata.” J. Geotech. Engrg. Div., ASCE, 100(2), 185–190.
29.
Randolph, M. F., and Wroth, C. P. (1978). “An analysis of the deformation of vertically loaded piles.” J. Geotech. Engrg. Div., ASCE, 104(12), 1465–1488.
30.
Randolph, M. F., and Wroth, C. P. (1979). “An analysis of the vertical deformation of pile groups.” Geotech., 29(4), 423–439.
31.
Reese, L. C. (1964). “Load versus settlement for an axially loaded pile.” Proc., Symp. Bearing Capacity Piles, Part 2, Central Bldg. Res. Inst., Roorkee, India, 18–38.
32.
Reese, L. C., Hudson, W. R., and Viayvergiya, V. N. (1969). “An investigation of the interaction between bored piles and soil.” Proc. 7th ICOSOMEF, 2, Mexico City, Mexico, 211–215.
33.
Seed, H. G., and Reese, L. C. (1957). “The action of soft clay along friction piles.” Trans., ASCE, 122, 731–754.
34.
Skempton, A. W. (1953). “Discussion: Piles and pile foundations, settlement of pile foundations.” Proc., 3rd ICOSOMEF, 3, held at Zurich, Switzerland, 172.
35.
Terzaghi, K., and Peck, R. B. (1948). Soil mechanics in engineering practice. John Wiley & Sons, New York, N.Y.
36.
Utku, S. (1971). ELAS75 computer program for linear equilibrium problems of linear structures, user's manual. Duke University, School of Engrg., Struct. Mech. Series No. 10, Durham, N.C.
37.
Vesic, A. S. (1965). “Ultimate loads and settlements of deep foundations in sands.” Proc., Symp. Bearing Capacity Settlement Found., Duke Univ., Durham, N.C., 53–68.
38.
Vesic, A. S. (1967). A study of bearing capacity of deep foundations. Final Report, Project B‐189, Georgia Inst. Tech., Atlanta, Ga., 231–236.
39.
Vesic, A. S. (1970). “Tests on instrumented piles, Ogeechee River site.” JSMFD/ASCE, 96(2), 561–584.
40.
Vesic, A. S. (1973). “On penetration resistance and bearing capacity of piles in sand.” Discussion, Session 3, Proc. 8th ICOSOMEF, 4, Moscow, U.S.S.R., 78–81.
41.
Vesic, A. S. (1977). “Design of pile foundations.” Natl. Cooperative Highway Res. Prog., NRC/TRB, 42, Washington, D.C.
42.
Vesic, A. S. (1980). “Predicted behavior of piles and pile group at the Houston site.” Proc. Pile group Prediction Symp., Univ. of Maryland, College Park, Md.
43.
Whitaker, T., and Cooke, R. W. (1966). “An investigation of the shaft and base resistances of large bored piles.” Proc. Symp. Large Bored Piles, Institution of Civil Engineers, London, England, 1–49.
Information & Authors
Information
Published In
Copyright
Copyright © 1988 ASCE.
History
Published online: Apr 1, 1988
Published in print: Apr 1988
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.