Removal of Toluene Vapor with Dispersed Activated Carbon
Publication: Journal of Environmental Engineering
Volume 132, Issue 3
Abstract
This work considers the mechanisms of mass transfer in a process of dispersed sorbent injection. During experiments, an air supply was dosed with toluene vapor, at partial pressures between 4 and 15 Pa. Powdered activated carbon (PAC) was added to remove the toluene from the air, and the resulting mixture was passed through a 3-m-long, tubular, aluminum test section. Toluene concentrations were measured at seven axial locations within the test section. Comparing the measurements with mathematical models indicated the importance of adsorption kinetics. At reduced toluene inlet concentrations the PAC removed a slightly bigger fraction of toluene from the air stream. This fraction increased with PAC concentration. The effect on removal of varying the air temperature between 25 and 85°C was small. Alternative models incorporating either pore diffusion or surface diffusion were fitted to the results. The quality of the fits was fair only, but sufficient to show that the pore diffusivity that gave the best fit was far larger than would be expected from the Knudsen diffusivity in the pores. That is, surface diffusion was an important part of the intraparticle mass transfer.
Get full access to this article
View all available purchase options and get full access to this article.
References
Air and Waste Management Association. (1992). Air pollution engineering manual, Van Nostrand Reinhold, New York.
Al-Duri, B., and McKay, G. (1991). “Prediction of binary system for kinetics of batch adsorption using base dyes onto activated carbon.” Chem. Eng. Sci., 46, 193–204.
Anstice, P. J. C., and Alder, J. F. (1997). “Effect of sulphur dioxide on the adsorption properties of activated carbon towards chloropicrin.” Adsorpt. Sci. Technol., 15, 531–540.
Archer, E. D., Allen, R. W. K., and MacInnes, J. M. (2000). “Measurements of VOC take-up by adsorbing particles in a gas stream.” Filtr. Sep., 37(10), 33–39.
Chatzopoulos, D., and Varma, A. (1995). “Aqueous phase adsorption and desorption of toluene in activated carbon beds.” Chem. Eng. Sci., 50, 127–141.
Cheng, T., Jiang, Y., Zhang, Y., and Liu, S. (2002). “Prediction of breakthrough curves for adsorption on activated carbon fibres in a fixed bed.” Carbon, 42, 3081–3085.
Coulson, J., and Richardson, J. (1991). Chemical engineering, Vol. 2, Pergamon, Oxford, U.K.
Crittenden, J. C., Luft, P., Hand, D. W., Oravitz, J. L., Loper, S. W., and Ari, M. (1985). “Prediction of multicomponent adsorption equilibria using ideal adsorbed solution theory.” Environ. Sci. Technol., 19, 1037–1043.
Do, D. D., and Do, H. D. (2001). “Surface diffusion of hydrocarbons in activated carbon: Comparison between constant molar flow, differential permeation and differential adsorption bed methods.” Adsorption, 7, 189–209.
European Union. (1989). “Directive of the reduction of air pollution from municipal waste incinerators.” Rep. No. 89/369/EEC/OJL 163 14/6/89, Brussels, Belgium.
Finlayson, B. A. (1972). The method of weighted residuals and variational principles, Academic, New York.
Flora, J. V., Vidic, R. D., and Thurnaus, R. (1998). “Modeling powdered activated carbon injection for the uptake of elemental mercury vapours.” J. Air Waste Manage. Assoc., 48, 1051–1059.
Fujii, T., Murakawa, T., Maeda, N., Kondo, M., Nagai, K., Hama, T., and Ota, K. (1994). “Removal technology of PCDDs/PCFDs in flue gas from MSW incinerators by fabric bag filter and SCR system.” Chemosphere, 29, 2067–2070.
McKay, G. (2002). “Dioxin characterisation, formation and minimisation during municipal solid waste incineration: Review.” Chem. Eng. J. 86(3), 343–368.
Myers, A. L., and Prausnitz, J. M. (1965). “Thermodynamics of mixed gas adsorption.” AIChE J., 11, 121–130.
Norit Americas. (1994). “Activated carbons for removal of mercury and dioxins.” Rep. No. NA 74-3, Altanta, Ga.
Oser, H. R., Thanner, H. H., Grotheer, B. K., Gullett, N., Beran, D., French, D., and Natshce, D. (1997). “DLR Jet-REMPLI as a continuous emissions monitor: Measurements of chlorinated dibenzondioxins.” Proc., Int. Conf. on Incinerations and Thermal Treatment Technologies, UC-Irvine/AWMA, Oakland, Calif.
Prasertmanukitch, S., Tierney, M. J., Waszkiewicz, S. D., Saidani, H., and Riceh, I. (2004). “Measurement of the bulk adsorption properties of powders.” Sep. Purif. Technol., 40, 267–277.
Roy, S., Raju, R., Chang, H. F., Cruden, B. A., and Meyyappan, M. (2003). “Modeling gas flow through microchannels and nanopores.” J. Appl. Phys., 93(8), 4870–4879.
Ruthven, D. (1984). Principles of adsorption and adsorption processes, Wiley Intersciences, New York.
Sam-Cwan, K., Sung Hwan, J., II-Rok, J., Ki-Hun, K., Myung-Hee, K., Jae-Hyung, K., Jun-Heung, Y., Sueng-Jin, K., Jae-Cheon, Y., and Dong-Hee, J. (2001). “Removal efficiencies of PCDDs/PCDFs by air pollution control devices in municipal solid waste incinerators.” Chemosphere, 43, 773–776.
Schiller, L., and Naumann, A. (1933). “Uber die grundegenden Berchnungen bei der Schwerkraftaufbereitung.” Z. Ver. Deut. Ing., 77, 318–320.
Suzuki, M. (1990). Adsorption engineering, Kodashana, Tokyo.
Suzuki, M., and Kawazoe, K. (1975). “Effective surface diffusion coefficients of volatile organics on activated carbon during adsorption from aqueous solution.” J. Chem. Eng. Jpn. 8, 381.
Tien, C. (1995). Adsorption calculations and modelling, Butterworth-Heinemann, New York.
Tierney, M. J., and Quarini, G. L. (1997). “Mass transfer by simultaneous dropwise condensation and particle deposition.” Int. J. Heat Mass Transfer, 40, 727–735.
U.K. Environmental Agency. (1996). “Processes subject to integrated pollution control.” IPC guidance notes, series 2, S25.01: Waste incineration, Waste Disposal and Recycling Sector, The Stationery Office, London.
Urano, K., Omori, S., and Yamamotos, E. (1982). “Prediction method for adsorption capacities of commercial activated carbons in removal of organic vapours.” Environ. Sci. Technol., 16, 10–20.
Yang, R. T. (1987). Gas separation by adsorption processes, Butterworth, Boston.
Information & Authors
Information
Published In
Copyright
© 2005 ASCE.
History
Received: Jun 15, 2004
Accepted: Jun 3, 2005
Published online: Mar 1, 2006
Published in print: Mar 2006
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.