Wave Attenuation over a Rigid Porous Medium on a Sandy Seabed
Publication: Journal of Engineering Mechanics
Volume 135, Issue 11
Abstract
In this study, an analytic solution of wave interaction with a rigid porous medium above a poro-elastic sandy bottom is derived to investigate the attenuation of the surface wave and the wave-induced soil response. In the model, both inertial and damping effects of the flow are considered in the rigid porous region using the potential theory, while the consolidation theory is adopted in the sand region. A new complex dispersion relation involving parameters of the rigid porous and the poro-elastic medium is obtained. The analytic solutions are verified by some special cases, such as wave interaction with a porous structure over an impermeable bottom or wave interaction with a poro-elastic medium only. Numerical results indicate that the wave attenuation is highly dependent upon the thickness of the rigid porous layer, the soil stiffness, and their respective coefficients of permeability. Increasing the thickness of the rigid porous layer will shorten the wavelength of the surface wave regardless of the sand coarseness. The pore pressure in fine-sand is larger than in coarse sand, with both decaying with wave progression. It is also found that increasing the thickness of the rigid porous medium will effectively reduce the pore pressure in the sand. For the applications, an extended hyperbolic mild-slope equation is finally obtained, based on the basic analytic solutions. Examples of the wave height transformation over submerged permeable breakwaters on a slope sandy seabed are given. The simulated results show that the wave decay of the coarse sand seabed is larger than those of fine-sand and impermeable seabeds when waves pass after the submerged porous breakwater. The wave damping versus the friction factor for various height of the submerged breakwater is discussed.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The writers are grateful to National Science Council of Taiwan, for supporting this study under Grant No. NSCTNSC 95-2221-E-005–154.
References
Bear, J., and Verruijt, A. (1987). Modeling groundwater flow and pollution, Reidel, Dordrecht, The Netherlands.
Biot, M. A. (1941). “General theory of three dimensional consolidation.” J. Appl. Phys., 12, 155–164.
Copeland, G. J. M. (1985). “A practical alternative to the mild-slope wave equation.” Coastal Eng., 9, 125–149.
Gu, Z., and Wang, H. (1991). “Gravity waves over porous bottoms.” Coastal Eng., 15, 497–524.
Hsu, J. R. C., Jeng, D. S., and Tsai, C. P. (1993). “Short-crested wave-induced soil response in a porous seabed of infinite thickness.” Int. J. Numer. Analyt. Meth. Geomech., 17(8), 553–576.
Jeng, D. S. (2000). “On calculating the length of a short-crested wave over a porous seabed.” Appl. Ocean. Res., 22(2), 63–73.
Liu, P. L. F., Lin, P., Chang, K. A., and Sakakiyama, T. (1999). “Numerical modeling of wave interaction with porous structures.” J. Waterway, Port, Coastal, Ocean Eng., 125(6), 322–330.
Madsen, O. S. (1974). “Wave transmission through porous structures.” J. Wtrwy., Harb. and Coast. Engrg. Div., 100, 169–188.
Madsen, O. S. (1978). “Wave-induced pore pressures and effective stresses in a porous bed.” Geotechnique, 28(4), 377–393.
Mase, H., Sakai, T., and Sakamoto, M. (1994). “Wave-induced porewater pressures and effective stresses around breakwater.” Ocean Eng., 21, 361–379.
Mostafa, A. M., Mizutani, N., and Iwata, K. (1999). “Nonlinear wave, composite breakwater, and seabed dynamic interaction.” J. Waterway, Port, Coastal, Ocean Eng., 125(2), 88–97.
Mynett, A. E., and Mei, C. C. (1982). “Wave-induced stresses in a saturated poro-elastic sea bed beneath a rectangular caisson.” Geotechnique, 32(3), 235–247.
Rojanakamthorn, S., Isobe, M., and Watanabe, A. (1989). “A mathematical model of wave transformation over a submerged breakwater.” Coast. Eng. Japan, 31, 209–234.
Sollitt, C. K., and Cross, R. H. (1972). “Wave transmission through permeable breakwaters.” Proc., 13th Int. Conf. Coastal Eng., ASCE, Reston, Va., 1837–1846.
Tsai, C. P., and Chen, H. B. (2002). “Wave transformation over sloping poro-elastic beach.” Proc., 24th Ocean Eng. Conf. in Taiwan, Taiwan Society of Ocean Engineering, Taiwan, 641–647.
Tsai, C. P., Chen, H. B., and Hsu, J. R. C. (2001). “Calculation of wave transformation across the surf zone.” Ocean Eng., 28, 941–955.
Tsai, C. P., Chen, H. B., and Lee, F. C. (2006). “Wave transformation over submerged permeable breakwater on porous bottom.” Ocean Eng., 33(11–12), 1623–1643.
Watanabe, A., and Maruyama, K. (1986). “Numerical modeling of nearshore wave field under combined refraction, diffraction and breaking.” Coast. Eng. Japan, 29, 19–39.
Yamamoto, T., Koning, H. L., Sellmeiher, H., and Van Hijum, E. V. (1978). “On the response of a poro-elastic bed to water waves.” J. Fluid Mech., 87, 193–206.
Information & Authors
Information
Published In
Copyright
© 2009 ASCE.
History
Received: Apr 3, 2007
Accepted: Jun 19, 2009
Published online: Oct 15, 2009
Published in print: Nov 2009
Notes
Note. Associate Editor: Dinesh R. Katti
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.