Identification of Stiffness Reductions Using Natural Frequencies
This article has a reply.
VIEW THE REPLYThis article has a reply.
VIEW THE REPLYPublication: Journal of Engineering Mechanics
Volume 121, Issue 10
Abstract
A technique is presented for the identification of localized reductions in the stiffness of a structure using natural frequency measurements. The sensitivities of the eigenvalues to localized changes in the stiffness have been developed as a set of underdetermined equations. These equations have been used as the constraints in an optimization problem, which minimizes one of three criteria: (1) the changes in the element stiffnesses; (2) the norm of the changes to the global stiffness matrix; or (3) the residuals of the eigenvalue problem. An additional constraint, which forces the stiffness to always decrease due to damage, places the optimization problem in the realm of nonlinear programming. The overall formulation has provided a useful method to identify damage with a small number of measured natural frequencies. Ten to 90% localized reduction in stiffness was successfully identified in a 10-story, two-bay steel frame. The method was verified using test data from an aluminum, cantilever beam.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Baruch, M.(1978). “Optmization procedure to correct stiffness and flexibility matrices using vibration tests.”AIAA J., 16(11), 1208–1210.
2.
Baruch, M. (1982). “Correction of stiffness matrix using vibration tests.”AIAA J., Vol. 20, 441–442.
3.
Beck, J. L., and Katafygiotis, L. S. (1992). “Probabilistic system identification and health monitoring of structures.”Proc., 10th ASCE World Conf. on Earthquake Engrg., Vol. 7, ASCE, New York, N.Y., 3721–3732.
4.
Cawley, P., and Adams, R. D.(1979). “The location of defects in structures from measurements of natural frequencies.”J. of Strain Anal., 14(2), 49–57.
5.
Chen, J. C., and Garba, J. A.(1980). “Analytical model improvement using modal test results.”AIAA J., 18(6), 684–690.
6.
Collins, J. D., Hart, G. C., Hasselman, T. K., and Kennedy, B.(1974). “Statistical identification of structures.”AIAA J., 12(2), 185–190.
7.
Crohas, H., and Lepert, P. (1982). “Damage detection and monitoring method for offshore platforms is field-tested.”Oil and Gas J., 94–103.
8.
Goldfarb, D., and Idnani, A. (1983). “A numerically stable dual method for solving strictly convex qaudratic programs.”Mathematical Programming, Vol. 27, 1–33.
9.
Gudmundson, P.(1982). “Eigenfrequency changes of structures due to cracks, notches, or other geometrical changes.”J. Mech. and Phys. of Solids, 30(5), 339–353.
10.
Hart, G. C., and Yao, J. T. P.(1977). “System identification in structural dynamics.”J. Engrg. Mech. Div., ASCE, 103(6), 1089–1104.
11.
Hassiotis, S., and Jeong, G. D.(1993). “Assessment of structural damage from natural frequency measurements.”Comp. and Struct., 49(4), 679–691.
12.
Hoff, C. J., Bernitsas, M. M., Sandstrom, R. E., and Anderson, W. J.(1984). “Inverse perturbation method for structural redesign with frequency and mode shape constraints.”AIAA J., 22(9), 1304–1309.
13.
Hoit, M. (1985). Structural analysis program SSTAN . Dept. of Civ. Engrg., Univ. of Florida, Gainsville, Fla.
14.
IMSL, FORTRAN subroutines for mathematical applications. (1987). Int. Math. and Statistical Libraries Inc., Houston, Tex.
15.
Kabe, A. M.(1985). “Stiffness matrix adjustment using mode data.”AIAA J., 23(9), 1431–1436.
16.
Kim, K. O., Anderson, W. J., and Sandstrom, R. E. (1983). “Nonlinear inverse perturbation method in dynamic analysis.”AIAA J., Vol. 21, 1310–1316.
17.
Kuo, C. P., and Wada, B. K.(1987). “Nonlinear sensitivity coefficients and corrections in system identification.”AIAA J., 25(11), 1463–1468.
18.
Lapierre, H., and Ostiguy, G.(1990). “Structural model verification with linear quadratic optimization theory.”AIAA J., 28(8), 1497–1503.
19.
Luenberger, D. G. (1984). Linear and nonlinear programming . Addison-Wesley Publishing Co., Reading, Mass.
20.
Manual of steel construction, load and resistance factor design (LRFD). (1986). American Institute of Steel Construction (AISC), Inc., Chicago, Ill.
21.
Mao, Q., and Shen, X. (1991). “Dynamic detection of damage in structures.”DE-Vol. 38, Modal analysis, modeling, diagnostics, and control-analytical and experimental, Am. Soc. of Mech. Engrs. (ASME), New York, N.Y., 165–168.
22.
Nataraja, R. (1983). “Structural integrity monitoring in real seas.”15th Annu. OTC, Paper No. 4538, Vol. 2, Offshore Technol. Conf. (OTC), Houston, Tex., 221–228.
23.
Ogawa, J., and Abe, Y. (1980). “Structural damage and stiffness degradation of buildings caused by severe earthquakes.”Proc., 7th World Conf. on Earthquake Engrg., Vol. 7, 527–534.
24.
Peng, C. Y. (1987). “Generalized modal identification of linear and nonlinear dynamic systems.”Rep. No. EERL 87-05, Calif. Inst. of Technol., Pasadena, Calif.
25.
Powell, M. J. D. (1983). “ZQPCVX a FORTRAN subroutine for convex quadratic programming.”DAMTP Rep. NA17, Cambridge, England.
26.
Sandstrom, R. E., and Anderson, W. J. (1982). Modal Perturbation Methods for Marine Studies. Trans., Soc. Naval Archit. and Marine Engrs., Vol. 90, 41–54.
27.
Stetson, K. A.(1975). “Perturbation method of structural design relevant to holographic vibration analysis.”AIAA J., 13(4), 457–459.
28.
Stetson, K. A., and Palma, G. E.(1976). “Inversion of first-order perturbation theory and its application to structural design.”AIAA J., 14(4), 454–460.
29.
Stubbs, N., Broome, T. H., and Osegueda, R.(1990). “Nondestructive construction error detection in large space structures.”AIAA J., 28(1), 146–152.
30.
Stubbs, N., and Mohammad, A. Q. (1988). “Nondestructive evaluation of geotechnical systems.”Tech. Rep. No. TR-88-100, Texas A & M Univ., College Station, Tex.
31.
Stubbs, N., and Osegueda, R. (1987). “Global nondestructive damage evaluation in solids.”Tech. Rep. No. TR-87-101, Texas A & M Univ., College Station, Tex.
32.
Taylor, J. E.(1977). “Scaling a discrete structural model to match measured modal frequencies.”AIAA J., 15(11), 1647–1649.
33.
Timoshenko, S., Young, D. H., and Weaver Jr., W. (1974). Vibration problems in engineering, 4th Ed., John Wiley & Sons, Inc., New York, N.Y.
34.
Toussi, S., and Yao, J. T. P. (1981). “Hysteresis identification of multi-story buildings.”Tech. Rep. No. CE-STR-81-5, Purdue Univ., West Lafayette, Ind.
35.
Yang, J. C. S., Tsai, T., Pavlin, V., Chen, J., and Tsai, W. H. (1985). “Structural damage detection by the system identification technique.”Shock and Vibration Bull., Vol. 55, 57–66.
Information & Authors
Information
Published In
Copyright
Copyright © 1995 American Society of Civil Engineers.
History
Published online: Oct 1, 1995
Published in print: Oct 1995
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.