Mountain Streams—Modeling Hydraulics and Substance Transport
Publication: Journal of Environmental Engineering
Volume 131, Issue 2
Abstract
One-dimensional models are useful tools for predicting hydraulics, substance transport, temperature, and water quality in rivers for flow distances that are long compared to the lateral mixing distance. However, the application of such models to mountain streams is difficult because, in addition to small scale bed roughness, the effects of large-scale roughness, irregularity in bed geometry, and pool and riffle sequences have to be taken into account at a spatially averaged scale. Representation of pools, stagnant zones due to bed irregularity, and interstitial zones in the gravel bed with a dead zone model leads to a description of substance transport that is strongly simplified but correct in the representation of basic mechanisms. However, this approach leads to more severe problems regarding parameter identifiability compared to inclusion of these effects in an enlarged friction coefficient. To overcome these problems, we applied a friction estimator developed for river sections without pools and were then able to identify the dead zone volume and exchange parameters. In a case study in the southern Swiss Alps, the dead zone volume fraction and the residence time in the dead zone did not strongly depend on stream discharge, but these parameters varied strongly from one stream section to another. This indicates that the evaluation of a tracer test for one single flow condition significantly decreases prediction uncertainty of substance transport for a specific stream reach.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The writers thank Mike Schurter, Cyrill Bonjour, Tom Ravens, and Barbara Fasnacht for their help during measurements, Urs Uehlinger for providing data underlying the paper of Robinson et al. 2005, and Matt Hare for carefully checking the manuscript. The power plant authorities of OFIBLE and the Swiss Federal Office for Water and Geology provided essential discharge data for the investigation.
References
Aguirre-Pe, J., and Fuentes, R. (1990). “Resistance to flow in steep rough streams.” J. Hydraul. Eng., 116(11), 1374–1387.
Bathurst, J. C. (1978). “Flow resistance of large-scale roughness.” J. Hydraul. Div., Am. Soc. Civ. Eng., 104(12), 1587–1603.
Bathurst, J. C. (1985). “Flow resistance estimation in mountain rivers.” J. Hydraul. Eng., 111(4), 625–643.
Bencala, K. E., and Walters, R. A. (1983). “Simulation of solute transport in a mountain pool-and-riffle stream: A transient storage model.” Water Resour. Res., 19(3), 718–724.
Bonjour, C. (1998). “Modellierung des Waermeaustausches über die Wasseroberflaeche eines Gebirgsbachs.” diploma thesis, EAWAG Duebendorf (in German).
Brun, R., Reichert, P., and Künsch, H. R. (2001). “Practical identifiability analysis of large environmental simulation models.” Water Resour. Res., 37(4), 1015–1030.
Fesch, C., Simon, W., Haderlein, St. B., Reichert, P., and Schwarzenbach, R. P. (1998). “Nonlinear sorption and nonequilibrium solute transport in aggregated porous media: Experiments, process identification and modeling.” J. Contam. Hydrol., 31(3–4), 373–407.
Fischer, H. B. (1967). “The mechanics of dispersion in natural streams.” J. Hydraul. Div., Am. Soc. Civ. Eng., 93(6), 187–216.
Fischer, H. B. (1973). “Longitudinal dispersion and turbulent mixing in open-channel flow.” Annu. Rev. Fluid Mech., 5, 59–78.
Fischer, H. B., List E. J., Koh, R. C. Y., Imberger, J., and Brooks, N. H. (1979). Mixing in inland and coastal waters, Academic, New York.
Hart, D. R., Mulholland, P. J., Marzolf, E. R., DeAngelis, D. L., and Hendricks, S. P. (1999). “Relationship between hydraulic parameters in a small stream under varying flow and seasonal conditions.” Hydrolog. Process., 13, 1497–1510.
Holmberg, A. (1982). “On the practical identifiability of microbial growth models incorporating Michaelis-Menten type nonlinearities.” Math. Biosci., 62, 23–43.
Jarrett, R. D. (1984). “Hydraulics of high-gradient streams.” J. Hydraul. Eng., 110(11), 1519–1539.
Kilpatrick, F. A., and Cobb, E. D. (1984). “Measurement of discharge using tracers.” USGS techniques of water-resources investigations book 3.
Marcus, W. A., Roberts, K., Harvey, L., and Tackman, G. (1992). “An evaluation of methods for estimating Manning’s n in small mountain streams.” Mountain Res. Devel., 12(3), 227–239.
Meier, W. K., Bonjour, C., Wuest, A., and Reichert, P. (2003). “Modelling the effect of water diversion on the temperature of mountain streams.” J. Environ. Eng., 129(8), 755–764.
Nordin, C. F., and Troutman, B. M. (1980). “Longitudinal dispersion in rivers: The persistence of skewness in observed data.” Water Resour. Res., 16, 123–128.
Reichert, P. (1994). “AQUASIM—A tool for simulation and data analysis of aquatic systems.” Water Sci. Technol., 30, 21–30.
Reichert, P., and Wanner, O. (1991). “Enhanced one-dimensional modeling of transport in rivers.” J. Hydraul. Eng., 117(9), 1165–1183.
Robinson, C. T., Uelinger, U., and Minshall, G. W. (2005). “Functional characteristics of wilderness streams 20 years following a wildfire.” West. North Am. Naturalist, 65(1) (in press).
Sabol, G. V., and Nordin, C. F. (1978). “Dispersion in rivers as related to storage zones.” J. Hydraul. Div., Am. Soc. Civ. Eng., 104(5), 695–708.
Taylor, G. I. (1954). “The dispersion of matter in turbulent flow through a pipe.” Proc. R. Soc. London, Ser. A, 223, 446–468.
Thackston, E. L., and Schnelle, K. B. (1970). “Predicting effects of dead zones on stream mixing.” J. Sanit. Eng. Div., Am. Soc. Civ. Eng., 96(2), 319–331.
Thompson, S. M., and Campbell, P. L. (1979). “Hydraulics of a large channel paved with boulders.” J. Hydraul. Res., 17(4), 341–354.
Thorne, C. R., and Zevenbergen, L. W. (1985). “Estimating mean velocity in mountain rivers.” J. Hydraul. Eng., 111(4), 612–624.
Wagner, B. J., and Harvey, J. W. (1997). “Experimental design for estimating parameters of rate-limited mass transfer: Analysis of stream tracer studies.” Water Resour. Res., 33(7), 1731–1741.
Wolman, M. G. (1954). “A method of sampling coarse river-bed material.” Trans., Am. Geophys. Union, 35(6), 951–956.
Yen, B. (1973). “Open-channel flow equations revisited.” J. Eng. Mech. Div., 99(5), 979–1009.
Information & Authors
Information
Published In
Journal of Environmental Engineering
Volume 131 • Issue 2 • February 2005
Pages: 252 - 261
Copyright
© 2003 ASCE.
History
Received: Jul 31, 2003
Accepted: Nov 25, 2003
Published online: Feb 1, 2005
Published in print: Feb 2005
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.