New Approach to Strain Rate Sensitivity of Concrete in Compression
Publication: Journal of Engineering Mechanics
Volume 125, Issue 12
Abstract
A constitutive law to model the strain-rate-dependent compression behavior of concrete is proposed. It is derived from a mechanical model, where inertia effects influence damage formation. To verify this model an experimental method based on the split Hopkinson bar (SHB) technique is described, one that considers the special properties of concrete specimens. Compressive stress waves with varying peak values and durations were realized using an extended SHB device. Dynamic stress-strain relations—which differ considerably from the corresponding static relations—are derived for the investigated load histories and are modeled with the proposed dynamic constitutive law. While a number of compression load histories are sustained by the specimens, others result in failure. So a dynamic failure criterion is established, connecting failure occurrence, peak stress, and the time to reach the peak stress.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Abrams, D. A. (1917). “Effect of rate of application of load on the compressive strength of concrete.” Proc., 20th Annu. Meeting, ASTM, West Conshohocken, Pa., Vol. 17, Part II, 366–374.
2.
Albertini, C., and Montagnani, M. ( 1974). “Testing techniques based on the split Hopkinson bar.” Mechanical properties at high rates of strain, The Institute of Physics, London, 22–32.
3.
Bachmann, H. (1993). “Die Massenträgheit in einem Pseudo-Stoffgesetz für Beton bei schneller Zugbeanspruchung.” Tech. Rep. No. 19, Inst. für Massivbau und Baustofftechnologie, Universität Karlsruhe, Karlsruhe, Germany.
4.
Bertholf, L. D., and Karnes, J. (1975). “Two-dimensional analysis of the split Hopkinson pressure bar experiment.” Mech. Phys. Solids, 23(1), 1–19.
5.
Bischoff, P. H. ( 1988). “Compressive response of concrete to hard impact,” PhD thesis, Dept. of Civil Engineering, Imperial College of Science and Technology, London.
6.
Curbach, M. (1987). “Festigkeitssteigerung von Beton bei hohen Belastungsgeschwindigkeiten.” Tech. Rep. No. 1, Inst. für Massivbau and Baustofftechnologie, Universität Karlsruhe, Karlsruhe, Germany.
7.
Eibl, J. (1996). “Ein neuer Ansatz für ein Stoffgesetz zur Berücksichtigung grosser Dehngeschwindigkeiten bei zugbeanspruchtem Beton.” Tech. Rep. BMI 9/96, Inst. für Baustofflehre und Materialprüfung, Universität Innsbruck, Innsbruck, Austria.
8.
Eibl, J., and Curbach, M. (1989). “An attempt to explain strength increase due to high loading rates.” Nuclear Engrg. and Des., 112, 45–50.
9.
Eibl, J., and Schmidt-Hurtienne, B. (1998). “Stress history versus strain history.” Computat. Modelling of Concrete Stuct., Proc., EURO-C 1998 Conf., Balkema, Rotterdam, The Netherlands.
10.
Eibl, J., and Schmidt-Hurtienne, B. (1999). “Strain rate sensitive constitutive law for concrete.”J. Engrg. Mech., ASCE, 125(12), 141–142.
11.
Hopkinson, B. (1914). “A method of measuring the pressure produced in the detonation of high explosives or by the impact of bullets.” Philosophical Trans., Royal Soc. of London, Series A, 213(10), 437–456.
12.
Kolsky, H. (1949). “An investigation of the mechanical properties of materials at very high rates of loading.” Proc., Physical Society, Section B, 62, 676–700.
13.
Malvern, L. E., Tang, T., Jenkins, D. A., and Gong, J. C. (1985). “Dynamic compressive strength of cementitious materials.” MRS Symp. Cement-Based Composites: Strain Rate Effects on Fracture, Boston, 119–138.
14.
Reinhardt, H. W., Körmeling, H. A., and Zielinski, A. J. (1986). “The split Hopkinson bar, a versatile tool for the impact testing of concrete.” Mat. and Struct., 19, 55–63.
15.
Ross, C. A., Thompson, P. Y., and Tedesco, J. W. (1989). “Split-Hopkinson pressure-bar tests on concrete and mortar in tension and compression.” ACI Mat. J., 86, 475–481.
16.
Tang, T., Malvern, L. E., and Jenkins, D. A. (1992). “Rate effects in uniaxial dynamic compression of concrete.”J. Engrg. Mech., ASCE, 118, 108–123.
17.
Zhao, H., and Gary, G. (1996). “On the use of SHBP techniques to determine the dynamic behavior of materials in the range of small strains.” Int. J. Solids Struct., 33(23), 3363–3375.
18.
Zheng, S. (1996). “Beton bei variierender Dehngeschwindigkeit untersucht mit einer neuen modifizierten Split-Hopkinson-Bar-Technik.” Tech. Rep. No. 27, Inst. für Massivbau and Baustofftechnologie, Universität Karlsruhe, Karlsruhe, Germany.
Information & Authors
Information
Published In
History
Received: Jan 14, 1998
Published online: Dec 1, 1999
Published in print: Dec 1999
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.