Practical Modeling of SVE Performance at a Jet-Fuel Spill Site
Publication: Journal of Environmental Engineering
Volume 127, Issue 7
Abstract
A coupled flow and transport model (VENT3D) was used to simulate the performance of soil vapor extraction at a jet-fuel (JP-4) contaminated site. The contaminant mixture was approximated with 10 surrogate components categorized by carbon number class. The contaminant was distributed heterogeneously throughout the soil. The initial total contaminant mass was the only parameter that was adjusted, and it was fit to the observed removal during the pilot tests. The predicted total mass removal using the most general approach matched the observed hydrocarbon mass removal within ±4%. The effects of the following selected simplifying assumptions were examined with the model: (1) uniform contaminant distribution; (2) 2D horizontal flow; and (3) single equivalent contaminant. The uniform soil contamination distribution and the horizontal flow assumptions yielded similar results—both estimated removal rates that were initially higher by 30% and eventually overpredicted the total removal by 10%. The equivalent single-component approximation underpredicted the removal by as much as 50% during the first half of the operation and then overpredicted the removal, ultimately overpredicting the total removal by <10%.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Anderson, M. P., and Woessner, W. W. ( 1992). Applied groundwater modeling: Simulation of flow and advective transport, Academic, San Diego.
2.
Benson, D. A., Huntley, D., and Johnson, P. C. ( 1993). “Modeling vapor extraction and general transport in the presence of NAPL mixtures and nonideal conditions.” Ground Water, 31(3), 437–445.
3.
El-Beshry, M. Z. ( 1999). “Evaluating the predictive capabilities of a three-dimensional simulator (VENT3D) against the performance of a field-scale soil vapor extraction operation.” PhD dissertation, Dept. of Envir. Sci. and Engrg., Rice University, Houston.
4.
DePaoli, D. W. et al. ( 1991). Field demonstration of in situ soil venting at Hill Air Force Base JP-4 jet fuel spill site, Oak Ridge National Laboratory, Oak Ridge, Tenn.
5.
Domenico, P. A., and Schwartz, F. W. ( 1990). Physical and chemical hydrogeology, Wiley, New York.
6.
Falta, R. W. ( 1996). “A program for analyzing transient and steady-state soil gas pump tests.” Ground Water, 34(4), 750–755.
7.
Jordan, D. L., Mercer, J. W., and Cohen, R. M. ( 1995). “Review of mathematical modeling for evaluating soil vapor extraction systems.” EPA/540/R-95/513, National Risk Management Research Laboratory, Office of Research and Development, U.S. Environmental Protection Agency, Cincinnati.
8.
Lyman, W. J., Reehl, W. F., and Rosenblatt, D. H. ( 1982). Handbook of chemical property estimation methods, McGraw-Hill, New York.
9.
Massmann, J. W. (1989). “Applying ground-water flow models in vapor extraction system design.”J. Envir. Engrg., ASCE, 115(1), 129– 149.
10.
McCray, J. E., and Falta, R. W. ( 1997). “Numerical simulation of air sparging for remediation of NAPL contamination.” Ground Water, 35(1), 99–110.
11.
Rathfelder, K., Lang, J. R., and Abriola, L. M. ( 1995). “Soil vapor extraction and bioventing: Applications, limitations and future research directions.” Rev. of Geophysics, S1067–S1081.
12.
Reid, R. C., Prausnitz, J. M., and Poling, B. E. ( 1987). The properties of gases and liquids, McGraw-Hill, New York.
13.
Schwarzenbach, R. P., Gschwend, P. M., and Imboden, D. M. ( 1993). Environmental organic chemistry, Wiley, New York.
14.
Smith, J. H., Harper, J. C., and Haber, H. ( 1981). “Analysis and environmental fate of Air Force distillate and high density fuels.” Rep. ESL-TR-81-54, Air Force Engrg. and Services Ctr., Tyndall Air Force Base, Fla.
15.
User's manual to VENT3D: A three-dimensional multi-compound, multi-phase partitioning vapor transport model. (1994). Desert Research Institute, University of Nevada, Reno, Nev. 〈http://www.hydro.unr.edu/homepages/benson〉.
Information & Authors
Information
Published In
Journal of Environmental Engineering
Volume 127 • Issue 7 • July 2001
Pages: 630 - 638
History
Received: Jun 14, 1998
Published online: Jul 1, 2001
Published in print: Jul 2001
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.