Dynamic Model for Soluble Mn2+ Removal by Oxide-Coated Filter Media
Publication: Journal of Environmental Engineering
Volume 123, Issue 7
Abstract
A process model for soluble Mn2+ removal by oxide-coated media filtration was developed, incorporating a modified Gnielinski mass transfer correlation for boundary layer transport, hydrodynamic dispersion, the Freundlich isotherm, and a modified Keinath correlation for intracoating surface diffusion. The available fraction of equilibrium sorption capacity was the calibration parameter used for the sorptive process mode. For the process mode of continuous regeneration by free chlorine, the sorbed Mn2+ oxidation rate constant was an additional calibration parameter, and the two parameters were uncorrelated. The calibrated model was predictive for laboratory column effluent profiles under dynamic influent boundary conditions of sorption followed by desorption over ranges of pH, flow rate, ionic strength, and (Ca2+). The model also satisfactorily accounted for oxidative Mn2+ removal over a range of process conditions for both synthetic and “naturally” coated media. Model structure was suggested by results of fundamental physical and chemical characterization of filter media from water treatment plants.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
American Water Works Association (AWWA). (1992). Standard methods for the examination of water and waste water, 18th Ed., Denver, Colo.
2.
American Water Works Association (AWWA). (1994). AWWA mainstream, Denver, Colo.
3.
Cleasby, J. L.(1975). “Iron and manganese removal—a case study.”J. AWWA, 67(3), 147.
4.
Coffey, B. M., Gallagher, D. L., and Knocke, W. R.(1993). “Modeling soluble manganese removal by oxide-coated filter media.”J. Envir. Engrg. Div., ASCE, 119(4), 679.
5.
Crittenden, J. C., and Weber, W. J. Jr.(1978). “Predictive model for design of fixed-bed absorbers: parameter estimation and model development.”J. Envir. Engrg. Div., ASCE, 104(2), 185.
6.
Davis, M. E. (1984). Numerical methods and modeling for chemical engineers. John Wiley & Sons, Inc., New York, N.Y.
7.
Edwards, S. E., and McCall, G. B.(1946). “Manganese removal by breakpoint chlorination.”Water & Sewage Works, 93, 303.
8.
Griffin, A. E.(1960). “Significance and removal of manganese in water supplies.”J. AWWA, 52, 1326.
9.
Hong, S., and Summers, R. S. (1994). “Impact of backwashing and desorption on GAC breakthrough of natural organic matter.”Proc., Annu. Conf. of the Am. Water Works Assn., Am. Water Works Assn., Denver, Colo.
10.
Horvath, A. L. (1985). Handbook of aqueous electrolyte solutions. Ellis Horwood Ltd., Chichester, England.
11.
Judge, G. G., Griffiths, W. E., Hill, R. C., and Lee, T. S. (1980). The theory and practice of econometrics. John Wiley & Sons, Inc., New York, N.Y.
12.
Keinath, T. M. (1972). “Modeling and simulation of the performances of adsorption contactors.”Mathematical modeling in environmental engineering, Proc., 8th Annu. Workshop, AEEP.
13.
Knocke, W. R., Occiano, S., and Hungate, R. (1990). Removal of soluble manganese from water by oxide-coated filter media. Am. Water Works Assn. Res. Found., Denver, Colo.
14.
Knocke, W. R., Hamon, J., and Thompson, C.(1988). “Soluble manganese removal on oxide-coated filter media.”J. AWWA, 80(12), 65.
15.
McGhee, T. J. (1991). Water supply and sewerage. McGraw-Hill Inc., New York, N.Y.
16.
Merkle, P. B. (1995). “Characterization and modeling of soluble manganese removal from drinking water by oxide-coated filter media,” PhD dissertation, Virginia Polytechnic Inst. and State Univ.
17.
Merkle, P. B., Knocke, W. R., Gallagher, D. L., Junta-Rosso, J., and Solberg, T. N.(1996). “Characterizing filter media mineral coatings.”J. AWWA, 88(12), 62.
18.
Merkle, P. B. (1991). “A weather-driven model for atmospheric deposition of semivolatile organic contaminants to near-shore environments,” MS thesis, Marine Sci. Res. Ctr., State Univ. of New York at Stony Brook, Stony Brook, N.Y.
19.
Nakanishi, H.(1967). “Kinetics of continuous removal of manganese in a MnO2-coated sand bed.”Kogyo Kagaku Zasshi, 70(4), 407.
20.
Press, W. H., Teukolsky, S. A., Vetterling, W. T., and Flannery, B. P. (1992). Numerical recipes in FORTRAN: the art of scientific computing. Cambridge University Press, New York, N.Y.
21.
Pugh-Roberts Associates, Inc. (1986). Professional DYNAMO Plus, Cambridge, Mass.
22.
Roberts, P. V., Cornel, P., and Summers, R. S.(1985). “External mass-transfer rate in fixed-bed adsorption.”J. Envir. Engrg. Div., ASCE, 11(6), 891.
23.
Smith, J. M. (1981). Chemical engineering kinetics, 3rd Ed., McGraw-Hill Inc., New York, N.Y.
24.
Suzuki, M. (1990). Adsorption engineering, Chapter 7: Chemical engineering monographs. Kodansha Ltd., Tokyo, and Elsevier Science Publishers BV (North-Holland), Amsterdam, The Netherlands.
25.
Troutman, B. M.(1985). “Errors and parameter estimation in precipitation-runoff modeling: 1. theory.”Water Resour. Res., 21(8), 1195.
26.
Zapffe, C.(1933). “The history of manganese in water supplies and methods for its removal.”J. AWWA, 25(5), 655.
Information & Authors
Information
Published In
Copyright
Copyright © 1997 American Society of Civil Engineers.
History
Published online: Jul 1, 1997
Published in print: Jul 1997
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.