Frequency-Dependent Stress Wave Attenuation in Cement-Based Materials
Publication: Journal of Engineering Mechanics
Volume 121, Issue 6
Abstract
Ultrasonic techniques are a widely used, reliable form of nondestructive testing of materials. The nature of concrete as a heterogeneous mixture makes it somewhat ill-suited as a conductor of stress waves, and therefore makes the interpretation of ultrasonic data difficult. In order to quantify the attenuation of ultrasonic waves in concrete, a point source/point receiver (PS/PR) ultrasonic test system was set up, and the individual components were evaluated. PS/PR can be used to quantify (among other things) the ultrasonic attenuation in the materials. The technique was applied to a series of four portland-cement-based test specimens. These specimens ranged from a fine cement paste to concrete sample with a maximum aggregate size of 10 mm. The frequency-dependent attenuation was evaluated for each specimen. The results of this investigation showed that the wave-propagation characteristics of the materials can be quantified with this technique, and that certain characteristics of the attenuation curves can be linked to the degree of inhomogeneity in the material.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Aki, K., and Richards, P. G. (1980). “Chapter 4.”Quantitative seismology: theory and methods. W. H. Freeman and Co., New York, N.Y.
2.
“ASTM E1106-86; standard method for primary calibration of acoustic emission sensors.” (1986). Annual book of ASTM standards, Vol. 03.03, ASTM, Philadelphia, Pa., 949–969.
3.
Breckenridge, F. R., Proctor, T. M., Hsu, N. N., Fick, S. E., and Eitzen, D. G. (1990). “Transient sources for acoustic emission work.”Progress in acoustic emission V, K. Yamaguchi, H. Takahashi, and H. Niitsuma, eds., The Japanese Society for NDI, Tokyo, Japan, 20–37.
4.
Ceranoglu, A. N., and Pao, Y. H. (1981). “Propagation of elastic pulses and acoustic emission in a plate. Part I: theory; part II: epicentral response; part III: general response.”J. Appl. Mech., Vol. 48, 125–147.
5.
Enoki, M., and Kishi, T. (1988). “Theory and analysis of deformation moment tensor due to microcracking.”Int. J. Fracture, Vol. 38, 295–310.
6.
Generazio, E. R., Roth, D. J., and Baaklini, G. Y.(1988). “Acoustic imaging of subtle porosity variations in ceramics.”Mat. Evaluation, 46(10), 1338–1343.
7.
Handbook on NDT of concrete. (1991). V. M. Malhotra, and N. J. Carino, eds., CRC Press.
8.
Hsu, N. N., Simmons, J. A., and Hardy, S. C. (1977). “An approach to acoustic emission signal analysis.”Mat. Evaluation, Vol. 35, 100–106.
9.
Hsu, N. N. (1985). “Dynamic Green's functions of an infinite plate—a computer program.”Rep. NBSIR 85-3234, National Bureau of Standards, Gaithersburg, Md.
10.
Kim, Y. K., and Sachse, W. (1986). “Characteristic of an acoustic emission source from a thermal crack in glass.”Int. J. Fracture, Vol. 31, 211–231.
11.
Landis, E. N. (1993). “A quantitative acoustic emission investigation of microcracking in cement-based materials,” PhD dissertation, Northwestern Univ., Evanston, Ill.
12.
Michaels, J. E., Michaels, T. E., and Sachse, W. (1981). “Applications of deconvolution to acoustic emission signal analysis.”Mat. Evaluation, Vol. 39, 1032–1036.
13.
Proc., Int. Conf. on Nondestructive Testing of Concrete in the Infrastructure. (1993). R. A. Miller, S. E. Swartz, and S. P. Shah, eds., Soc. for Experimental Mech., Dearborn, Mich.
14.
Proc., Nondestructive Evaluation of Civ. Struct. and Mat. (1992). B. A. Suprenant, J. L. Noland, and M. P. Schuller, eds., Boulder, Colo.
15.
Proctor, T. M.(1982). “An improved piezoelectric acoustic emission transducer.”J. Acoustical Soc. Am., 71(3), 1163–1168.
16.
Sachse, W., and Kim, K. Y. (1986). “Point source/point receiver materials testing.”Review of progress in quantitative nondestructive evaluation, 6A, D. O. Thompson and D. E. Chimenti, eds., Plenum Press, New York, N.Y., 311–320.
17.
Scruby, C. B., Baldwin, G. R., and Stacy, K. A. (1985). “Characterization of fatigue crack extension by quantitative acoustic emission.”Int. J. Fracture, Vol. 28, 201–222.
18.
Simmons, J. A.(1991). “Deconvolution of acoustic emission and other causal time series.”J. Res. of the Nat. Inst. of Standards and Technol., 96(3), 345–369.
19.
Whitcomb, R. W., Jacobs, L., and Aref, L. (1993). “Quantitative ultrasonic evaluation of concrete.”Proc., Int. Conf. on Nondestructive Testing of Concrete in the Infrastructure., R. A. Miller, S. E. Swartz, and S. P. Shah, eds., Soc. for Experimental Mech., Dearborn, Mich., 238–255.
Information & Authors
Information
Published In
Copyright
Copyright © 1995 American Society of Civil Engineers.
History
Published online: Jun 1, 1995
Published in print: Jun 1995
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.